Interfacial micellization of cetyl-dimethyl-benzylammonium chloride and Tween-80R at the Hg/electrolyte solution interphase

Condensed film formation of binary mixtures of cetyltrimethylammonium bromide and cetyldimethylbenzylammonium chloride in a wide potential region at the mercury/electrolyte interface

The adsorption of binary mixtures of cetyltrimethylammonium bromide (CTAB) and cetyldimethylbenzylammonium chloride (CDBACl) at the mercury/electrolyte interface was studied in various electrolyte systems. The optimum surfactant concentration and electrolyte ratio was searched for, to obtain the formation of a condensed film at as wide a potential range as possible at the highest temperature possible. The optimum conditions found were 2 x 10(-4) M CTAB and 2 x 10(-4) M CDBACl in 0.07 M KF and 0.03 M KBr at 2 degrees C. The capacitances vs time curves were used for the reconstruction of isochronous capacitance vs potential curves. These curves showed that in that system the condensed film was formed in the potential range from -0.4 to -1.9 V vs Ag/AgCl in less than 220 s. The stability of this film, following the removal of the mercury drop from the solution, was also studied.

Effect of the deaeration on the adsorption of some cationic surfactants at the mercury/electrolyte solution interface

The effect of the deaeration on the adsorption of three cationic surfactants cetyldimethylbenzylammonium chloride (CDBACl), cetyltrimethylammonium bromide (CTAB) and octadecyltrimethylammonium bromide (OTAB) at the mercury/electrolyte solution interface is studied. The deaeration is studied using either nitrogen or helium and the effect of deaeration process and time is also studied. In all cases an effect of the deaeration time is found which is mainly observed at potentials where a condensed film is formed. Capacity-time curves at the potentials where the film is formed show a nucleation and growth mechanism with induction time that depends on the deaeration time. The deaeration slows down the kinetics of the film formation but does not change the equilibrium capacitance value of the film. The decrease of the dissolved gas from the water that perturbs its structure is perhaps the main reason for the behaviour observed during the adsorption of these surfactants.

On the adsorption of cetyldimethylbenzylammonium chloride at the mercury/electrolyte solution interface

The adsorption of cetyldimethylbenzylammonium chloride (CDBACl) on the hanging mercury electrode is studied in various supporting electrolytes at various temperatures from 1 to 50 degrees C. A condensed film with low capacitance is formed at negative potentials at transition temperatures below approximately 40 degrees C. The decrease of the temperature favors the film formation, and increases the width of the capacitance pit, while its value remains practically constant. Hysteresis phenomena are also observed during different scan directions. Capacitance-time curves at the potentials where the film is formed show in some cases a nucleation and growth mechanism with induction time and studied by the Avrami formulation. At high temperatures an increase of the capacitance with time is observed depending on the CDBACl concentration and slightly on the electrolyte used, and is attributed to the formation of hemimicelles. At high negative potentials a second narrow region with lower capacitance values is observed. This is easily observed at very high temperatures, while it is absent at lower temperatures. It depends upon the concentration of CDBACl and the electrolyte used. The results are different from those obtained for the adsorption of cetyltrimethylammonium bromide on mercury, indicating the importance of interaction between the hydrophobic chains.