Combination of biobarcode assay with on-chip capillary electrophoresis for ultrasensitive and multiplex biological agent detection

Tb(iii)-doped nanosheets as a fluorescent probe for the detection of dipicolinic acid

A new fluorescent probe based on terbium(iii)-doped nanosheets was designed for detecting low-levels of dipicolinic acid (DPA), a biomarker of bacterial spores. The ability to detect ultra-low concentrations of DPA is therefore of great significance. First, Tb(iii)-doped ytterbium hydroxide nanosheets were obtained by mechanical exfoliation from layered rare-earth hydroxide (LRH) materials. The morphology of the as-synthesized nanosheets was studied by transmission electron microscopy and atomic force microscopy. The Tb(iii)-doped nanosheets are demonstrated to be highly sensitive to DPA, which remarkably enhances Tb(iii) luminescence intensities at a wavelength of 544 nm. Furthermore, Tb(iii) emission increases linearly with DPA concentration. Selectivity studies were conducted by adding different competing aromatic ligands to the sensing solution; however, their fluorescence responses were observed to be negligibly small in comparison with that of DPA. Our findings provide a basis for the application of Tb(iii)-doped nanosheets for accurate, sensitive, and selective monitoring of DPA as a biomarker of anthrax.

Barcoded point-of-care bioassays

Barcoded bioassays are ready to promote bioanalysis and biomedicine toward the point of care.

Sandwich NP-based biobarcode assay for quantification C-reactive protein in plasma samples

A NP-based biobarcode for C-reactive protein (CRP) quantification in plasma samples is reported for the first time. The assay uses capture antibody functionalized magnetic beads (pAbCRP2-MP), multifunctional oligonucleotide encoded probes modified with a detection antibody (pAbCRP1-ePSP), and a fluorescent DNA microarray. Thus, magnetic beads are added to the sample to form immunocomplexes that will be isolated, to then add the codified particles to form a sandwich complex with both particles and the target protein, subsequently the complexes are treated to release the oligonucleotide codes, which are finally hybridized in a fluorescent DNA microarray. The assay has been implemented to the analysis of plasma samples being able to quantify this biomarker within 900 ng mL^-1 to 12500 ng mL^-1 with an excellent accuracy (mean of recovery of 99.5 ± 4.2%, N = 3). The CRP biobarcode has been used on a small pilot clinical study in which plasma samples from patients suffering different pathologies, most of them related to cardiovascular diseases (CVDs). The samples have been analyzed and the results compared to a reference method demonstrating that the assay can be useful for monitoring this biomarker on patients being suspicious to be under risk of suffering CVDs or other diseases involving inflammatory processes.

Biobarcode assay for the oral anticoagulant acenocoumarol

A novel approach for therapeutic drug monitoring of oral anticoagulants (OA) in clinical samples is reported, based on a NP-based biobarcode assay. The proposed strategy uses specific antibodies for acenocumarol (ACL) covalently bound to magnetic particles (pAb236-MP) and a bioconjugate competitor (hACL-BSA) linked to encoded polystyrene probes (hACL-BSA-ePSP) on a classical competitive immunochemical format. By using this scheme ACL can be detected in low nM range (LOD, 0.96 ± 0.26, N = 3, in buffer) even in complex samples such as serum or plasma (LOD 4 ± 1). The assay shows a high reproducibility (%CV 1.1 day-to-day) and is robust, as it is demonstrated by the fact that ACL can be quantified in complex biological samples with a very good accuracy (slope = 0.97 and R² = 0.91, of the linear regression obtained when analyzing spiked vs measured values). Moreover, we have demonstrated that the biobarcode approach has the potential to overcome one of the main challenges of the multiplexed diagnostic, which is the possibility to measure in a single run biomarker targets present at different concentration ranges. Thus, it has been proven that the signal and the detectability can be modulated by just modifying the oligonucleotide load of the encoded probes. This fact opens the door for combining in the same assay encoded probes with the necessary oligonucleotide load to achieve the detectability required for each biomarker target.

Capillary electrophoresis based on nucleic acid detection for diagnosing human infectious disease

Rapid transmission, high morbidity, and mortality are the features of human infectious diseases caused by microorganisms, such as bacteria, fungi, and viruses. These diseases may lead within a short period of time to great personal and property losses, especially in regions where sanitation is poor. Thus, rapid diagnoses are vital for the prevention and therapeutic intervention of human infectious diseases. Several conventional methods are often used to diagnose infectious diseases, e.g. methods based on cultures or morphology, or biochemical tests based on metabonomics. Although traditional methods are considered gold standards and are used most frequently, they are laborious, time consuming, and tedious and cannot meet the demand for rapid diagnoses. Disease diagnosis using capillary electrophoresis methods has the advantages of high efficiency, high throughput, and high speed, and coupled with the different nucleic acid detection strategies overcomes the drawbacks of traditional identification methods, precluding many types of false positive and negative results. Therefore, this review focuses on the application of capillary electrophoresis based on nucleic detection to the diagnosis of human infectious diseases, and offers an introduction to the limitations, advantages, and future developments of this approach.

Rapid Identification and Characterization of Francisella by Molecular Biology and Other Techniques

Francisella tularensis is the causative pathogen of tularemia and a Tier 1 bioterror agent on the CDC list. Considering the fact that some subpopulation of the F. tularensis strains is more virulent, more significantly associated with mortality, and therefore poses more threat to humans, rapid identification and characterization of this subpopulation strains is of invaluable importance. This review summarizes the up-to-date developments of assays for mainly detecting and characterizing F. tularensis and a touch of caveats of some of the assays.

A fully integrated microdevice for biobarcode assay based biological agent detection

An integrated microdevice, consisting of a micropump, a passive mixer, a magnetic separation chamber, and a microcapillary electrophoretic channel, was constructed for biobarcode assay based multiplex biological agent detection in a sample-to-answer-out manner within 30 min with high sensitivity.