Reactivity of perovskite-type precursor in MWCNTs synthesis

Ni nanoparticles supported on Al2O3 + La2O3 yolk-shell catalyst for photo-assisted thermal decomposition of methane

Catalytic methane decomposition (CMD) has emerged as an appealing technology for large-scale production of H₂ and carbon nanostructures from natural gas. As the CMD process is mildly endothermic, the application of concentrated renewable energy sources such as solar energy under a low-temperature regime could potentially represent a promising approach towards CMD process operation. Herein, Ni/Al₂O₃-La₂O₃ yolk-shell catalysts are fabricated using a straightforward single-step hydrothermal approach and tested for their performance in photothermal CMD. We show that the morphology of the resulting materials, dispersion and reducibility of Ni nanoparticles, and nature of metal-support interactions can be tuned by addition of varying amounts of La. Notably, the addition of an optimal amount of La (Ni/Al-20La) improved the H₂ yield and catalyst stability relative to the base Ni/Al₂O₃ material, while also favoring base growth of carbon nanofibers. Additionally, we show for the first time a photothermal effect in CMD, whereby the introduction of 3 suns light irradiation at a constant bulk temperature of 500 °C reversibly increased the H₂ yield of catalyst by about 1.2 times relative to the rate in the dark, accompanied by a decrease in apparent activation energy from 41.6 kJ mol^-1 to 32.5 kJ mol^-1. The light irradiation further suppressed undesirable CO co-production at low temperatures. Our work reveals photothermal catalysis as a promising route for CMD while providing an insightful understanding of the roles of modifier in enriching methane activation sites on Al₂O₃-based catalysts.

Effect of the Calcination Temperature of LaNiO3 on the Structural Properties and Reaction Performance of Catalysts in the Steam Reforming of Methane

The steam reforming of methane (SRM) reaction is a significant process for efficient syngas generation and for promising distributed hydrogen production. In this work, a series of LaNiO3 oxides were prepared using the Pechini method, calcined from 600 °C to 900 °C and tested for the SRM reaction. Fresh, reduced, and used samples were characterized using STA-MS-FTIR, in situ and ex situ XRD, N2 physical adsorption, H2-TPR, TEM, TPO, and Raman. The results show that LaNiO3 begins to crystallize at about 550 °C, and the increase in calcination temperature results in the following differences in the properties of the LaNiO3 samples: larger LaNiO3 grains, smaller specific surface area, higher reduction temperature, smaller Ni0 grains reduced from the bulk phase, and stronger metal–support interaction. The maximum CH4 conversion could be achieved over LaNiO3 calcinated at 800 °C. In addition, the effect of steam-to-carbon ratio (S/C) on the performance of the SRM reaction was studied, and a S/C of 1.5 was found to be optimal for CH4 conversion. Too strong a metal–support interaction and too much unreacted steam causes a loss of catalytic activity. Finally, it was also proved using TPO and Raman that an increase in calcination temperature improves the carbon deposition resistance of the catalyst.