Impact of sacral colpopexy on in vivo vaginal biomechanical properties

Non-invasive biomechanical assessment of the prolapsed vaginal wall: an explorative pilot study on cutometry and indentometry

The clinical assessment of pelvic organ prolapse (POP) and associated treatment strategies is currently limited to anatomical and subjective outcome measures, which have limited reproducibility and do not include functional properties of vaginal tissue. The objective of our study was to evaluate the feasibility of using cutometry and indentometry for non-invasive biomechanical assessment of the vaginal wall in women with POP. Both techniques were applied on the vaginal wall of 20 women indicated for surgical correction of POP stage two or higher. The primary outcome was the measurement success rate. Measurements were considered successful if biomechanical parameters were generated after a maximum of three attempts. Secondary outcomes included acquisition time, number of attempts to obtain a successful measurement, and biomechanical parameters. Measurements were successfully performed on the anterior vaginal wall of 12 women with cystocele and the posterior vaginal wall of eight women with rectocele. The success rate was 100% for both techniques and acquisition time was under 1 minute for all 20 measurements. Tissue fast elasticity of the posterior vaginal wall (rectocele) was significantly higher than that of the anterior vaginal wall (cystocele) and negatively correlated with age (r = - 0.57, P < 0.05). In women with POP, measuring the biomechanical properties of the vaginal wall using cutometry and indentometry is technically feasible. Objective evaluation of biomechanical properties may help to understand the pathophysiology behind surgical outcomes, providing an opportunity for the identification of patients at risk for (recurrent) prolapse, and individualized treatment decisions.

Investigation of Murine Vaginal Creep Response to Altered Mechanical Loads

The vagina is a viscoelastic fibromuscular organ that provides support to the pelvic organs. The viscoelastic properties of the vagina are understudied but may be critical for pelvic stability. Most studies evaluate vaginal viscoelasticity under a single uniaxial load; however, the vagina is subjected to dynamic multiaxial loading in the body. It is unknown how varied multiaxial loading conditions affect vaginal viscoelastic behavior and which microstructural processes dictate the viscoelastic response. Therefore, the objective was to develop methods using extension-inflation protocols to quantify vaginal viscoelastic creep under various circumferential and axial loads. Then, the protocol was applied to quantify vaginal creep and collagen microstructure in the fibulin-5 wildtype and haploinsufficient vaginas. To evaluate pressure-dependent creep, the fibulin-5 wildtype and haploinsufficient vaginas (n = 7/genotype) were subjected to various constant pressures at the physiologic length for 100 s. For axial length-dependent creep, the vaginas (n = 7/genotype) were extended to various fixed axial lengths then subjected to the mean in vivo pressure for 100 s. Second-harmonic generation imaging was performed to quantify collagen fiber organization and undulation (n = 3/genotype). Increased pressure significantly increased creep strain in the wildtype, but not the haploinsufficient vagina. The axial length did not significantly affect the creep rate or strain in both genotypes. Collagen undulation varied through the depth of the subepithelium but not between genotypes. These findings suggest that the creep response to loading may vary with biological processes and pathologies, therefore, evaluating vaginal creep under various circumferential loads may be important to understand vaginal function.

Mesenchymal stem cell-based bioengineered constructs enhance vaginal repair in ovariectomized rhesus monkeys

Transvaginal meshes repair for treating pelvic organ prolapse (POP) was halted by the U. S. Food and Drug Administration (FDA) because they can lead to severe complications. Therefore, investigations of new therapeutic strategies are urgently needed. Cell-based regenerative therapy holds great promise for the repair and restoration of damaged tissue. Here, we generated a bioengineered graft by seeding human umbilical cord mesenchymal stem cells (HUMSCs) on bioscaffolds to reconstruct the damaged vagina. In the in vitro study, HUMSCs proliferated well and the density was appropriate after 5 days of culture. Besides, we demonstrated that the differentiation potential of HUMSCs was maintained with external growth factor stimulation. The complete transcriptomic profile of HUMSCs revealed that HUMSCs cultured on grafts produced significantly higher levels of proangiogenic cytokines than cells cultured in tissue culture plates (TCPs). Three months after implantation of the bioengineered grafts into ovariectomized (OVX) rhesus monkeys via sacrocolpopexy, extracellular matrix reorganization, large muscle bundle formation, angiogenesis and, mechanical properties of the vagina were enhanced. To our knowledge, this is the first demonstration of the utility of stem cell-based bioengineered grafts for repairing damaged vaginal tissue in rhesus monkeys. These results elucidate a new approach for vagina repair and provide new ideas for treating POP.

Measuring tissue displacement of the anterior vaginal wall using the novel aspiration technique in vivo

Little is known about the mechanical properties of pelvic floor structures and their role in the course and treatment of pelvic organ prolapse (POP). We hypothesize that in vivo mechanical properties of the vaginal wall are related to the appearance of POP and pre-and post-operative states. We used a suction device for intravaginal application, the aspiration device, to evaluate two in vivo mechanical parameters of the anterior vaginal wall, the load dependent tissue displacement and the initial displacement, by image analysis in pre- and post-menopausal women with (POP) and without (control) cystocele (POP: pre-menopausal: N = 6, post-menopausal: N = 19, control: pre-menopausal: N = 17, post-menopausal: N = 6). Mechanical parameters in women with and without cystocele and pre- and post-operative parameters were compared. Statistically significant differences were observed between the two mechanical parameters in pre- and post-operative states (P = 0.04, P = 0.03), but not between the parameters for women with and without cystocele (P = 0.92, P = 0.75). The mechanical behavior of pelvic floor structures is influenced by factors such as POP, age or estrogenization that are apparent at different length scales, which cannot be separated by the aspiration based biomechanical measurements. When comparing pre- and post-operative states of the same patient, a firmer tissue response was observed after intervention.

Biomechanical properties of vaginal tissue in women with pelvic organ prolapse

BACKGROUND/AIMS

To compare biomechanical properties of vaginal tissues between women with and without pelvic organ prolapse (POP) and investigate factors that may influence these properties.

METHODS

Forty patients submitted to POP surgery and 15 non-POP cadavers were evaluated. The tissue was excised from anterior and posterior middle third vagina. The biomechanical properties considered were stiffness (E) and maximum stress (S), and they were evaluated by means of uniaxial tension tests.

RESULTS

POP patients were associated with higher values of E (13.1 ± 0.8 vs. 9.5 ± 0.7 MPa; p < 0.001) and S (5.3 ± 0.5 vs. 3.2 ± 0.9 MPa; p < 0.001) in the anterior vaginal wall compared to the posterior wall. In contrast, non-POP women presented lower values of E (6.9 ± 1.1 vs. 10.5 ± 1.0 MPa; p = 0.01) and S (2.6 ± 0.4 vs. 3.5 ± 0.4 MPa; p = 0.043) in the anterior wall. The occurrence of POP was the only independent predictor of higher values of E and S in anterior vaginal samples (p = 0.003 and p = 0.008, respectively). Women with severe anterior vaginal prolapse presented higher levels of E and S in the anterior sample compared to those with lower POP stages (p = 0.001 and p = 0.01; respectively).

CONCLUSION

Women with POP present significant changes of biomechanical properties in the vagina.

Persistence of polypropylene mesh anisotropy after implantation: an experimental study

OBJECTIVE

To determine whether anisotropy persisted after incorporation into the host, using a standardised rabbit model for abdominal wall reconstruction.

DESIGN

Investigator-initiated prospective-controlled experimental study.

SETTING

Centre for Surgical Technologies, Medical Faculty KU-Leuven.

SAMPLE

Fifteen New Zealand White rabbits.

METHODS

In each rabbit, four full thickness primarily repaired abdominal wall defects were covered by a 4 × 5-cm Prolift+M implant (Johnson & Johnson, Norderstedt, Germany), either with the stiffest (n = 6 rabbits) or most elastic (n = 6) direction parallel to the body axis. Prolift+M contains 32 g/m² polypropylene, reinforced with polyglecaprone fibres. Harvesting was performed after 30, 60 and 120 days (n = 2 each time-point). The abdominal wall of three unoperated rabbits was used as negative control.

MAIN OUTCOME MEASURES

Contraction, compliance and maximal strain and stress determined by uniaxial tensiometry.

RESULTS

Anisotropy properties persist at lower, more physiological displacements, but not at higher displacements. The stiffness of a mesh-augmented repair in the lower strain range remains above that of native tissue. Eventual mesh contraction was limited to 4.3%.

CONCLUSIONS

Anisotropic properties of Prolift+M persist in vivo and shrinkage is minimal. Compliance of mesh-augmented repair remains less than that of native tissue. The functional consequences of this remain to be studied.