Evaluation of high-performance liquid chromatography for the separation and determination of arsenic species by on-line high-performance liquid chromatographic-hydride generation-atomic absorption spectrometry

Field Deployable Method for Arsenic Speciation in Water

Contamination of drinking water supplies by arsenic is a world-wide problem. Total arsenic measurements are commonly used to investigate and regulate arsenic in water, but it is well understood that arsenic occurs in several chemical forms, and these exhibit different toxicities. It is problematic to use laboratory-based speciation techniques to assess exposure as it has been suggested that the distribution of species is not stable during transport in some types of samples. A method was developed in this study for the on-site speciation of the most toxic dissolved arsenic species: As (III), As (V), monomethylarsonic acid (MMA) and dimethylarsenic acid (DMA). Development criteria included ease of use under field conditions, applicable at levels of concern for drinking water, and analytical performance.The approach is based on selective retention of arsenic species on specific ion-exchange chromatography cartridges followed by selective elution and quantification using graphite furnace atomic absorption spectroscopy. Water samples can be delivered to a set of three cartridges using either syringes or peristaltic pumps. Species distribution is stable at this point, and the cartridges can be transported to the laboratory for elution and quantitative analysis. A set of ten replicate spiked samples of each compound, having concentrations between 1 and 60 µg/L, were analyzed. Arsenic recoveries ranged from 78-112 % and relative standard deviations were generally below 10%. Resolution between species was shown to be outstanding, with the only limitation being that the capacity for As (V) was limited to approximately 50 µg/L. This could be easily remedied by changes in either cartridge design, or the extraction procedure. Recoveries were similar for two spiked hard groundwater samples indicating that dissolved minerals are not likely to be problematic. These results suggest that this methodology can be use for analysis of the four primary arsenic species of concern in drinking water supplies.

A simple and fast detection technique for arsenic speciation based on high-efficiency photooxidation and gas-phase chemiluminescence detection

High-efficiency photooxidation (HEPO) and gas phase chemiluminescence detection (CL) combined with high-performance liquid chromatography (HPLC) and hydride generation were developed for speciation of As(III), As(V), monomethylarsonic acid (MMA) and dimethylarsinic acid (DMA). After chromatography separation, the arsenic species were passed through HEPO which performed efficient photooxidation and converted MMA and DMA to As(V) in several seconds. Then the reaction of ozone and arsine upon hydride generation produced a CL signal as the analytical parameter. The total analytical process was completed within 10 min. The effects of operational parameters such as the concentrations of hydrochloric acid and NaBH4 solution, carrier gas flow and air gas flow for ozone generation were investigated. Detection limits were 3.7, 10.3, 10.2 and 10.0 microg/L for As(III), As(V), MMA and DMA, respectively. The recoveries of the four arsenic species in human urine sample ranged from 87 to 94%.

Arsenic speciation analysis in water samples: a review of the hyphenated techniques

Interests in the determination of different arsenic species in natural waters is caused by the fact that toxic effects of arsenic are connected with its chemical forms and oxidation states. In determinations of water samples inorganic arsenate (As(III), As(V)), methylated metabolities (MMAA, DMAA) and other organic forms such as AsB, AsC, arsenosugars or arsenic containing lipids have the most importance. This article provides information about occurrence of the dominant arsenic forms in various water environments. The main factors controlling arsenic speciation in water are described. The quantification of species is difficult because the concentrations of different forms in water samples are relatively low compared to the detection limits of the available analytical techniques. Several hyphenated methods used in arsenic speciation analysis are described. Specific advantages and disadvantages of methods can define their application for a particular sample analysis. Insufficient selectivity and sensitivity of arsenic speciation methods cause searching for a new or modifications already existing techniques. Some aspects of improvement and modifications of the methods are highlighted.

On-line reversed-phase liquid chromatography hydride generation emission spectrometry: speciation of arsenic in urine of patients intravenously treated with As2O3

Hydride generation inductively coupled plasma-atomic emission spectrometry (HG ICP-AES) was used as a continuous detection system for the determination of arsenic in the eluate from a high-performance liquid chromatographic (HPLC) system. Four arsenic species [arsenite As(III), arsenate As(V), monomethylarsonate (MMA), and dimethylarsinate (DMA)] present in the urine samples of patients treated intravenously with arsenite, were analyzed separately by HPLC-HG-ICP-AES using a non-polar C18 column. This analytical method allowed the sensitive determination of the arsenic species in the submicrogram per liter range. Urine samples collected on different days after arsenite administration were found to contain arsenite predominantly--monomethylarsonate and dimethylarsinate were also detected.

Speciation of dimethylarsinic acid and monomethylarsonic acid by solid-phase microextraction-gas chromatography-ion trap mass spectrometry

A solid-phase microextraction (SPME) method has been developed to determine two methylated arsenic species in human urine samples by GC-MS. The direct extraction of the methyl arsenic compounds by SPME after thioglycol methylate derivatization was studied. Direct extraction with SPME was suitable for the determination of trace levels of dimethylarsinic acid (DMA) and monomethylarsonic acid (MMA) in urine samples. Four different commercial SPME fibers were tested for the extraction of methyl arsenic compounds, and the best results were obtained using the polydimethylsiloxane coating. The extraction and desorption time profiles of DMA and MMA were determined. The detection limits for DMA and MMA using the SPME-GC-MS method were 0.12 and 0.29 ng/ml, respectively. The method is linear in the 1 to 200 ng/ml range.

Simultaneous determination of dimethylarsinic acid and monomethylarsonic acid after derivatization with thioglycol methylate by gas chromatography/mass spectrometry

A gas chromatography/mass spectrometry (GC/MS) method has been developed to determine two methylated arsenic species in human urine samples. The yield of derivatization for dimethylarsinic acid (DMA) and monomethylarsonic acid (MMA) using thioglycol methylate (TGM) was measured. The detection limit for the derivatized DMA and MMA using the GC/MS method are 0.95 and 0.8 ng cm-3, respectively. This simple and rapid method has good precision and accuracy. Fragmentation routes of derivatized MMA and DMA are suggested on accurate mass measurements.