Non-BMD DXA measurements of the hip

Influence of Low-Intensity Pulsed Ultrasound Parameters on the Bone Mineral Density in Rat Model: A Systematic Review

OBJECTIVE

Bone recovery typically depends on the age of organisms or the prevalence of metabolic disorders such as osteoporosis, which is a metabolic condition characterized by decreased bone strength and bone mineral density (BMD). Therefore, low-intensity pulsed ultrasound (LIPUS), a non-invasive method for osteogenic stimulation, presents promising results. However, heterogeneity in animal study designs is a typical characteristic. Hence, we conducted a systematic review to evaluate the effectiveness of LIPUS in the recovery of experimental bone defects using rat models. We examined the areal and volumetric BMD to identify LIPUS doses to be applied and evaluated the accuracy reported by previous studies.

METHODS

The Virtual Health Library regional portal, PubMed, Embase, EBSCOhost, Scopus and CAPES were reviewed for animal studies that compared fracture treatments based on LIPUS with sham or no treatments using rat models and reported BMD as an outcome. The tool provided by the Systematic Review Centre for Laboratory Animal Experimentation (SYRCLE) and the Collaborative Approach to Meta-Analysis and Review of Animal Data from Experimental Studies (CAMARADES) checklist were used to assess the bias and quality of such studies.

RESULTS

Of the six studies reviewed, the most frequently used LIPUS dose had an ultrasonic frequency of 1.0 MHz, repetition rate of 0.1 kHz and pulse duration of 2000 μs. An intensity (ISATA) of 30 mW/cm2 was the most preferred for bone recovery. However, the BMD could not solely irrefutably evaluate the effectiveness of LIPUS in bone recovery as the results were discordant with each other. The discrepancies in experimental methodologies, low-quality classifications and high risk of bias in the selected studies, however, did not validate the undertaking of a meta-analysis.

CONCLUSION

On the basis of the BMD results, no sufficient evidence was found to recommend the use of LIPUS for bone recovery in rat models. Thus, this systematic review indicates that the accuracy of such reports must be improved to improve their scientific quality to facilitate a transition of LIPUS applications from pre-clinical research to clinic use.

Radiofrequency echographic multi-spectrometry for the in-vivo assessment of bone strength: state of the art-outcomes of an expert consensus meeting organized by the European Society for Clinical and Economic Aspects of Osteoporosis, Osteoarthritis and Musculoskeletal Diseases (ESCEO)

PURPOSE

The purpose of this paper was to review the available approaches for bone strength assessment, osteoporosis diagnosis and fracture risk prediction, and to provide insights into radiofrequency echographic multi spectrometry (REMS), a non-ionizing axial skeleton technique.

METHODS

A working group convened by the European Society for Clinical and Economic Aspects of Osteoporosis and Osteoarthritis met to review the current image-based methods for bone strength assessment and fracture risk estimation, and to discuss the clinical perspectives of REMS.

RESULTS

Areal bone mineral density (BMD) measured by dual-energy X-ray absorptiometry (DXA) is the consolidated indicator for osteoporosis diagnosis and fracture risk assessment. A more reliable fracture risk estimation would actually require an improved assessment of bone strength, integrating also bone quality information. Several different approaches have been proposed, including additional DXA-based parameters, quantitative computed tomography, and quantitative ultrasound. Although each of them showed a somewhat improved clinical performance, none satisfied all the requirements for a widespread routine employment, which was typically hindered by unclear clinical usefulness, radiation doses, limited accessibility, or inapplicability to spine and hip, therefore leaving several clinical needs still unmet. REMS is a clinically available technology for osteoporosis diagnosis and fracture risk assessment through the estimation of BMD on the axial skeleton reference sites. Its automatic processing of unfiltered ultrasound signals provides accurate BMD values in view of fracture risk assessment.

CONCLUSIONS

New approaches for improved bone strength and fracture risk estimations are needed for a better management of osteoporotic patients. In this context, REMS represents a valuable approach for osteoporosis diagnosis and fracture risk prediction.

DXA evaluation of femoral bone mineral density and cortical width in patients with prior total knee arthroplasty

Periprosthetic fractures after total knee arthroplasty (TKA) have devastating consequences. Osteoporosis increases periprosthetic fracture risk, but distal femur bone mineral density (BMD) is not measured post-TKA. This study measured distal femur BMD and cortical width; both were lower in the TKA compared to the non-operated leg. BMD measurement reproducibility was good. Standardized DXA regions of interest are proposed.

INTRODUCTION

Periprosthetic fractures following total knee arthroplasty (TKA) are not rare. We hypothesized that TKA is associated with low BMD, potentially increasing periprosthetic fracture risk. However, distal femur dual energy x-ray (DXA) measurement is virtually never performed after TKA due to lack of standardized approaches. Thus, this study's aims were to develop standard DXA femur regions of interest (ROIs), assess cortical width, and determine measurement reproducibility in TKA patients.

METHODS

Thirty adults (15 M/15 F) age 59-80 years with unilateral, primary TKA within 2-5 years had femoral DXA scans performed in duplicate using a Lunar iDXA densitometer. In prior work, we established that femur BMD was lowest in the distal metaphysis and highest in mid-shaft. Thus, BMD and cortical width were measured at 15%, 25%, and 60% of the femur length measured from the distal notch. Femur BMD and cortical width were compared between limbs (TKA vs. non-operated side) by paired t test.

RESULTS

BMD was 3.2-9.9% lower (p < 0.001) in the operated femur at all custom ROIs; substantial between individual differences existed with some up to 30% lower. Cortical width was lower (p < 0.05) at the 25% ROI on the TKA side. BMD reproducibility was excellent; CV 0.85-1.33%.

CONCLUSIONS

Distal femur BMD can be reproducibly measured using DXA and is ~ 10% lower on the TKA leg. Similarly, medial and lateral cortices are thinner at the 25% ROI. These bone changes likely increase periprosthetic fracture risk. Further work to define and mitigate periprosthetic fracture risk after TKA is needed.

European guidance for the diagnosis and management of osteoporosis in postmenopausal women

Guidance is provided in a European setting on the assessment and treatment of postmenopausal women at risk from fractures due to osteoporosis.

INTRODUCTION

The International Osteoporosis Foundation and European Society for Clinical and Economic Aspects of Osteoporosis and Osteoarthritis published guidance for the diagnosis and management of osteoporosis in 2013. This manuscript updates these in a European setting.

METHODS

Systematic reviews were updated.

RESULTS

The following areas are reviewed: the role of bone mineral density measurement for the diagnosis of osteoporosis and assessment of fracture risk; general and pharmacological management of osteoporosis; monitoring of treatment; assessment of fracture risk; case-finding strategies; investigation of patients; health economics of treatment. The update includes new information on the evaluation of bone microstructure evaluation in facture risk assessment, the role of FRAX® and Fracture Liaison Services in secondary fracture prevention, long-term effects on fracture risk of dietary intakes, and increased fracture risk on stopping drug treatment.

CONCLUSIONS

A platform is provided on which specific guidelines can be developed for national use.

Long-term effect of testosterone replacement therapy on bone in hypogonadal men with Klinefelter Syndrome

PURPOSE

To assess different aspects of bone damage in untreated adult patients with Klinefelter Syndrome (KS) before and during testosterone replacement therapy (TRT).

METHODS

Fifteen untreated hypogonadal men with KS and 26 control subjects (C) matched for age and BMI were recruited. Sex hormone levels were measured in all subjects. Lumbar spine (LS) and femoral (neck: FN and total hip: TH) bone mineral density (BMD), trabecular bone score (TBS), hip structure analysis (HSA) and fat measures (percentage of fat mass, android/gynoid ratio and visceral adipose tissue) were evaluated by DEXA. In KS patients, blood analysis and DEXA measurements were assessed at baseline and repeated yearly for three years during TRT.

RESULTS

Fat measures were significantly higher in KS than C (p < 0.01). In contrast, mean LS, FN and TH BMD were significantly reduced in KS compared to C (p < 0.01), while there was no difference in TBS. HSA revealed a significantly lower cortical thickness and significantly higher buckling ratio in KS compared to C at all femoral sites (p < 0.01). In KS patients, TRT significantly increased BMD at LS only, but did not improve TBS and HSA parameters. Fat measures were inversely associated with TBS values, and TRT did not influence this relationship.

CONCLUSIONS

In untreated hypogonadal men with KS, lumbar and femoral BMD was reduced, and femoral bone quality was impaired. Adiposity seemed to have a detrimental effect on lumbar bone microarchitecture, as indirectly evaluated by TBS. However, TRT failed to remedy these negative effects on bone.

Comparison of femoral strength and fracture risk index derived from DXA-based finite element analysis for stratifying hip fracture risk: A cross-sectional study

BACKGROUND

Dual-energy X-ray absorptiometry (DXA)-based finite element analysis (FEA) has been studied for assessment of hip fracture risk. Femoral strength (FS) is the maximum force that the femur can sustain before its weakest region reaches the yielding limit. Fracture risk index (FRI), which also considers subject-specific impact force, is defined as the ratio of von Mises stress induced by a sideways fall to the bone yield stress over the proximal femur. We compared risk stratification for prior hip fracture using FS and FRI derived from DXA-based FEA.

METHODS

The study cohort included women aged ≥65years undergoing baseline hip DXA, with femoral neck T-scores <-1 and no osteoporosis treatment; 324 cases had prior hip fracture and 655 controls had no prior fracture. Using anonymized DXA hip scans, we measured FS and FRI. Separate multivariable logistic regression models were used to estimate odds ratios (ORs), c-statistics and their 95% confidence intervals (95% CIs) for the association of hip fracture with FS and FRI.

RESULTS

Increased hip fracture risk was associated with lower FS (OR per SD 1.36, 95% CI: 1.15, 1.62) and higher FRI (OR per SD 1.99, 95% CI: 1.63, 2.43) after adjusting for Fracture Risk Assessment Tool (FRAX) hip fracture probability computed with bone mineral density (BMD). The c-statistic for the model containing FS (0.69; 95% CI: 0.65, 0.72) was lower than the c-statistic for the model with FRI (0.77; 95% CI: 0.74, 0.80) or femoral neck BMD (0.74; 95% CI: 0.71, 0.77; all P<0.05).

CONCLUSIONS

FS and FRI were independently associated with hip fracture, but there were differences in performance characteristics.