Robust LPV control design for blood glucose regulation considering daily life factors

Analysis of the performances of various controllers adopted in the biomedical field for blood glucose regulation: a case study of the type-1 diabetes

Diabetes remains a critical global health concern that necessitates urgent attention. The contemporary clinical approach to closed-loop care, specifically tailored for insulin-dependent patients, aims to precisely monitor blood glucose levels while mitigating the risks of hyperglycaemia and hypoglycaemia due to erroneous insulin dosing. This study seeks to address this life-threatening issue by assessing and comparing the performance of different controllers to achieve quicker settling and convergence rates with reduced steady-state errors, particularly in scenarios involving meal interruptions. The methodology involves the detection of plasma blood glucose levels, delivery of precise insulin doses to the actuator through a control architecture, and subsequent administration of the calculated insulin dosage to patients based on the control signal. Glucose-insulin dynamics were modelled using kinetics and mass balance equations from the Bergman minimal model. The simulation results revealed that the PID controller exhibited superior performance, maintaining blood glucose concentration around the preferred threshold ∼98.8% of the time, with a standard deviation of 2.50. This was followed by RST with a success rate of 98.5% and standard deviation of 5.00, SPC with a success rate of 58% and standard deviation of 2.99, SFC with a success rate of 55% and standard deviation of 10.08, and finally LCFB with a rate of 10% and significantly higher standard deviation of 64.55.

Hardware design for blood glucose control based on the Sorensen diabetic patient model using a robust evolving cloud-based controller

Diabetes Mellitus (DM) is the most hazardous public health challenge requiring engineering study to prevent disease complications. In this paper, a Sorensen-based diabetic model is presented in which the insulin-glucose process of a Type 1 patient is maintained by considering other factors such as physical characteristics and changes in mental aspects of the diabetic patient. The purpose of the research is to include a non-linear model of a patient with diabetes who is affected by stress, meals, exercise, and Insulin Sensitivity (IS), and a suitable RECCo controller is designed as a notable recent innovation that implements the concept of ANYA fuzzy rule-based system, which is an online adaptive type of controller that is used in this research work with an uncertainty case of the condition, where the blood glucose must be regulated. To ensure the performance of the proposed controller, a simple insulin pump is designed in a practical case, and a hardware experiment is conducted. The result of the hardware is analyzed and shows the success of the implementation of the controller in blood glucose regulation, thereby preventing complications such as hypoglycemia and hyperglycemia. The comparison analysis of RECCo was performed with other types of controllers, such as MPC and MRAC. The accuracy of the model was validated using the N-BEATS algorithm with a data-set collected from the simulated model, which is around 98%.

Robust nonlinear control of blood glucose in diabetic patients subject to model uncertainties

Recent advances in the artificial pancreas system provide an emerging treatment option for type 1 diabetes. The performance of the blood glucose regulation directly relies on the accuracy of the glucose-insulin modeling. Sorenson model involves the behavior of different organs and offers precise representation. However, the high complexity of such a model makes the controller design procedure a hard task. Therefore, the high-order nonlinear Sorensen model as a popular high-fidelity physiological model is opted in this paper to analyze the glucose-insulin interactions in great detail, and a new robust nonlinear approach to regulate the blood glucose concentration (BGC) in Type-I diabetic patients is proposed. Inspiring the backstepping technique, for designing an acceptable controller, the model is divided into three main subsystems such that in each subsystem, the virtual control input laws are obtained using both Lyapunov stability and input-to-state theorems. Since the measurement of the parameters in the glucose-insulin system is not accurate, parametric uncertainties are defined in the investigated model. Furthermore, owing to the fact that the only measurable state variable is blood glucose, the estimation of inaccessible state variables is an important issue that is properly considered by the unscented Kalman filter (UKF) estimator. The suggested approach is compared to H_∞, robust H_∞, and linear parameter-varying control approaches. The comparison results on 500 simulated patients imply a remarkable superiority of the proposed controller approach to the compared methods in terms of the BGC tracking and the algorithm robustness in the presence of food intake disturbance patterns.

An Intelligent Model-Based Effective Approach for Glycemic Control in Type-1 Diabetes

Type-1 diabetes mellitus (T1DM) is a challenging disorder which essentially involves regulation of the glucose levels to avoid hyperglycemia as well as hypoglycemia. For this purpose, this research paper proposes and develops control algorithms using an intelligent predictive control model, which is based on a UVA/Padova metabolic simulator. The primary objective of the designed control laws is to provide an automatic blood glucose control in insulin-dependent patients so as to improve their life quality and to reduce the need of an extremely demanding self-management plan. Various linear and nonlinear control algorithms have been explored and implemented on the estimated model. Linear techniques include the Proportional Integral Derivative (PID) and Linear Quadratic Regulator (LQR), and nonlinear control strategy includes the Sliding Mode Control (SMC), which are implemented in this research work for continuous monitoring of glucose levels. Performance comparison based on simulation results demonstrated that SMC proved to be most efficient in terms of regulating glucose profile to a reference level of 70 mg/dL compared to the classical linear techniques. A brief comparison is presented between the linear techniques (PID and LQR), and nonlinear technique (SMC) for analysis purposes proving the efficacy of the design.

Automatic Artificial Pancreas Systems Using an Intelligent Multiple-Model PID Strategy

In this paper, an individualized intelligent multiple-model technique is proposed to design automatic artificial pancreas (AP) systems for the glycemic regulation of type 1 diabetic patients. At first, using the multiple-model concept, the insulin-glucose regulatory system is mathematically identified by constructing some local models. In this step, trade-offs between the number of local models and the complexity of the overall closed-loop system are made by defining and solving a bi-objective optimization problem. Then, optimal AP systems are designed by tuning a bank of proportionalintegralderivative (PID) controllers via the genetic algorithm (GA). A fuzzy gain scheduling strategy is employed to determine the participation percentages of the PID controllers in the control action. Finally, two safety mechanisms, called insulin on board (IOB) constraint and pump shut-off, are installed in the AP systems to enhance their performance. To assess the proposed AP systems, in silico experiments are performed on virtual patients of the UVA/Padova metabolic simulator. The obtained results reveal that the proposed intelligent multiple-model methodology leads to AP systems with limited hyperglycemia and no severe hypoglycemia.