Flow injection determination of ketotifen fumarate using PVC membrane selective electrodes

Potentiometric determination of ketotifen fumarate in pharmaceutical preparations and urine using carbon paste and PVC membrane selective electrodes

This study compares between unmodified carbon paste (CPE; the paste has no ion pair) and polyvinyl chloride (PVC) membrane selective electrodes that were used in potentiometric determination of ketotifen fumarate (KTF), where sodium tetraphenylborate (NaTPB) was used as titrant. The performance characteristics of these sensors were evaluated according to IUPAC recommendations which reveal a fast, stable, and linear response for KTF over the concentration range of 10⁻⁷ to 10⁻² mol L⁻¹. The electrodes show Nernstian slope value of 52.51 ± 0.20 and 51.51 ± 0.25 mV decade⁻¹ for CPE and PVC membrane electrodes at 30°C, respectively. The potential is nearly stable over the pH range 3.0–6.0 and 2.0–7.0 for CPE and PVC membrane electrodes, respectively. Selectivity coefficient values towards different inorganic cations, sugars, and amino acids reflect high selectivity of the prepared electrodes. The electrodes responses at different temperatures were also studied, and long operational lifetime of 12 and 5 weeks for CPE and PVC membrane electrodes, respectively, were found. These are used for determination of ketotifen fumarate using potentiometric titration, calibration, and standard addition methods in pure samples, its pharmaceutical preparations (Zaditen tablets), and biological fluid (urine). The direct potentiometric determination of KTF using the proposed sensors gave recoveries % of 98.97 ± 0.53 and 98.62 ± 0.74 with RSD 1.42 and 0.63% for CPE and PVC membrane selective electrodes, respectively. Validation of the method shows suitability of the proposed sensors for use in quality control assessment of KTF. The obtained results were in a good agreement with those obtained using the reported spectrophotometric method.

Determination of ketotifen fumarate by capillary electrophoresis with tris(2,2'-bipyridyl) ruthenium(II) electrochemiluminescence detection

On the basis of an europium (III)-doped Prussian blue analog film modifying platinum electrode as the working electrode, a Ru(bpy)₃²⁺-based electrochemiluminescence (ECL) assay coupled with capillary electrophoresis has been first established for the determination of ketotifen fumarate (KTF). Analytes were injected onto a separation capillary of 50 cm length (50 μm i.d., 360 μm o.d.) by electrokinetic injection for 10 s at 10 kV. Parameters related to the separation and detection were discussed and optimized. It was proved that 15 mM phosphate buffer at pH 8.0 could achieve the most favorable resolution, and the highest sensitivity of detection was obtained using the detection potential at 1.25 V and 5 mM Ru(bpy)₃²⁺ in 100 mM phosphate buffer at pH 8.0 in the detection reservoir. Under the optimized conditions, the ECL intensity was in proportion to KTF concentration over the range from 3.0 × 10⁻⁸ to 5.0 × 10⁻⁶ g mL⁻¹ with a detection limit of 2.1 × 10⁻⁸  g mL⁻¹ (3σ). The relative standard deviations of the ECL intensity and the migration time were 0.95 and 0.26%, respectively. The developed method was successfully applied to determine KTF contents in pharmaceuticals and human urine with recoveries between 99.5 and 107.0%.