NH2-CuO-MCM-41 covalently cross-linked multipurpose membrane for applications in water treatment: Removal of hazardous pollutants from water, water desalination and anti-biofouling performance

Removal of pharmaceutically active compounds from water sources using nanofiltration and reverse osmosis membranes: Comparison of removal efficiencies and in-depth analysis of rejection mechanisms

Trace organic compounds from effluent streams are not completely removed by conventional purification techniques and hence, contaminating groundwater sources. Herein, we report the removal efficiency and rejection mechanisms of three common pharmaceutically active compounds (PhACs); caffeine (CFN), omeprazole (OMZ), and sulfamethoxazole (SMX), using commercial nanofiltration (NF) and reverse osmosis (RO) membranes with different surface characteristics. The RO membranes showed near-complete removal of all PhACs with rejection rates >99%. On the other hand, retention capabilities for the NF membranes varied and were influenced by the characteristics of the PhACs, membranes, and the feed solution. In general, during long-term testing, the rejection did not show much variation and followed a trend compatible with the size exclusion (steric hindrance) mechanism. When a real matrix was used, the rejection of CFN by the more tight NF membranes, HL TFC and NFW decreased by ∼10%, whereas the removal of SMX by the loose NF membrane, XN45, increased by the same ratio. In short-term testing, the rejection of negatively charged SMX increased significantly (∼20-40%) at a higher pH of ∼8 and in the presence of salts. Fouling by the PhACs was more severe on the high-flux NF membranes, HL TFC and XN45, as witnessed by the significant change in Contact angle (CA) values (∼25-50°) as well as the flux decline (∼15%) during long-term testing. To summarize, the removal of PhACs by membranes is a complex phenomenon and depends upon a combination of several factors.

Decoration of β-Cyclodextrin and Tuning Active Layer Chemistry Leading to Nanofiltration Membranes for Desalination and Wastewater Decontamination

Given the huge potential of thin film composite (TFC) nanofiltration (NF) membranes for desalination and micro-pollutant removal, two different sets of six NF membranes were synthesized. The molecular structure of the polyamide active layer was tuned by using two different cross-linkers, terephthaloyl chloride (TPC) and trimesoyl chloride (TMC), reacted with tetra-amine solution containing β-Cyclodextrin (BCD). To further tune the structure of the active layers, the time duration of interfacial polymerization (IP) was varied from 1 to 3 min. The membranes were characterized by scanning electron microscopy (SEM), atomic force microscopy (AFM), water contact angle (WCA), attenuated total reflectance Fourier transform infra-red (ATR-FTIR) spectroscopy, elemental mapping and energy dispersive (EDX) analysis. The six fabricated membranes were tested for their ability to reject divalent and monovalent ions followed by rejection of micro-pollutants (pharmaceuticals). Consequently, terephthaloyl chloride turned out to be the most effective crosslinker for the fabrication of membrane active layer with tetra-amine in the presence of β-Cyclodextrin using interfacial polymerization reaction for 1 min. The membrane fabricated using TPC crosslinker (BCD-TA-TPC@PSf) showed higher % rejection for divalent ions (Na₂SO₄ = 93%; MgSO₄ = 92%; MgCl₂ = 91%; CaCl₂ = 84%) and micro-pollutants (Caffeine = 88%; Sulfamethoxazole = 90%; Amitriptyline HCl = 92%; Loperamide HCl = 94%) compared to the membrane fabricated using TMC crosslinker (BCD-TA-TMC@PSf). For the BCD-TA-TPC@PSf membrane, the flux was increased from 8 LMH (L/m².h) to 36 LMH as the transmembrane pressure was increased from 5 bar to 25 bar.