Study of the composition of ternary mixed oxides: Use of these materials on a hydrogen production process

Transition Metal-Promoted Mg-Fe Mixed Oxides for Conversion of Ethanol to Valuable Products

The conversion of ethanol into petrochemicals, such as ethyl and butyl acetate, butanol, hexanol, and so forth was studied. The conversion was catalyzed by Mg-Fe mixed oxide modified with a second transition metal (Ni, Cu, Co, Mn, or Cr). The main aim was to describe the influence of second transition metal on (i) the catalyst itself and (ii) reaction products such as ethyl acetate, butanol, hexanol, acetone, and ethanal. Moreover, the results were compared with the results of pure Mg-Fe. The reaction was carried out in the gas phase in a flow reactor with a weight hour space velocity of 4.5 h^-1 for 32 h at three reaction temperatures (280, 300, and 350 °C). The metals Ni and Cu in Mg-Fe oxide enhanced the ethanol conversion due to the population of active dehydrogenation sites. Despite the lower acido-basicity, Cu, Co, and Ni supported the yield of ethyl acetate, and Cu and Ni also promoted the yield of higher alcohols. Ni was related to the extent of the gasification reactions. Moreover, long-term stability (by leaching of metals) test was carried out for all catalysts (128 h).

Investigation of Structural and Luminescent Properties of Sol-Gel-Derived Cr‑Substituted Mg3Al1-xCrx Layered Double Hydroxides

In the present work, Cr-substituted Mg₃Al_1−xCr_x layered double hydroxides (LDHs) were synthesised through the phase conversion of sol-gel-derived mixed-metal oxides in an aqueous medium. The chromium substitution level in the range of 1 to 25 mol% was investigated. It was demonstrated that all synthesised specimens were single-phase LDHs. The results of elemental analysis confirmed that the suggested synthetic sol-gel chemistry approach is suitable for the preparation of LDHs with a highly controllable chemical composition. The surface microstructure of sol-gel-derived Mg₃Al_1−xCr_x LDHs does not depend on the chromium substitution level. The formation of plate-like agglomerated particles, which consist of hexagonally shaped nanocrystallites varying in size from approximately 200 to 300 nm, was observed. Optical properties of the synthesised Mg₃Al_1−xCr_x LDHs were investigated by means of photoluminescence. All Cr-containing powders exhibited characteristic emission in the red region of the visible spectrum. The strongest emission was observed for the sample doped with 5 mol% Cr³⁺ ions. However, the emission intensity of samples doped with 1–10 mol% Cr³⁺ ions was relatively similar. A further increase in the Cr³⁺ ion concentration to 25 mol% resulted in severe concentration quenching.

Multifunctional Pd/Ni-Co catalyst for hydrogen production by chemical looping coupled with steam reforming of acetic acid

High yield of high-purity H2 from acetic acid, a model compound of bio-oil obtained from the fast pyrolysis of biomass, was produced by sorption-enhanced steam reforming (SESR). An oxygen carrier was introduced into a chemical loop (CL) coupled to the cyclical SESR process to supply heat in situ for the endothermic sorbent regeneration to increase the energy efficiency of the process. A new multifunctional 1 %Pd/20 %Ni-20 %Co catalyst was developed for use both as oxygen carrier in the CL and as reforming catalyst in the SESR whereas a CaO-based material was used as CO2 sorbent. In the sorbent-air regeneration step, the Ni-Co atoms in the catalyst undergo strong exothermic oxidation reactions that provide heat for the CaO decarbonation. The addition of Pd to the Ni-Co catalyst makes the catalyst active throughout the whole SESR-CL cycle. Pd significantly promotes the reduction of Ni-Co oxides to metallic Ni-Co during the reforming stage, which avoids the need for a reduction step after regeneration. H2 yield above 90 % and H2 purity above 99.2 vol % were obtained.