Experience with outlet strut fracture of the Björk-Shiley convexoconcave mitral valve prosthesis

Variation in Artificial Heart Acceleration and Sound Production with Prosthetic Valve Selection in vitro

In an attempt to explore methods to reduce total artificial heart (TAH) acceleration and sound production, in vitro measurements of TAH acceleration and sound were made when using a variety of prosthetic valves in a test ventricle. A miniature, uniaxial, high fidelity accelerometer was glued to the housing of a UTAH-100 left ventricle adjacent to the inflow and outflow ports and parallel to the axis of diaphragm excursion. A miniature, high fidelity contact microphone was glued to the opposite side of the ventricular housing between the inflow and outflow ports. Data was collected over a range of heart rates, ventricular filling volumes and control modes while using tilting disc valves (TDV) and polymer trileaflet valves (PTV). For both valve types, the peak systolic acceleration impulse was lower (≈ 50%) when the ventricle was fully rather than partially filled and the peak diastolic acceleration impulse was lower (≈ 50%) when the ventricle was fully rather than partially ejected. The magnitude of the acceleration with PTVs was ≈ 20x less than the TDVs (0.5 to 2.2 g vs. 10 to 49g). The magnitude of the sound production was also considerably less with the PTVs (28 to 49 db vs. 50 to 64 db). Diastolic acceleration and sound production was approximately twice the systolic value for the TDVs; the reserse was true for PTV sound production. These data demonstrate the substantial reduction in TAH impulse acceleration and sound production by selecting PTVs over TDSs. With PTVs, the TAH impulse acceleration is the same as the natural heart. Consequently, this ability to lower TAH acceleration and sound production to the level of the natural heart may lead to a reduction in component wear, patient discomfort and other undesirable consequences of TAH implantation.

Digital acoustical analysis of normal and bimodal Björk-Shiley 60 degrees convexo-concave heart valves

Fracture of the outlet strut of the Björk-Shiley 60 degrees convexo-concave (BS60CC) valve has been attributed to a bimodal closing pattern in certain valves in which the closing disk rotates about the inlet strut, causing upward displacement of the outlet strut and its eventual fracture. This article reports the in vivo studies of the normal BS60CC valve and the in vitro studies of the normal and bimodal BS60CC valves, using a digital acoustical signal processing technique, in which the individual collisions (impact history) of the occluder disk with the components of the valve body are revealed during each closing cycle. In vitro analysis of the closing acoustical signals of normal BS60CC valves showed impact history cluster width (IHCW) means of 2.07 +/- 0.85 ms (standard error), not significantly different from those of 1.86 +/- 0.58 ms (standard error) observed in 38 clinically normal patients with BS60CC valves (p greater than 0.1). The bimodal valves showed IHCW of 6.14 +/- 0.98 ms (standard error), in vitro, which was significantly greater than those observed in the normal in vitro valve group and in the normal patient population (p less than 0.0001).

Björk-Shiley strut fracture and disc escape: literature review and a method of disc retrieval

Embolization of a prosthetic valve poppet is a rare but life-threatening event. It was reported sporadically before the introduction of the Björk-Shiley 70-degree convexoconcave prosthesis in 1980. Since that time, there have been a large number of reported mechanical failures with disc escape. The rate for the 29-mm to 33-mm mitral valves is estimated as 5.2%. In 29 of 35 patients (including the 2 presented here) in whom the site of disc lodgment could be determined, the disc was in the descending or abdominal aorta. Fifteen of these patients died. Six survivors had the disc removed at the same operation and 6 at a later operation. In 2 patients, the disc was not removed. In 2 patients in whom the disc was not removed initially, it was thought to contribute to postoperative complications. Two more cases of structural failure of the Björk-Shiley convexoconcave prosthesis are presented. A transpericardial approach to the descending aorta on bypass is described. It allows easy removal of the disc and eliminates the need for a second operation.

Radiologic search for embolized leaflets of prosthetic heart valves: a report of two cases

In a radiologic search for embolized leaflets of Edwards-Duromedics bileaflet valves in 2 patients, the embolized fragments were localized in the iliac vessels using computed tomography. Sonography was successful in one case and standard X-ray films of the abdomen were negative in both cases. In vitro investigations with Björk-Shiley and Edwards-Duromedics leaflets suggested that standard X-ray films of the abdomen and pelvis should be considered as the first investigational technique. If negative, computed tomography of the lower abdomen should be done.

Outlet strut fracture of the Björk-Shiley 60 degrees Convexo-Concave valve: current information and recommendations for patient care

Mechanical failure of artificial heart valves can be a catastrophic event. The problem of outlet strut fracture of the Björk-Shiley 60 degrees Convexo-Concave tilting disc prosthesis has received much attention in the medical literature and generated both concern and confusion among patients and physicians. Analysis of current data from the manufacturer, as well as a review of the medical literature, suggests that the overall risk of outlet strut fracture is low and that elective explantation of a well functioning Björk-Shiley 60 degrees Convexo-Concave valve prosthesis is not warranted. Diagnostic features of outlet strut fracture can be seen with overpenetrated chest X-ray films so that diagnosis can be established promptly. Early operation to replace the fractured prosthesis is essential for patient survival.

Cardiac valve prostheses: pathological and bioengineering considerations

Cardiac valve replacement with mechanical prosthetic or bioprosthetic devices enhances patient survival and quality of life. Nevertheless, prosthesis-associated complications are frequent and contribute significantly to outcome. Thromboembolic complications are the most important problems in patients with mechanical valves, necessitating chronic anticoagulation in all patients receiving them. In contrast, patients with bioprosthetic valves, composed of chemically treated animal tissues, generally do not require anticoagulants. However, bioprostheses fail frequently by degeneration, especially that involving cuspal calcification. This paper reviews the pathological and bioengineering considerations in the selection of cardiac prosthetic valves and the management of patients who have received these devices. The significance, morphology, and pathogenesis of the observed major complications and other alterations during function are described in detail. Contemporary investigative trends are summarized, including studies of inhibition of mineralization and other degenerative changes in bioprostheses, improved design rigid mechanical valves with pyrolytic carbon occluders and the development of central-flow, flexible polymeric leaflet valves.