Simple, sensitive and selective high-performance liquid chromatographic method for analysis of chlorthalidone in whole blood

The simultaneous UPLC-MS/MS determination of emerging drug combination; candesartan and chlorthalidone in human plasma and its application

A novel, precise, sensitive and accurate ultra-performance liquid chromatography-tandem mass spectrometry (UPLC-MS/MS) method has been developed for the simultaneous determination of a novel drug combination, candesartan (CAN) and chlorthalidone (CHL), in human plasma. Chromatographic separation was achieved on Waters Acquity UPLC BEH C₁₈ (50 × 2.1 mm, 1.7 μm). Mobile phase consisting of 1 mm ammonium acetate in water-acetonitrile (20:80 v/v) was used. The total chromatographic runtime was 1.9 min with retention times for CAN and CHL at 0.7 and 1.1 min respectively. Ionization and detection of analytes and internal standards was performed on a triple quadrupole mass spectrometer, operating in the multiple reaction monitoring and negative ionization mode. Quantitation was done to monitor protonated precursor → product ion transition of m/z 439.2 → 309.0 for CAN, 337.0 → 189.8 for CHL and 443.2 → 312.1 for candesartan D4 and 341.0 → 189.8 for chlorthalidone D4. The method was validated over a wide dynamic concentration range of 2.0-540.0 ng/mL for candesartan and 1.0-180.0 ng/mL for chlorthalidone. The validated method was successfully applied for the assay of CAN and CHL in healthy volunteers.

Simultaneous determination of atenolol and amiloride by capillary electrophoresis with capacitively coupled contactless conductivity detection (C4D)

Capillary electrophoresis coupled with a capacitively coupled contactless conductivity detector (CE-C(4)D) has been employed for the determination of the β-blocker drugs (atenolol and amiloride) in pharmaceutical formulations. 150 mM acetic acid was used as background electrolyte. The influence of several factors (detector excitation voltage and frequency, buffer concentration, applied voltage, capillary temperature, and injection time) was studied. Non-UV absorbing L-valine was used as an internal standard; the analytes were all separated in less than 7 min. The separation was carried out in normal polarity mode at 28 °C, 25 kV, and using hydrodynamic injection (25 s). The separation was effected in a bare fused-silica capillary 75 μm × 52 cm. The CE-C(4)D method was validated with respect to linearity, limit of detection and quantification, accuracy, precision, and selectivity. Calibration curves were linear over the range 5-250 μg mL(-1) for the studied analytes. The relative standard deviations of intra- and inter-day precisions of migration times and corrected peak areas were less than 6.0%. The method showed good precision and accuracy and was successfully applied to the simultaneous determination of the β-blocker drugs in different pharmaceutical tablets.

Simple and rapid HPLC method for simultaneous determination of atenolol and chlorthalidone in spiked human plasma

A simple, sensitive and rapid chromatographic method was developed and validated for the simultaneous quantification of atenolol and chlorthalidone in human plasma using hydrochlorothiazide as internal standard (IS). The method utilized proteins precipitation with acetonitril as the only sample preparation involved prior to reverse phase-HPLC. The analytes were chromatographed on Shim-pack cyanopropyl column with isocratic elution with 10 mM KH2PO4 (pH 6.0) - methanol (70:30, v/v) at ambient temperature with flow rate of 1 mL min(-1) and UV detection at 225 nm. The chromatographic run time was less than 10 min for the mixture. The calibration curves were linear over the range of 0.1-10 μg mL(-1). The method was validated in terms of accuracy, precision, absolute recovery, freeze-thaw stability, bench-top stability and re-injection reproducibility. The within- and between-day accuracy and precision were found to be within acceptable limits <15%. The analytes were stable after three freeze-thaw cycles (deviation <15%). The proposed method was specific for the simultaneous determination of atenolol and chlorthalidone in human plasma where there was no interference from endogenous biological substances.

Simultaneous determination of atenolol and chlorthalidone in plasma by high-performance liquid chromatography. Application to pharmacokinetic studies in man

An HPLC method developed to detect in a single run both atenolol and chlorthalidone, extracted from plasma, using two detectors (UV for chlorthalidone and fluorometric for atenolol) connected in series, is described. The drugs were separated on an ODS column at room temperature using a 0.05 M sodium dodecyl sulphate in phosphate buffer (pH 5.8)-n-propanol (95:5, v/v) solution, delivered at a flow-rate of 1.3 ml/min. Having ascertained the sensitivity (10 ng/ml of both drugs) and the intra-day reproducibility (pre-study validation), the reliability of the method was verified by inter-day assays (within-study validation) carried out during the analysis of plasma samples collected from healthy volunteers after single-dose treatment with atenolol+chlorthalidone tablets (pharmaceutical preparations containing 100+25 mg and 50+12.5 mg of the two drugs, respectively).

On-line solid-phase extraction and high-performance liquid chromatographic determination of chlorthalidone in urine

A simple and rapid on-line method for the determination of chlorthalidone in urine is proposed. The sample containing the internal standard is injected in a CN precolumn. After a 2-ml water rinsing, the precolumn is coupled for 30 s to the HPLC column via a switching, valve, allowing the on-line elution of the compounds of interest. Analysis is carried out by reversed-phase chromatography with an acetonitrile-0.01 M phosphate buffer pH 7 (20:80, v/v) eluent, using UV detection at 214 nm. While the LC separation is performed, the precolumn is regenerated and conditioned, and is ready to receive the next sample at the end of the run. Accurate (> 95%) and precise (< 10%) analyses, in the range of 0.1-20 micrograms/ml of chlorthalidone in urine, have been achieved using this method.