Characterization of cap-shaped silver particles for surface-enhanced fluorescence effects

Indium nanoparticle-based surface enhanced fluorescence from deep ultraviolet to near-infrared: A theoretical study

Herein, for the first time, we report a theoretical investigation on Indium nanoparticle-based surface enhanced fluorescence (SEF) from deep ultraviolet (UV) to near-infrared (NIR). In the beginning, the far- and near-field plasmonic properties of the Indium nanospheres of different sizes are studied to extract the wavelengths of lower and higher-order localized surface plasmon modes and the corresponding local electric field enhancement (EFE) values. Later, the dependence of the SEF enhancement with the separation between the fluorophore and nanoparticle (d), fluorescence, and excitation wavelengths is studied systematically. The role of the surrounding medium on plasmon mode wavelength and the SEF enhancement is also shown. Moreover, the effect of d and fluorescence wavelength on the average SEF enhancement is investigated. Finally, the variation in the plasmonic properties after thin dielectric coating on the surface of single Indium nanospheres is studied.

Protection of silver and gold LSPR biosensors in corrosive NaCl environment by short alkanethiol molecules; characterized by extinction spectrum, helium ion microscopy and SERS

We investigated the utility of localized surface plasmon resonance sensors in a biologically relevant environment containing NaCl. Our sensors are fabricated by depositing gold or silver on a monolayer of adsorbed monodisperse SiO2 nanospheres. While silver nanostructures are rather unstable in air and water as assessed by drifts in the extinction peak, even gold nanostructures have been found to drift at elevated NaCl concentrations. In an attempt to protect these nanostructures against NaCl, we modified them with alkanethiols with different lengths in the vapor phase and found that shorter chain alkanethiols such as 1-butanethiol are particularly effective against even 250 mM NaCl, rather than longer-chain alkanethiols more suitable for robust SAM formation. A vapor phase treatment method, in contrast to widely used solution phase treatment methods, was selected with the intention of reducing the solvent effect, i.e. destruction of intricate nanostructures upon contact with a solvent when nanostructures have been prepared in a vacuum system. Moreover, the treatment with 1-butanethiol led to an enhanced sensitivity as expressed by peak shift in nm per refractive index unit, nm per RIU. We show the results of evaluating alkanethiol-protected silver and gold nanostructures by extinction spectroscopy, helium ion microscopy and surface-enhanced Raman spectroscopy. The vapor phase treatment method with short chain alkanethiols is an effective way to protect intricate gold and silver nanostructures prepared in a vacuum system.

Enhancement of Fluorescence-Based Sandwich Immunoassay Using Multilayered Microplates Modified with Plasma-Polymerized Films

A functional modification of the surface of a 96-well microplate coupled with a thin layer deposition technique is demonstrated for enhanced fluorescence-based sandwich immunoassays. The plasma polymerization technique enabling the deposition of organic thin films was employed for the modification of the well surface of a microplate. A silver layer and a plasma-polymerized film were consecutively deposited on the microplate as a metal mirror and the optical interference layer, respectively. When Cy3-labeled antibody was applied to the wells of the resulting multilayered microplate without any immobilization step, greatly enhanced fluorescence was observed compared with that obtained with the unmodified one. The same effect could be also exhibited for an immunoassay targeting antigen directly adsorbed on the multilayered microplate. Furthermore, a sandwich immunoassay for the detection of interleukin 2 (IL-2) was performed with the multilayered microplates, resulting in specific and 88-fold–enhanced fluorescence detection.

Morphology Effects of Cap-shaped Silver Nanoparticle Films as a SERS Platform

In this paper, we evaluate randomly adsorbed cap-shaped silver nanoparticles for applications to surface-enhanced Raman spectroscopy, SERS. They were prepared by depositing silver on top of surface-adsorbed monodisperse SiO2 nanospheres, in a manner similar to the method for preparing metal film on nanosphere, MFON, but one major difference lies in the fact that nanospheres are randomly adsorbed rather than as a close-packed MFON. With random MFON, it is possible to incorporate nanospheres with more than one size. Mixing has been found to increase SERS performance. More specifically, by using 50 and 100 nm nanospheres, we found that substrates containing both types outperform substrates prepared from 100% of either 50 or 100 nm nanospheres. As evaluated by spectrophotometry, this increase could not be attributed to an increase in the extinction coefficient of the substrate at the irradiation wavelength of SERS measurements.

Photonic crystal micropost as a microarray platform

This study demonstrates a photonic crystal micropost (PCMP) substrate for microarray applications. The substrate comprises an array of circular MPs with a PC on top of these MPs. This substrate enables biomolecule-containing droplets to form a composite contact upon deposition, thus allowing biomolecules to be attached on only the MPs, forming spots. When the device (PC) is excited on resonance, the electric field intensity is enhanced on only the top surface of the MPs. This enables the fluorescence intensities to be enhanced up to 5.50x; principally, this enhancement does not engender an increase in the background (intensity outside MP or spots) and noise intensities. The PCMP substrate enhances the spot intensity and minimizes the background intensity, enabling the detection of lower concentration analytes.

Enhanced fluorescence emitted by microdroplets containing organic dye emulsions

In this paper, laser beam resonant interaction with pendant microdroplets that are seeded with a laser dye (Rhodamine 6G (Rh6G)) water solution or oily Vitamin A emulsion with Rhodamine 6G solution in water is investigated through fluorescence spectra analysis. The excitation is made with the second harmonic generated beam emitted by a pulsed Nd:YAG laser system at 532 nm. The pendant microdroplets containing emulsion exhibit an enhanced fluorescence signal. This effect can be explained as being due to the scattering of light by the sub-micrometric drops of oily Vitamin A in emulsion and by the spherical geometry of the pendant droplet. The droplet acts as an optical resonator amplifying the fluorescence signal with the possibility of producing lasing effect. Here, we also investigate how Rhodamine 6G concentration, pumping laser beam energies and number of pumping laser pulses influence the fluorescence behavior. The results can be useful in optical imaging, since they can lead to the use of smaller quantities of fluorescent dyes to obtain results with the same quality.

Enhanced infrared LSPR sensitivity of cap-shaped gold nanoparticles coupled to a metallic film

We report on optical properties of gold deposited on SiO2 nanospheres randomly adsorbed on a thin gold layer. Extinction peaks with optical density of more than 2 are observed in the visible as well as near-IR regimes. The peak wavelength of the latter was affected exquisitely by the thickness of the top layer. A helium ion microscope (HIM) was used for careful observation of morphological transformation accompanying the change in the deposition thickness. Growth of grain structures into a capped-dimer structure was accompanied by slight blue-shift of the visible peak and significantly greater red-shift of the near-IR peak. Our finite-difference time-domain (FDTD) calculations show that these peaks in the visible and near-IR can be respectively attributed to dipole modes associated with transverse and longitudinal oscillations of free electrons in the gold-capped dimer. To investigate the refractive index sensitivity of these peaks, we used two approaches: immersion in solutions of varying refractive index and coating with an organic layer. With the first approach that characterizes the bulk sensitivity, the visible peak shows sensitivity of 122 nm/RIU, while the near-IR peak shifts at the rate of 506 nm/RIU. With the second approach that reflects the local sensitivity, the surface was saturated with alkaline phosphatase (ALP), whose subsequent reaction led to formation of a thin insoluble organic layer, causing a relatively small blue-shift, under 7 nm, of the visible peak and much larger red-shift, over 50 nm, of the near-IR peak when measured in buffer. When the same reaction was measured at end points in the air, the shift was as large as 444 nm for the near-IR peak.

pH- and glucose-responsive core-shell hybrid nanoparticles with controllable metal-enhanced fluorescence effects

In this paper, a novel core-shell hybrid nanoparticle with a silver core and cross-linked poly(3-acrylamidephenylboronic acid-co-acrylic acid) shell (Ag@PAPBA-PAA) was reported. The prepared hybrid nanoparticles can exhibit good responsiveness to the glucose concentration and pH of the environment and exhibit a responsive swelling and shrinking behavior. Tuned by the glucose concentration or pH, a swelling of up to 15.0 nm thickness of the hybrid nanoparticle shell can be observed. These unique responsive properties can be employed to tune the metal-enhanced fluorescence (MEF) effects of the incorporated Ag cores. The fluorescence of adsorbed positively charged porphyrin molecules (Por(4+)) shows good sensitivity to the glucose concentration and pH with an enhancement of up to about 1.8-fold. These functional hybrid nanoparticles with tunable MEF effects show a great potential application in the fields of responsive fluorescent sensing and detection.

Multiplexed cancer biomarker detection using quartz-based photonic crystal surfaces

A photonic crystal (PC) surface is demonstrated as a high-sensitivity platform for detection of a panel of 21 cancer biomarker antigens using a sandwich enzyme-linked immunosorbent assay (ELISA) microarray format. A quartz-based PC structure fabricated by nanoimprint lithography, selected for its low autofluorescence, supports two independent optical resonances that simultaneously enable enhancement of fluorescence detection of biomarkers and label-free quantification of the density of antibody capture spots. A detection instrument is demonstrated that supports fluorescence and label-free imaging modalities, with the ability to optimize the fluorescence enhancement factor on a pixel-by-pixel basis throughout the microarray using an angle-scanning approach for the excitation laser that automatically compensates for variability in surface chemistry density and capture spot density. Measurements show that the angle-scanning illumination approach reduces the coefficient of variation of replicate assays by 20-99% compared to ordinary fluorescence microscopy, thus supporting reduction in limits of detectable biomarker concentration. Using the PC resonance, biomarkers in mixed samples were detectable at the lowest concentrations tested (2.1-41 pg/mL), resulting in a three-log range of quantitative detection.

Application of photonic crystal enhanced fluorescence to cancer biomarker microarrays

We report on the use of photonic crystal surfaces as a high-sensitivity platform for detection of a panel of cancer biomarkers in a protein microarray format. The photonic crystal surface is designed to provide an optical resonance at the excitation wavelength of cyanine-5 (Cy5), thus providing an increase in fluorescent intensity for Cy5-labeled analytes measured with a confocal microarray scanner, compared to a glass surface. The sandwich enzyme-linked immunosorbent assay (ELISA) is undertaken on a microarray platform to undertake a simultaneous, multiplex analysis of 24 antigens on a single chip. Our results show that the resonant excitation effect increases the signal-to-noise ratio by 3.8- to 6.6-fold, resulting in a decrease in detection limits of 6-89%, with the exact enhancement dependent upon the antibody-antigen interaction. Dose-response characterization of the photonic crystal antibody microarrays shows the capability to detect common cancer biomarkers in the <2 pg/mL concentration range within a mixed sample.

Nanostructured silver-based surfaces: new emergent methodologies for an easy detection of analytes

In this work, we describe how to realize a new sensing platform for an easy and fast detection of analytes. In particular, we utilized enhanced fluorescence emission on silver island films (SIFs) coupled to the total internal reflection fluorescence mode (TIRF) to develop a new assay format for the detection of target analytes. Here, as an example, we report on the detection of the toxic peptides present in gliadin (Gli). Our assay was performed as follows: (1) gliadin was first captured on surfaces coated with anti-Gli antibodies; (2) the surfaces were then incubated with fluorophore-labeled anti-Gli antibodies; (3) the signal from the fluorophore-labeled anti-Gli antibody bound to the antigen was detected by TIRF. The system was examined on glass surfaces and on SIFs. We observed a relevant enhancement of the signal from SIFs compared to the signal from the glass substrate not modified with a SIF. In addition, the estimated detection limit (EDL) of our methodology was 60 ng/mL (or lower). This limit is therefore lower than the clinical cut-off for Gli presence in food for celiac patients. The advantage of our method is a reduced number of testing steps, which allows for easy detection of residual toxic peptides in food labeled as gluten free. The proposed technology can be easily expanded to the determination of different target analytes.

Novel approach for the assembly of highly efficient SERS substrates

In this paper we present the properties of surface-enhanced Raman scattering (SERS) active substrates elaborated by a low-cost approach. Our methodology relying on capillary assembly and soft lithography allows us to generate periodic two-dimensional (2D) matrixes of 100 nm gold nanoparticle patterns in a very precise, cost-efficient, and large-scale manner. For this study, we assembled nanoparticle aggregates of different sizes (one to six particles) in order to determine the influence of the aggregation on the local electric field enhancement. We further demonstrate that this substrate is greatly efficient not only for SERS but also in metal-enhanced fluorescence (MEF) for local enhancement of conventional fluorescence.