Improving the energy balance of grass-based anaerobic digestion through combined harvesting and pretreatment

Biogas production from beverage factory wastewater in a mobile bioenergy station

Recently, the production of renewable biogas such as biohydrogen and biomethane from wastewaters through anaerobic fermentation has gained worldwide attention. In the present study, a mobile bioenergy generation station had been constructed based on a high-efficiency hydrogenesis & methanogenesis technology (HyMeTek) developed by Feng Chia University, Taiwan. The substrate was a beverage wastewater having chemical oxygen demand (COD) concentration of 1200 mg/L. This bioenergy station had a feedstock tank (3.8 m³), a nutrient tank (0.8 m³), an acidogenesis tank (AT, 2 m³), two methanogenesis tanks (MT, 4 m³ for each), a membrane bioreactor and a control room. Biogas production rate, methane concentration, COD removal efficiencies, energy efficiency and economical interest of the plant were assessed. The peak total methane production rates for AT (at hydraulic retention time, HRT, 4 h) and MT (at HRT 8 h) were 430 and 7 mL/L·d, respectively. A strategy of shortening HRT was a promising method to enhance biogas quality and energy efficiency. This mobile bioenergy system has commercial potential because it could bring good economic benefit of initial rate of return (58.84%) and payback time (2.68 y).

Exploitation of Mowed Grass from Green Areas by Means of Anaerobic Digestion: Effects of Grass Conservation Methods (Drying and Ensiling) on Biogas and Biomethane Yield

Grass from landscape management or from agricultural practices is currently destined mainly for composting, with the production of a valuable product; however, this process demands energy. Anaerobic digestion, instead, represents an energy-positive process that results in the production of fuel, biogas, and a fertilizer, namely digestate. Previous tests for the evaluation of biogas yield from freshly harvested grass gave promising results. However, for a practical exploitation of this resource, appropriate conservation is necessary in order to enable the daily load of digesters while reducing the loss of organic matter. The present work is focused on the evaluation of biogas and methane yield from dried and ensiled grass (without conditioning) in order to assess eventual biogas potential losses in comparison to digested fresh grass. Tests were performed with grass collected from riverbanks (Veneto, Northern Italy) in batch, lab scale digesters. Dry and ensiled grass showed a good potential for exploitation in the anaerobic digestion process, reaching biogas yields of 565.9 and 573.4 NL∙kgVS−1, respectively. Compared to the biogas yield of 639.7 NL∙kgVS−1 of the fresh grass, the conservation treatment determined yield reductions of 11.5% and 10.4% for dried and ensiled grass, respectively. However, considering the methane yields, conservation treatments showed lower reductions, amounting to 4.8% for dry grass and 0.5% for ensiled grass; presumably the higher concentration of organic acids in ensiled grass determined a higher methane content in biogas and the consequently lower reduction of methane yield.

Mechanical pretreatment of lignocelluloses for enhanced biogas production: Methane yield prediction from biomass structural components

In this study, mechanical pretreatment was applied to six different lignocelluloses in two different treatment phases and the prediction of their methane yield was done from biomass chemical composition. Physicochemical, proximate and microbial analyses were carried out on both pretreated and untreated biomass using standard methods. Mechanical pretreatments caused the breakdown of structural materials in all the used biomass which was characterized by reduction of the lagging time during anaerobic digestion and the subsequent increase in methane yield up to 22%. The different loading rate of biomass had no effect on the overall methane yield increase. Both single and multiple linear regressions models were used in order to correlate the chemical composition of the biomass with their methane potentials and a fairly high correlation (R² = 0.63) was obtained. The study also showed that the pretreatments are economically feasible. Therefore, its further application to other biomass is encouraged.

The Future Agricultural Biogas Plant in Germany: A Vision

After nearly two decades of subsidized and energy crop-oriented development, agricultural biogas production in Germany is standing at a crossroads. Fundamental challenges need to be met. In this article we sketch a vision of a future agricultural biogas plant that is an integral part of the circular bioeconomy and works mainly on the base of residues. It is flexible with regard to feedstocks, digester operation, microbial communities and biogas output. It is modular in design and its operation is knowledge-based, information-driven and largely automated. It will be competitive with fossil energies and other renewable energies, profitable for farmers and plant operators and favorable for the national economy. In this paper we discuss the required contribution of research to achieve these aims.

Mechanical pretreatment for increased biogas production from lignocellulosic biomass; predicting the methane yield from structural plant components

Lignocellulosic substrates are associated with limited biodegradability due to the structural complexity. For that reason, a pretreatment step is mandatory for efficient biomass transformation which will lead to increased bioenergy output. The aim of the present study was to assess the efficiency of two pretreatment machines to enhance the methane yield of meadow grass. Specifically, the application of shearing forces with a rotated plastic sweeping brush against a steel roller significantly increased biomass biodegradability by 20% under relatively gentle operation conditions (600 rpm). The more intense operation (1200 rpm) was not associated with higher methane yield enhancement. Regarding an alternative machine, in which the brush was replaced with a coarse steel roller resulted in a more distinct effect (+27%) despite the lower rotating speed (∼400 rpm). Moreover, the association of the substrate's individual chemical components and the practical methane yield was assessed, establishing single and multiple linear regression models. However, the estimation accuracy was rather low with either single (regressor: lignin, R²: 0.50) or multiple linear regression analyses (regressors: arabinan-lignin-protein, R²: 0.61). Results showed that poorly lignified plant tissue containing relatively high fractions of protein and arabinan is more susceptible to anaerobic digestion.