Acid-catalyzed mechanocatalytic pretreatment to improve sugar release from birch sawdust: Structural and chemical aspects

Semi-continuous hydrothermal processing of pine sawdust for integrated production of fuels precursors and platform chemicals

This research reports data for the integrated obtaining of fermentable sugars (FSs), bio-oil (BO), and hydro-char (HC) - all fuel precursors - as well as platform chemicals (PCs - acetic, formic, and levulinic acid, besides furfural, and hydroxymethylfurfural) through semi-continuous hydrothermal processing of sawdust from pine wood. The influence of temperature (260, 300, and 340 °C) and the water-to-biomass ratio (25 and 50 g H2O (g biomass)-1) were the parameters considered to evaluate the mass yields, kinetic profiles, and BO properties. For FSs (and PCs), a detailed analysis considering the kinetic profiles of obtaining cellobiose, glucose, xylose, and arabinose is presented. For the conditions evaluated, a distinct behavior concerning the process parameters was observed, where 7.11 and 9.28 g (100 g biomass)-1 of FSs and PCs were synergistically obtained, respectively, after 30 min, 20 MPa, 260 °C, and 50 g H2O (g biomass)-1. Contextually, 17.59 g (100 g biomass)-1 of BO was obtained at 340 °C and the same water/biomass ratio. FTIR analysis of the BO samples suggested the presence of aldehydes, carboxylic acids, ketones, hydrocarbons, ethers as well as aromatic, alcohols, and nitrogenous compounds. Similar HC yields were achieved among the conditions analyzed, where 24.68 g (100 g biomass)-1 were obtained at 340 °C and 50 g H2O (g biomass)-1 for a higher heating value of 29.14 MJ kg-1 (1.5 times higher than the in natura biomass).

Combined conversion of lignocellulosic biomass into high-value products with ultrasonic cavitation and photocatalytic produced reactive oxygen species - A review

The production of high-value products from lignocellulosic biomass is carried out through the selective scission of crosslinked CC/CO bonds. Nowadays, several techniques are applied to optimize biomass conversion into desired products with high yields. Photocatalytic technology has been proven to be a valuable tool for valorizing biomass at mild conditions. The photoproduced reactive oxygen species (ROSs) can initiate the scission of crosslinked bonds and form radical intermediates. However, the low mass transfer of the photocatalytic process could limit the production of a high yield of products. The incorporation of ultrasonic cavitation in the photocatalytic system provides an exceptional condition to boost the fragmentation and transformation of biomass into the desired products within a lesser reaction time. This review critically discusses the main factors governing the application of photocatalysis for biomass valorization and tricks to boost the selectivity for enhancing the yield of desired products. Synergistic effects obtained through the combination of sonolysis and photocatalysis were discussed in depth. Under ultrasonic vibration, hot spots could be produced on the surface of the photocatalysts, improving the mass transfer through the jet phenomenon. In addition, shock waves can assist the dissolution and mixing of biomass particles.