A thorough investigation on pushing activities in industry: The impact of the variation in the speed of motion and load conditions on initial and sustained forces

Characterization of hand forces exerted during non-powered hospital bed pushing and pulling tasks

Accurate assessment of biomechanical risk associated with pushing/pulling tasks represents a challenging issue, especially in the health system where personnel are often required to maneuver beds and carts. Most studies in this field have been carried out in the laboratory, while few data have been collected under actual working conditions. This study aims to characterize the forces exerted during non-powered hospital bed maneuvering. Twenty participants were required to move a bed (equipped with a customized handlebar to measure exerted forces) along an actual hospital path including straight, turn and maneuver phases. The results show that higher forces are associated with the initial phase (peak and mean values 222 and 68 N) while the straight, turn and maneuvering phases required similar (lower) efforts. The combined effect of left, right and transversal forces suggests that the trunk of the operator might experience axial rotation, thus calling for further investigations of this aspect.

The Effects of Ramp Gradients and Pushing-Pulling Techniques on Lumbar Spinal Load in Healthy Workers

Background

Many tasks in industrial and health care setting are involved with pushing and pulling tasks up or down on a ramp. An efficient method of moving cart which reduces the risk of low back pain should be concerned. This study aimed to investigate the effects of handling types (HTs) and slope on lumbar spinal load during moving a cart on a ramp. We conducted a 2 × 2 × 4 factorial design with three main factors: 2 HTs, 2 handling directions of moving a cart and 4 degrees of ramp slope.

Methods

Thirty healthy male workers performed 14 tasks consist of moving a cart up and down on the ramp of 0°, 10°, 15°, and 20° degrees with pushing and pulling methods. Joint angles from a 3D motion capture system combined with subject height, body weight, and hand forces were used to calculate the spinal load by the 3DSSPP program.

Results

Our results showed significant effect of HT, handling directions and slope on compression and shear force of the lumbar spine (p < 0.001). When the ramp gradient increased, the L4/5 compression forces increased in both pushing and pulling (p < 0.001) Shear forces increased in pulling and decreased in pushing in all tasks. At high slopes, pulling generated more compression and shear forces than that of pushing (p < 0.01).

Conclusion

Using the appropriate technique of moving a cart on the ramp can reduce the risk of high spinal load, and the pushing is therefore recommended for moving a cart up/down on ramp gradients.