Investigation of the photocatalytic transformation of acesulfame K in the presence of different TiO2-based materials

Development and application of high resolution mass spectrometry analytical method to study and identify the photoinduced transformation products of environmental pollutants

Terpenes are among the major causes of pleasant or unpleasant odors close to active or inactive landfills. We studied R-limonene and p-cymene environmental degradation products using the heterogeneous photocatalysis mediated by titanium dioxide to explore the odor pollution. The aim of the study was the development of mass spectrometry based methods both hyphenated with GC and HPLC to identify and characterize transformation products (TPs) derived from photodegradation of R-limonene and p-cymene. With the GC-MS method we identified three TPs for R-limonene and two for p-cymene comparing the obtained mass spectra with those in the NIST library. While with HPLC-MS method, thanks to the use of the high resolution of MS tool, we recognized four and five TPs for R-limonene and p-cymene respectively. No p-cymene was detected as R-limonene transformation product. The methods developed were then applied to real environmental samples coming from landfills active (Lan1) or inactive (Lan2 and Lan3) located in northern Italy. R-limonene was detected in the active landfill (Lan1 at the concentration of 2.35 μg/mL) together with one of its TPs and one TP derived from p-cymene. p-Cymene was detected in the other two inactive landfills (Lan2 and Lan3 concentrations 0.025 and 0.15 μg/mL, respectively) together with one of its TP and two TPs coming from R-limonene photodegradation. The finding of TPs together with R-limonene and p-cymene both in active and inactive landfills point out the attention on the reduction of these molecules in the environment to reduce pollution and human risks.

Acesulfame K Photodegradation over Nitrogen-Doped TiO2

Acesulfame K is a zero-calorie alternative to sugar used worldwide. There is contradictory information on the toxicity of the compound, but its accumulation in the aquatic environment is undeniable. In this study, one-pot sol-gel synthesis was used to obtain nitrogen-doped TiO2 photocatalysts. Doping up to 6.29 wt % of nitrogen caused an increase in the surface area of the catalysts (48.55–58.23 m2∙g−1) and a reduction of the pHPZC value (5.72–5.05). Acesulfame K photodegradation was tested at the initial concentration of 20–100 ppm and the catalyst concentration at the level of 1 g∙L−1. Compared to the pure anatase, 4.83–6.29 wt % nitrogen-doped TiO2 showed an effective photodegradation of Acesulfame K. Ninety percent molecule removal was obtained after ~100 min, ~90 min, and ~80 min for initial concentrations of 20 ppm, 50 ppm, and 100 ppm, respectively. The increased activity of the catalysts is due to the modification of the TiO2 lattice structure and probably the limitation of the photogenerated electron/hole charge carrier recombination. It was shown that the electrostatic interactions between Acesulfame K and the catalyst surface play an important role in the photodegradation efficiency.

Photocatalytic abatement of emerging pollutants in pure water and wastewater effluent by TiO2 and Ce-ZnO: degradation kinetics and assessment of transformation products

A good removal efficiency was obtained for a mixture of seven emerging contaminants in wastewater effluent using two catalysts, Ce-ZnO and TiO₂-SG, as evidenced by the formation of several transient transformation products.