High-performance liquid chromatographic determination of N-methylformamide and N-methyl-N-(hydroxymethyl)-formamide in human urine

Simultaneous determination of N-hydroxymethyl-N-methylformamide, N-methylformamide and N-acetyl-S-(N-methylcarbamoyl)cystein in urine samples from workers exposed to N,N-dimethylformamide by liquid chromatography-tandem mass spectrometry

N-Hydroxymethyl-N-methylformamide (HMMF) and N-methylformamide (NMF) in urine samples from workers exposed to N,N-dimethylformamide (DMF) cannot be distinguished by a gas chromatographic method because HMMF is converted to NMF at the injection port of gas chromatography (GC). Total NMF (HMMF+NMF) has been measured instead. Also, the determination of N-acetyl-S-(N-methylcarbamoyl)cystein (AMCC), which is supposed to be related to the toxicity of DMF, needs multiple treatments to convert to a volatile compound before GC analysis. There is no previous report of a simultaneous determination of three major metabolites of DMF in urine. The aim of this study is to develop a simple and selective method for the determination of DMF metabolite in urine. By using a liquid chromatography-tandem mass spectrometry, we can directly distinguish these three major metabolites of DMF in a single run. The diluted urine samples were analyzed on Capcell Pak MF SG80 column with the mobile phase of methanol in 2mM formic acid (10:90, v/v). The analytes were detected by an electrospray ionization tandem mass spectrometry in the multiple-reaction-monitoring mode. The standard curves were linear (r>0.999) over the concentration ranges of 0.004-8 microg/mL. The precision and accuracy of quality control samples for inter-batch (n=6) analyses were in the range of 1.3-9.8% and 94.7-116.8, respectively. The sum of each HMMF and NMF concentration determined by LC-MS/MS method shows high correlation (r=0.9927 with the slope of 1.0415, p<0.0001) with NMF included HMMF concentration determined by GC method for 13 urine samples taken from workers exposed to DMF. The excretion ratio of HMMF:NMF:AMCC is approximately 4:1:1 in molar concentration.

Mercapturic acids in the biological monitoring of occupational exposure to chemicals

This paper reviews several procedures for determination of mercapturic acids in urine. Special attention was paid to methods useful in relation to human exposure to industrial pollutants, without any description for less sensitive methods used in animal research. Gas chromatographic and liquid chromatographic procedures were considered together with the little information available about thin layer chromatography and immunochemical techniques. After a description of the main industrial pollutants which lead to synthesis of their specific mercapturic acids, the methods for analysing these products are synthetically reported. The comparison among difficulties in sample preparation, complexity of instrumentation and their cost/benefit ratio are discussed.

Measurement of urinary N-acetyl-S-(N-methylcarbamoyl)cysteine by high-performance liquid chromatography with direct ultraviolet detection

A new high-performance liquid chromatographic (HPLC) method is described for the determination of urinary N-acetyl-S-(N-methylcarbamoyl)cysteine (AMCC), the final product of the conjugation reaction between a metabolic intermediate of N,N-dimethylformamide (DMF) and glutathione. Urine samples were purified by C(18) solid-phase extraction and then directly analysed by HPLC with an Aminex Ion Exclusion HPX-87H column maintained at 25 degrees C and a UV detector set at 196 nm. Under isocratic conditions (2.4 mM sulphuric acid, flow-rate=0.6 ml/min) AMCC eluted at 20.2 min. The reproducibility (C.V.%) was 1.3-2.7% (intra- and inter-assay, N = 5); the accuracy was 98.0+/-1.7% at 10 mg/l and 101.9+/-1.5% at 800 mg/l (mean+/-SD, N = 3). AMCC was measured in urine from 22 exposed subjects. A strong correlation was found between AMCC and environmental DMF [AMCC (mg/g creatinine)=3.40xDMF (mg/m(3)) + 3.07; r=0.95], while in the urine of 20 unexposed subjects the concentration of AMCC was constantly below the detection limit of the method (0.9 mg/l in urine). The method described appears to be useful for the biological monitoring of DMF exposure.

Simultaneous determination of two human urinary metabolites of N,N-dimethylformamide using gas chromatography-thermionic sensitive detection with mass spectrometric confirmation

Two human urinary metabolites of the industrial solvent N,N-dimethylformamide (DMF), N-hydroxymethyl-N-methylformamide (HMMF) and N-acetyl-S-(N-methylcarbamoyl)cysteine (AMCC), were assayed using a new analytical method (gas chromatography and thermionic sensitive detection). Clean-up of urine samples includes a liquid-liquid extraction step followed by a solid-phase extraction step to separate HMMF and AMCC from other urine components. During clean-up, AMCC is converted into ethyl-N-methylcarbamate (EMC), and during gas chromatography, HMMF is degraded in the injector to N-methylformamide (NMF). All the validation data necessary for a quantitative procedure are given. The method was applied to urine samples from workers exposed to DMF and from the general population. The results were confirmed by mass spectrometric determination. For this purpose a further liquid-liquid extraction step was introduced in the clean-up procedure. Background levels of AMCC in the general population were identified.

High-performance liquid chromatographic determination of n-methylformamide, a biological index for occupational exposure to dimethylformamide

This report describes an analytical method for the biological monitoring of workers exposed to N,N-dimethylformamide (DMF), a solvent widely used in the chemical industry. The human main metabolites of DMF are N-hydroxymethyl-N-methylformamide (HMMF) and the minor metabolites N-methylformamide (NMF) and N-acetyl-S-(N-methylcarbamoyl)cysteine. The metabolite selected by the American Conference of Governmental Hygienists for occupational biomonitoring purposes, is NMF measured by gas chromatographic analysis, as during it HMMF may be converted to the minor metabolite NMF. HMMF and NFM can be measured independently using HPLC analysis. The procedure proposed here involves the thermal transformation of the primary metabolite HMMF into the minor metabolite NMF, which is then determined by HPLC. This method makes it possible to determine, using HPLC, both metabolites of DMF by measuring only one peak, thus offering two major advantages: (i) it increases the sensitivity of the test and (ii) it deploys only one reference standard.

Biological monitoring of workers exposed to N, N-dimethylfomamide. I. Methods of analysis

Some methods for analysing N,N-dimethylformamide and its metabolites [hydroxymethyl-N-methylformamide, hydroxymethylformamide and N-acetyl-S-(N-methylcarbamoyl)cysteine] in the urine of exposed workers are described. Unchanged dimethylformamide was measured after pretreatment of urine (2 ml) with silica gel cartridges and elution with methanol. The gas chromatographic analysis using a nitrogen phosphor detector made it possible to detect N,N-dimethylformamide in urine even when workers were exposed to low concentrations of the solvent (about 1 mg/m3). N-Hydroxymethyl-N-methylformamide and N-hydroxymethylformamide were analysed as N-methylformamide and formamide respectively after direct injection of urine into the gas chromatograph. The injection port temperature played an important role in the gas chromatographic determination of these products. Reliable results were obtained when direct or split injections were performed at 250 degrees C. The splitless injection gave the same reliable results at 150 degrees C. In urine samples from occupationally non-exposed persons, N-methylformamide could not be detected. In contrast, formamide (or its precursor, hydroxymethylformamide) was present in every urine sample. Our results in respect of 19 urine samples analysed with the injection port of the gas chromatograph at 250 degrees C gave a mean of 8.6 mg/l of formamide. N-Acetyl-S-(N-methylcarbamoyl)cysteine was determined using a modified method for analysing organic acid in urine samples. The metabolite was extracted with ethyl ether in an acid environment, treated with a silylating reagent and measured by gas chromatography/mass spectrometry.