The transition between ductile and slow-crack-growth failure in polyethylene

Guided Wave Ultrasonic Testing for Crack Detection in Polyethylene Pipes: Laboratory Experiments and Numerical Modeling

The use of guided wave-based Ultrasonic Testing (UT) for monitoring Polyethylene (PE) pipes is mostly restricted to detecting defects in welded zones, despite its diversified success in monitoring metallic pipes. PE's viscoelastic behavior and semi-crystalline structure make it prone to crack formation under extreme loads and environmental factors, which is a leading cause of pipeline failure. This state-of-the-art study aims to demonstrate the potential of UT for detecting cracks in non-welded regions of natural gas PE pipes. Laboratory experiments were conducted using a UT system consisting of low-cost piezoceramic transducers assembled in a pitch-catch configuration. The amplitude of the transmitted wave was analyzed to study wave interaction with cracks of different geometries. The frequency of the inspecting signal was optimized through wave dispersion and attenuation analysis, guiding the selection of third- and fourth- order longitudinal modes for the study. The findings revealed that cracks with lengths equal to or greater than the wavelength of the interacting mode were more easily detectable, while smaller crack lengths required greater crack depths for detection. However, there were potential limitations in the proposed technique related to crack orientation. These insights were validated using a finite element-based numerical model, confirming the potential of UT for detecting cracks in PE pipes.

Polymerization kinetics, glass transition temperature and creep of acrylic bone cements

Sulfix-6 and Zimmer LVC 60/30 bone cements were selected and the polymerization kinetics and resulting glass transition temperature Tg; creep behaviour in the dry or water-saturated state; and sorption and diffusion of water were studied. The calculation of conversion was based on a comparison of the residual polymerization heat measured by differential scanning calorimetry and the corresponding theoretical value. The conversion reached 99% after 90 min of quasi-adiabatic polymerization starting at 23 degrees C or after 10 min of isothermal polymerization at 37 degrees C. The Tgs of the cements prepared in the former way were about 82 and 100 degrees C, respectively. Creep rate of the bone cements at 37 degrees C decreased with the time of creeping. Sorbed water enhanced the compliance, but reduced the creep rate for long times so that water sorption during the service time may not have detrimental effects on the creep resistance of the cements. Both types of cements contained about 1% of low molar mass substances extractable by water. Measurements of the sorption kinetics of water showed that the diffusion coefficient is 0.14 x 10(-11) and 0.22 x 10(-11) m2/s and 1 yr sorption achieves 2.11% and 2.89% for Sulfix and Zimmer, respectively.