Novel, rapid, low-cost screen-printed (bio)sensors for the direct analysis of boar taint compounds androstenone and skatole in porcine adipose tissue: Comparison with a high-resolution gas chromatographic method

Comprehensive SPME-GC-MS Analysis of VOC Profiles Obtained Following High-Temperature Heating of Pork Back Fat with Varying Boar Taint Intensities

Boar taint detection is a major concern for the pork industry. Currently, this taint is mainly detected through a sensory evaluation. However, little is known about the entire volatile organic compounds (VOCs) profile perceived by the assessor. Additionally, many research groups are working on the development of new rapid and reliable detection methods, which include the VOCs sensor-based methods. The latter are susceptible to sensor poisoning by interfering molecules produced during high-temperature heating of fat. Analyzing the VOC profiles obtained by solid phase microextraction gas chromatography–mass spectrometry (SPME-GC-MS) after incubation at 150 and 180 °C helps in the comprehension of the environment in which boar taint is perceived. Many similarities were observed between these temperatures; both profiles were rich in carboxylic acids and aldehydes. Through a principal component analysis (PCA) and analyses of variance (ANOVAs), differences were highlighted. Aldehydes such as (E,E)-nona-2,4-dienal exhibited higher concentrations at 150 °C, while heating at 180 °C resulted in significantly higher concentrations in fatty acids, several amide derivatives, and squalene. These differences stress the need for standardized parameters for sensory evaluation. Lastly, skatole and androstenone, the main compounds involved in boar taint, were perceived in the headspace at these temperatures but remained low (below 1 ppm). Higher temperature should be investigated to increase headspace concentrations provided that rigorous analyses of total VOC profiles are performed.

Studies Towards the Development of a Novel, Screen-Printed Carbon-Based, Biosensor for the Measurement of Polyunsaturated Fatty Acids

This paper describes the design, development and characterisation of an electrochemical biosensor for the measurement of linoleic and α-linolenic acid, as representative free polyunsaturated fatty acids (PUFAs), that may be implicated in food safety and food quality. Initial cyclic voltammetric studies were performed with solutions that contained enzyme-generated hydroperoxides of the two PUFAs. These were examined with plain screen-printed carbon electrodes (SPCEs) and screen-printed carbon electrodes containing the electrocatalyst cobalt phthalocyanine (CoPC). The electrocatalytic oxidation peaks obtained with the latter occurred at potentials about 300 mV lower than the those obtained by direct oxidation with the plain SPCEs and were better defined; as these attributes would lead to better selectivity and sensitivity for fatty acid determinations, the CoPC-SPCEs were used in the fabrication of amperometric biosensors. The enzyme lipoxygenase (LOX) was immobilised on the surface of these devices using the crosslinking agent glutaraldehyde. These biosensors were optimised for the measurement of linoleic and α-linolenic acid using amperometry in stirred solution; the optimum conditions were deduced by studying the effect of enzyme loading, pH and temperature on the amperometric responses. These responses were examined over the concentration range 2.0 to 20 µM and the results indicated that the following conditions were optimal: LOX loading 15 units; pH 8.0; temperature 37 °C. Low concentration calibration studies were performed with the two PUFAs and it was shown that the steady state currents were linear between 0.2 and 10 µM for linoleic acid and 0.2 and 10 µM for α-linolenic acid; the detection limits were 24 and 100 nM, respectively. The precision (coefficient of variation, n = 6) was 5.3% for α-linoleic acid and 3.3% for linoleic acid, which were calculated from the steady state current following additions (n = 6) of 0.2 µM PUFA. These results demonstrate that the novel amperometric biosensor holds promise for determining whether foods contain acceptable levels of free fatty acids.

Feasibility of on/at Line Methods to Determine Boar Taint and Boar Taint Compounds: An Overview

Simple Summary

Due to welfare issues, the physical castration of male pigs is decreasing, and the entire male pig production is increasing. Fattening entire male pigs requires control due to the possibility of accumulating off odour/flavour called boar taint, which is mainly due to two compounds - skatole and androstenone. If carcasses with boar taint reach the market, it can cause a negative consumer reaction which may have economic consequences for the whole meat chain. Thus, it is necessary to sort out carcasses at the slaughter line. Today, a sensory quality control (human nose method) is used in some slaughter plants for this purpose. Detection by physical or chemical methods is also envisaged. A colorimetric method to determine skatole has been used in Danish abattoirs for decades, but it is foreseen that it will soon be replaced by the laser diode thermal desorption ion source coupled with a mass spectrometry equipment that allows a fully automated classification based on skatole and androstenone levels at speed line, with a delay of less than 40 min. Other potential methods such as the electrochemical biosensors, rapid evaporative ionization mass spectroscopy and Raman spectroscopy, still need further development and validation for an application at abattoir level.

Abstract

Classification of carcasses at the slaughter line allows an optimisation of its processing and differentiated payment to producers. Boar taint is a quality characteristic that is evaluated in some slaughter plants. This odour and flavour is mostly present in entire males and perceived generally by sensitive consumers as unpleasant. In the present work, the methodologies currently used in slaughter plants for boar taint classification (colorimetric method and sensory quality control-human nose) and the methodologies that have the potential to be implemented on/at the slaughter line (mass spectrometry, Raman and biosensors) have been summarized. Their main characteristics are presented and an analysis of strengths, weaknesses, opportunities and threats (SWOT) has been carried out. From this, we can conclude that, apart from human nose, the technology that arises as very promising and available on the market, and that will probably become a substitute for the colorimetric method, is the tandem between the laser diode thermal desorption ion source and the mass spectrometry (LDTD-MS/MS) with automation of the sampling and sample pre-treatment, because it is able to work at the slaughter line, is fast and robust, and measures both androstenone and skatole.