Membrane crystallization: Engineering the crystallization via microscale interfacial technology

Environmentally Friendly Photothermal Membranes for Halite Recovery from Reverse Osmosis Brine via Solar-Driven Membrane Crystallization

Modern society and industrial development rely heavily on the availability of freshwater and minerals. Seawater reverse osmosis (SWRO) has been widely adopted for freshwater supply, although many questions have arisen about its environmental sustainability owing to the disposal of hypersaline rejected solutions (brine). This scenario has accelerated significant developments towards the hybridization of SWRO with membrane distillation-crystallization (MD-MCr), which can extract water and minerals from spent brine. Nevertheless, the substantial specific energy consumption associated with MD-MCr remains a significant limitation. In this work, energy harvesting was secured from renewables by hotspots embodied in the membranes, implementing the revolutionary approach of brine mining via photothermal membrane crystallization (PhMCr). This method employs self-heating nanostructured interfaces under solar radiation to enhance water evaporation, creating a carefully controlled supersaturated environment responsible for the extraction of minerals. Photothermal mixed matrix photothermal membranes (MMMs) were developed by incorporating graphene oxide (GO) or carbon black (CB) into polyvinylidene fluoride (PVDF) solubilized in an eco-friendly solvent (i.e., triethyl phosphate (TEP)). MMMs were prepared using non-solvent-induced phase separation (NIPS). The effect of GO or GB on the morphology of MMMs and the photothermal behavior was examined. Light-to-heat conversion was used in PhMCr experiments to facilitate the evaporation of water from the SWRO brine to supersaturation, leading to sodium chloride (NaCl) nucleation and crystallization. Overall, the results indicate exciting perspectives of PhMCr in brine valorization for a sustainable desalination industry.

Processing tactics for low-cost production of pure nuciferine from lotus leaf

Nuciferine is an important drug candidate for the treatment of many diseases. However, there is no general method for its low - cost production. In this work, a feasible method for the production of nuciferine from lotus leaf, using ultrasonic-assisted extraction-solid phase extraction (UAE-SPE) as extraction and cleanup procedure, was developed. Petroleum ether and silica gel have been successfully used as extraction solvent and adsorbent to integrate UAE with SPE, respectively. Except for filtration, no treatment (e.g. concentration and redissolution, etc) was needed on UAE extract before SPE and the effluents obtained in the loading process of SPE could be used as UAE extraction solvent without purification. No obvious decline in the extraction efficiency of UAE and adsorption capacity of SPE was observed at least for 5 runs, which provides a feasible way for the continuous production of nuciferine in industry, i.e. Cyclic UAE-SPE. Moreover, SPE column could be conveniently regenerated and reused without significant decline in its adsorption capacity at least for 5 cycles, which can be used to reduce the cost of the whole system further. In comparison with other cleanup procedures, Cyclic UAE-SPE showed apparent advantages in energy conservation and emission reduction. LLE and crystallization were applied to separate nuciferine from other impurities further. Under optimum conditions, the total recovery rate of nuciferine with a purity over 90.0% from lotus leaf reached 50.1%. All in all, the developed method has advantages in convenient operation, low cost, and high efficiency, thus, is fitting for the production of high purity nuciferine.