Evaluation of strong cation-exchange polymers for the determination of drugs by solid-phase extraction–liquid chromatography–tandem mass spectrometry

Preparation of amine-modified amphiphilic resins for the extraction of trace pharmaceuticals and personal care products in environmental waters

Herein, four amine-modified amphiphilic resins were synthesized and utilized as solid-phase extraction (SPE) materials to enrich pharmaceuticals and personal care products (PPCPs) from environmental water. The obtained materials (Strong anion-exchange amphiphilic materials, SAAMs; Weak anion-exchange amphiphilic materials, WAAMs) possessed large specific surface area (473-626 m²/g), high ion exchange capacity (0.89-1.97 mmol/g), and small contact angle (74.41-79.74°), indicating good hydrophilicity. The main factors affecting the efficiency of the extraction process were studied, including column volume, column flow rate, sample salinity and sample pH. Notably, the trend observed in absolute recovery was significantly correlated with the Zeta potential of the employed adsorbents. Furthermore, based on the obtained materials, a method of SPE coupled with ultra-performance liquid chromatography and tandem mass spectrometry (SPE/LC-MS/MS) was developed, and then utilized to determine PPCPs in the samples collected from the Yangtze River Delta. The Method detection limit (MDL) and Method quantification limit (MQL) ranged from 0.05 to 0.60 ng/L and 0.17 to 2.00 ng/L, respectively, with a relative standard deviation (RSD) below 6.3%, demonstrating good accuracy and sensitivity. As evidenced by comparison with previous literature, the developed method exhibited satisfactory performance, showing great potential for further commercial application in the extraction of trace PPCPs from environmental water samples.

Hypercrosslinked polymer microspheres decorated with anion- and cation-exchange groups for the simultaneous solid-phase extraction of acidic and basic analytes from environmental waters

Mixed-mode ion-exchange sorbents were introduced to improve the selectivity and retention of solid-phase extraction (SPE) sorbents. Mixed-mode ion-exchange sorbents integrate reversed-phase chemistry with ion-exchange groups to promote favourable interactions with ionic species. Nevertheless, a need to extract analytes with acidic and basic properties simultaneously within the same SPE cartridge led to the introduction of novel amphoteric/zwitterionic sorbents, which incorporate cation- and anion-exchange moieties within the same functional group attached to the polymeric network. In the present study, the development, preparation and SPE evaluation of two novel hypercrosslinked zwitterionic polymeric sorbents, functionalised with either strong anion-exchange (SAX) and weak cation-exchange (WCX) or weak anion-exchange (WAX) and strong cation-exchange (SCX) groups (namely HXLPP-SAX/WCX and the HXLPP-WAX/SCX), is presented for the simultaneous retention of acidic and basic compounds. The sorbents were prepared by a precipitation polymerisation route which yielded poly(divinylbenzene-co-vinylbenzylchloride) as a precursor polymer; subsequently, the precursor polymer was hypercrosslinked, to increase the specific surface areas and capacities of the sorbents, and then functionalised to impart the zwitterionic character. The HXLPP-SAX/WCX sorbent was decorated with quaternised sarcosine groups and the HXLPP-WAX/SCX sorbent was decorated with taurine moieties. The SPE parameters were optimised to exploit the ionic interactions between compounds and the functional groups. The optimal conditions involve a washing step to remove the compounds retained by hydrophobic interactions, thus increasing the selectivity. The optimised SPE protocol used the quaternised sarcosine-based sorbent followed by liquid chromatography and tandem mass spectrometry, and was applied to determine compounds with acidic and basic properties from environmental samples, such as river water and effluent wastewater samples, with excellent selectivity and matrix effect values below -30% and apparent recovery results ranging from 52% to 105% for most of the compounds. The analytical method was validated for environmental water samples and used in the analysis of samples in which some of the target compounds were found at ng L^-1 concentration levels.

Development of a maleic acid-based material to selectively solid-phase extract basic compounds from environmental samples

This study presents a novel mixed-mode weak cation-exchange (WCX) material. This material was prepared by means of the functionalization of a mesoporous divinylbenzene (DVB) resin with maleic acid (maleic acid-DVB), which yielded a high carboxylic moiety content resulting in WCX interactions as well as suitable specific surface area for reversed-phase interactions. After the optimization of the solid-phase extraction (SPE) protocol to enhance the selectivity of the sorbent, this material was evaluated as a novel WCX sorbent in the SPE of a group of drugs from environmental water samples. The method is based on SPE followed by liquid chromatography (LC) coupled to high resolution mass spectrometry (HRMS) with an Orbitrap analyzer, and was validated and applied for the determination of basic drugs in river, effluent and influent wastewater samples. Maleic acid-DVB sorbent yielded suitable recovery rates (57% to 89%) and an acceptable matrix effect (<32%) thanks to the effective washing step included when these environmental waters were loaded through the novel resin. The method was applied to different environmental water samples and some basic drugs were suitably quantified in these environmental samples.

Pollen grains as a low-cost, green, alternative sorbent for hydrophilic solid-phase extraction

Many natural products have demonstrated functionality as novel, green sorbents for organic compounds. However, only limited reports exist on the use of such green materials as solid-phase extraction (SPE) sorbents for select organic acids. In this study, we employed pollen grains as a hydrophilic sorbent and investigated the influence of various extraction parameters using a series of experimental designs. The chemical structure and surface properties of the prepared sorbent were investigated by Fourier-transform infrared spectroscopy and scanning electron microscopy. The Plackett-Burman design was used to experimentally screen for parameters that significantly influenced the extraction performance. Three selected parameters were then statistically optimized by applying a central composite design combined with a response surface methodology. Phenolic acid residues were determined and quantified using high performance liquid chromatography with ultraviolet detection; a mass spectrometric detector in the selected ion monitoring mode was also used for identification. As a practical example, phenolic acids in the soil were successfully separated by the developed pollen sorbent. These results therefore indicate that pollen grains can be considered as a sustainable, green, and safe alternative to bare silica for extraction and separation applications.

Targeted cofactor quantification in metabolically engineered E. coli using solid phase extraction and hydrophilic interaction liquid chromatography-mass spectrometry

Quantification of energy and redox cofactors is of great value to synthetic biologists to infer the balance of energy metabolism in engineered microbial strains and assess each strain's potential for further improvement. Most currently used methods for intracellular cofactor measurement suffer from incomplete coverage, low reproducibility, suboptimal sensitivity or specificity. In this study, we described an SPE-HILIC/MS approach for simultaneous determination of six cofactor targets (ATP, ADP, NAD, NADH, NADP, NADPH) in Escherichia coli cells. Sufficient linearity, precision and metabolite recoveries of this new approach justified its reliability in targeted cofactor quantification. Our approach was then compared with conventional enzymatic assays to demonstrate its superior performance. We applied the SPE-HILIC/MS approach to profile shift of cofactor balances in several engineered E. coli strains with varying isobutanol production. Our cofactor analysis clearly revealed that optimal energy fitness was achieved in the highest-yield strain through combined modulation of a transhydrogenase and a NAD(+) kinase. Apart from the targeted cofactors, the SPE enrichment procedure also allowed for confident identification of 39 groups of polar metabolites mainly involved in central carbon metabolism in E. coli cells.

Determination of Triazine Herbicides in Drinking Water by Dispersive Micro Solid Phase Extraction with Ultrahigh-Performance Liquid Chromatography-High-Resolution Mass Spectrometric Detection

A novel dispersive micro solid phase extraction (DMSPE) method based on a polymer cation exchange material (PCX) was applied to the simultaneous determination of the 30 triazine herbicides in drinking water with ultrahigh-performance liquid chromatography-high-resolution mass spectrometric detection. Drinking water samples were acidified with formic acid, and then triazines were adsorbed by the PCX sorbent. Subsequently, the analytes were eluted with ammonium hydroxide/acetonitrile. The chromatographic separation was performed on an HSS T3 column using water (4 mM ammonium formate and 0.1% formic acid) and acetonitrile (0.1% formic acid) as the mobile phase. The method achieved LODs of 0.2-30.0 ng/L for the 30 triazines, with recoveries in the range of 70.5-112.1%, and the precision of the method was better than 12.7%. These results indicated that the proposed method had the advantages of convenience and high efficiency when applied to the analysis of the 30 triazines in drinking water.

Hypercrosslinked materials: preparation, characterisation and applications

Hypercrosslinked materials have experienced a great expansion in both the synthetic approach and the field of applications.