Baromechanical transduction in a model protein by the ΔTt mechanism

Mechanism for the Phase Transition of a Genetically Engineered Elastin Model Peptide (VPGIG)40in Aqueous Solution

The concentration dependence of the pressure- and temperature-induced cloud point transition (Pc and Tc, respectively) of aqueous solutions of an elastin-like polypeptide with a repeating pentapeptide Val-Pro-Gly-Ile-Gly sequence (MGLDGSMG(VPGIG)40VPLE) was investigated by using apparent light scattering, differential scanning calorimetry, and circular dichroism methods. In addition, the effects of salts and surfactants on these properties were investigated. The Pc and Tc of the present peptide in aqueous solution were strongly concentration dependent. The calorimetric measurements showed that the enthalpy of transitions was 300-400 kJ/mol, i.e., 7-10 kJ/mol per VPGIG pentamer. The Tc of the (VPGIG)40 solution was highly affected by the addition of inert salts or SDS. The effects of salts were consistent with those observed in the lyotropic series or Hoffmeister series. The CD spectrum at low peptide concentrations indicated that the present peptide forms type II beta-turn-like structure(s) at higher temperatures, but the temperature dependence of random coil diminishment (195 nm) and beta-turn formation (210 nm) were not exactly coincident. A hypothetical mechanism of the (VPGIG)40 phase transition that could account for these observations was postulated. Observations suggest that the temperature-responsive properties of the elastin model peptides occur via a mechanism involving conformational change-association-aggregation and that the first two are strongly interactive.

Effects of temperature and pressure on the aggregation properties of an engineered elastin model polypeptide in aqueous solution

The pressure and temperature dependence of the cloud point transition of an aqueous solution of an elastin-like polypeptide (MGLDGSMG(VPGIG)40VPLE), prepared by bacterial expression of the corresponding artificial gene, was measured. A temperature-pressure diagram was constructed over a wide range of conditions. The (VPGIG)40 solution exhibited a well-defined pressure-induced cloudpoint (Pc), as well as a temperature-induced transition (Tc). From near atmospheric pressure up to 100 MPa, Tc increased with increasing pressure, but decreased with further increases in pressure above 200 MPa. The maximum Tc was reached at 100-200 MPa. Between 10 and 25 degrees C, the Pc decreased with increasing temperature, and a broad maximum in Pc was observed in the range -10 to 0 degree C. These results are compared with our previous results on synthetic thermoresponsive vinyl polymers.