Operational performance and biofoulants in a dynamic membrane bioreactor

Insight into the effect of Tubificidae on dynamic membrane reactor: Membrane fouling mitigation and Tubificidae-ASM3-dynamic membrane coupled model

To gain insights into the effects of Tubificidae on dynamic membrane sequencing batch reactor (DMSBR), 4 identical DMSBRs were operated with different Tubificidae densities (i.e., 0, 1, 2, 3 g ww/L). Experimental results showed that Tubificidae had a minimal effect on carbon and nitrogen removal but varied effluent turbidity and sludge characteristics. An appropriate density (2 g ww/L) of Tubificidae significantly decreased effluent turbidity and mitigated membrane fouling, which was attributed to the minimized mixed liquor suspended solids (MLSS) and the maximized particle size. A Tubificidae-ASM3-dynamic membrane coupled model was developed by combining the biological model with the dynamic membrane resistance model, incorporating the extracellular polymeric substances (EPS) to characterize its contribution to membrane pore fouling, and introducing an inhibitory function to limit the unrestricted growth of membrane resistance. The model can be considered as a first attempt to describe the observed Tubificidae effects on dynamic membrane reactor.

Anaerobic dynamic membrane bioreactor for the co-digestion of toilet blackwater and kitchen waste

Anaerobic co-digestion using an anaerobic dynamic membrane bioreactor (AnDMBR) can separate the sludge retention time and hydraulic retention time, retaining the biomass for efficient degradation and the use of less expensive large pore-size membrane materials and more sustainable dynamic membranes (DMs). Therefore, anaerobic co-digestion of toilet blackwater (BW) and kitchen waste (KW) using an AnDMBR was hypothesized to increase the potential for co-digestion. Here, the efficiency and stability of AnDMBR in anaerobic co-digestion of toilet BW and KW were investigated. DM morphology and structural characteristics, filtration properties, and composition, as well as membrane contamination and membrane regeneration mechanisms, were investigated. Average daily biogas yields of the reactor in two membrane cycles before and after cleaning were 788.67 and 746.09 ml/g volatile solids, with average methane content of 66.64% and 67.27% and average COD removal efficiencies of 82.03% and 80.96%, respectively. The results showed that the bioreactor obtained good performance and stability. During the stabilization phase of the DM operation, the flux was maintained between 43.65 and 65.15 L/m2/h. DM was mainly composed of organic and inorganic elements. Off-line cleaning facilitated DM regulation and regeneration, restoring new Anaerobic morphology and structure. PRACTITIONER POINTS: High efficiency co-digestion of BW and KW was realized in the DMBR system. Average daily biogas yields before and after membrane cleaning were 788.67 and 746.09 ml/g volatile solids. Off-line cleaning facilitated DM regulation and regeneration as well as system stability. The flux was maintained between 43.65 and 65.15 L/m2/h during operation.

Prolonging the Life Span of Membrane in Submerged MBR by the Application of Different Anti-Biofouling Techniques

The membrane bioreactor (MBR) is an efficient technology for the treatment of municipal and industrial wastewater for the last two decades. It is a single stage process with smaller footprints and a higher removal efficiency of organic compounds compared with the conventional activated sludge process. However, the major drawback of the MBR is membrane biofouling which decreases the life span of the membrane and automatically increases the operational cost. This review is exploring different anti-biofouling techniques of the state-of-the-art, i.e., quorum quenching (QQ) and model-based approaches. The former is a relatively recent strategy used to mitigate biofouling. It disrupts the cell-to-cell communication of bacteria responsible for biofouling in the sludge. For example, the two strains of bacteria Rhodococcus sp. BH4 and Pseudomonas putida are very effective in the disruption of quorum sensing (QS). Thus, they are recognized as useful QQ bacteria. Furthermore, the model-based anti-fouling strategies are also very promising in preventing biofouling at very early stages of initialization. Nevertheless, biofouling is an extremely complex phenomenon and the influence of various parameters whether physical or biological on its development is not completely understood. Advancing digital technologies, combined with novel Big Data analytics and optimization techniques offer great opportunities for creating intelligent systems that can effectively address the challenges of MBR biofouling.

Occurrence, influence and removal strategies of mycotoxins, antibiotics and microplastics in anaerobic digestion treating food waste and co-digestive biosolids: A critical review

Food waste anaerobic digestion (FWAD) can be assisted with the co-digestion of manures, agricultural waste, and sewage sludge. Nevertheless, contaminants like mycotoxins, antibiotics, and microplastics (MPs) could be introduced and negatively affect the AD system. Over 180 literatures involved the occurrence, influence and removal strategies of these three types of pollutants in AD were summarized in this review. Aflatoxin B1(AFB1) as the most concerned mycotoxins were poorly degraded and brought about inhibitions in short-term. Considering methanogenesis inhibition and occurrence concentration, the risk of oxytetracycline and norfloxacin were identified as priority among antibiotics. Leaching toxic additives from MPs could be responsible for the AD inhibition, while their materials and sizes could also prolong the acidification and methanation processes in FWAD. Strategies of bioaugmentation technologies and bioreactors to enhance the removal were suggested. Perspectives were provided for a better understanding of the fates of reviewed contaminants and their elimination in FWAD systems.

Orbitrap mass spectrometry for the molecular characterization of water resource recovery from polluted surface water using membrane bioreactor

The increasing organic contamination of surface water hinders the conventional tap water treatment process. Membrane bioreactors (MBRs) are a promising alternative technology for recovering water from polluted surface water. In this study, the composition changes of dissolved organic matters (DOMs) in MBR and ultraviolet/ozone (UV/O₃)-MBR systems for polluted surface water treatment were investigated using Orbitrap mass spectrometry analysis with unknown screening. The intense DOM ions within a mass-to-charge ratio range of 100-500 was detected, and 2340 molecular formulae from 5743 peaks were assigned to the two systems. The most abundant components were formulae with C, H, O, N, and CHO only classes. The highest formulae decrease including CHO, CHON, CHOS, and CHONS were attributed to the bio-carrier used in both systems. Results showed that bioprocess was the main contributor in the DOM reduction, and the integration of UV/O₃ into the MBR improved the DOM composition changes. Biodegradable components with low O/C ratio in the CHO and CHON classes remarkably increased in the UV/O₃-MBR system. The integration of UV/O₃ as a polishing step in the recirculation stream of MBR system was effective in improve the DOM removal.

Insights into fouling behavior in a novel anammox self-forming dynamic membrane bioreactor by the fluorescence EEM-PARAFAC analysis

Fouling behavior of the novel anaerobic ammonium oxidation (anammox) self-forming dynamic membrane bioreactor (SFDMBR) was elucidated, which is using nylon mesh as the filter with controlled fouling and successful anammox process. Properties of anammox sludge and foulants in the anammox SFDMBR and MBR (using PVDF microfiltration membrane) were compared to analyze the alleviated fouling in the SFDMBR, of which transmembrane pressure could be kept below 10 kPa for 50 days in one filtration cycle of 82 days with flux of 12 L m^-2 h^-1. Colorimetrical determination and excitation emission matrices-parallel factor (EEM-PARAFAC) analysis of the foulants showed that humic acid content in foulants on nylon mesh was obviously lower than that on PVDF membrane. Considering that the small-sized and flexible humic acids prefer to plug into membrane pores, the alleviated irreversible fouling in the SFDMBR could be attributed to the less microbial humic acid content of foulants (8.8 ± 1.0%) compared with the MBR (20.7 ± 2.9%). The adequate efflux of humic-like substances in the operation with nylon mesh was speculated to be the main mechanism of fouling control in the SFDMBR. These findings highlighted the potential of anammox SFDMBR in practical applications, because of the high humic acid contents in real ammonium-laden wastewater. Our study highlights the important role of humic acids in fouling behavior of the novel anammox SFDMBR to provide guidance for fouling control strategies. Graphical abstract.

Activated sludge and other aerobic suspended culture processes

This paper provides an overview of activated sludge related to suspended growth processes for the year 2019. The review encompasses process modeling of activated sludge, microbiology of activated sludge, process kinetics and mechanism, nitrogen and phosphorus control, design, and operation in the activated sludge field. The fate and effect of xenobiotics in activated sludge, including trace organic contaminant and heavy metal xenobiotics, which had influence on the growth of suspended sludge, are covered in this review. Compared to past reviews, many topics show increase in activity in 2019. These include, biokinetics process of aerobic granular sludge formation, pyrolysis kinetic mechanism of granular sludge. These topics are referred to formation and disintegration of granular sludge. Other sections include activated sludge settling model, toxicity resistant microbial community, nitritation-anammox processes for nitrogen removal, and respirometry used in the operation of real wastewater treatment plant are especially highlighted in this review. PRACTITIONER POINTS: Biokinetics process of aerobic granular sludge formation Toxicity resistant microbial community in activated sludge Nitritation-anammox processes for nitrogen removal in activated sludge.

Membrane processes

This literature review provides a review for publications in 2018 and 2019 and includes information membrane processes findings for municipal and industrial applications. This review is a subsection of the annual Water Environment Federation literature review for Treatment Systems section. The following topics are covered in this literature review: industrial wastewater and membrane. Bioreactor (MBR) configuration, membrane fouling, design, reuse, nutrient removal, operation, anaerobic membrane systems, microconstituents removal, membrane technology advances, and modeling. Other sub-sections of the Treatment Systems section that might relate to this literature review include the following: Biological Fixed-Film Systems, Activated Sludge, and Other Aerobic Suspended Culture Processes, Anaerobic Processes, and Water Reclamation and Reuse. This publication might also have related information on membrane processes: Industrial Wastes, Hazardous Wastes, and Fate and Effects of Pollutants.