Analysis of sulphonated polyphenols, synthetic tanning agents in heavily polluted tannery wastewaters

Three-way spectrofluorimetric-assisted multivariate determination of nonylphenol ethoxylate and 2-naphtalene sulfonate in wastewater samples and optimization approach for their photocatalytic degradation by CoTiO3 nanostructure

This study presents a new strategy for the simultaneous quantification of two industrial contaminants. The excitation-emission fluorescence data matrix combined with a three-way chemometric method, such as parallel factor analysis, was used for the determination of nonylphenol ethoxylate (NPE-9) as a nonionic surfactant and 2-naphthalene sulfonate (2-NS) in waste water samples. It is noticeable that this method can resolve overlapping signal into spectral and relative concentration profiles. By spiking the known concentrations of these compounds in the wastewater samples, the accuracy of the proposed methods was validated and recoveries of the spiked values were calculated. High recoveries (i.e. 90-110%) obtained for the waste water samples indicate the present method can be used successfully to determine the analytes concentration in the environmental contaminations. The photocatalytic degradation of NPE-9 and 2-NS in aqueous solution was studied using the CoTiO₃ nanoparticles catalyst. It was synthesized by the sol-gel technique. The catalytic activity of the prepared nanoparticles was measured in a batch photoreactor containing appropriate solutions of these compounds with UV irradiation. The photodegradation process of these compounds was optimized by using the central composite design. The CoTiO₃ showed high activity for UV-photocatalytic degradation of NPE-9 and 2-NS.

Development and optimization of a method for the analysis of Brazilein by HPLC with electrochemical detection

The aim of this study was to establish an easy and accurate method for the determination of Brazilein in plant samples due to its potential pharmacological activities. High-performance liquid chromatography (HPLC) with electrochemical detection (ED) was used for the assay of Brazilein in this study for the first time. Crucial influence parameters including concentration of dodecane-1-sulfonic acid sodium salt (DSASS), inorganic modifier, tetrabutyl-ammonium hydroxide solution (TBAOH), and applied potential of proposed method were investigated. The proposed method is simple, rapid (analysis time: approximately 10 min), sensitive [(detection limit: 0.6 ng per injection (20 microl) at a signal-noise ratio 3:1)], highly selective and precise (intra- and inter-day precisions were within 5%, n = 7). The calibration graph of Brazilein was linear in the range 0.6-150 ng per injection 20 microl. Recovery of Brazilein was over 92% by standard addition method.

Removal of sulfur-organic polar micropollutants in a membrane bioreactor treating industrial wastewater

While membrane bioreactors (MBR) have proven their large potential to remove bulk organic matter from municipal as well as industrial wastewater, their suitability to remove poorly degradable polar wastewater contaminants is yet unknown. However, this is an important aspect for the achievable effluent quality and in terms of wastewater reuse. We have analyzed two classes of polar sulfur-organic compounds, naphthalene sulfonates and benzothiazoles, by liquid chromatography-electrospray ionization-tandem mass spectrometry (LC-ESI-MS) over a period of 3 weeks in the influent and effluent of a full-scale MBR with external ultrafiltration that treats tannery wastewater. While naphthalene monosulfonates were completely removed, total naphthalene disulfonate removal was limited to about 40%, and total benzothiazoles concentration decreased for 87%. Quantitative as well as qualitative data did not indicate an adaptation to or a more complete removal of these polar aromatic compounds by the MBR as compared to literature data on conventional activated sludge treatment. While quality improvements in receiving waters for bulk organic matter are documented and the same can be anticipated for apolar particle-associated contaminants, these data provide no indication that MBR will improve the removal of polar poorly biodegradable organic pollutants.

Method development for trace determination of poly(naphthalenesulfonate)-type pollutants in water by liquid chromatography-electrospray mass spectrometry

A very sensitive analytical procedure based on LC-MS for determining trace amounts of the more relevant poly(naphthalenesulfonate) (PNS) contaminants present in environmental waters is presented. Extraction was performed on a styrene-divinylbenzene copolymer resin solid-phase extraction cartridge after addition of ammonium acetate to the sample. Small amounts of ammonium acetate in the mobile phase allowed the determination and characterisation of the four shorter oligomers by liquid chromatography-electrospray mass spectrometry. Under such conditions the electrospray process generates fully ionised molecules which greatly simplifies interpretation of spectra and quantitation. Additionally, confirmatory ions can be generated by the in-source collision-induced decomposition process. The effectiveness of the method was assessed in recovery experiments from drinking and river water samples spiked with commercial mixtures of PNS concrete plasticizers also referred as naphthalenesulfonate-formaldehyde condensates. Moreover, the performance of this method was compared to methods using ion-pair chromatography coupled with fluorimetric and mass spectrometric detection. Method detection limits were in the low picomolar range (1 ng/l for the monomer) for each isomer. In order to evaluate the environmental relevance of PNS type compounds waste, river and ground water grab samples were analysed. Concentrations of PNS oligomers detected in these samples ranged between 53 ng/l and 32 microg/l.