Practical examination of flow rate effects and influence of the stationary phase water layer on peak shape and retention in hydrophilic interaction liquid chromatography

Effect of flow rate on plate height and resolution for antisense oligonucleotides under hydrophilic interaction liquid chromatography conditions

Determination of quality attributes of antisense oligonucleotides (ASOs) such as purity, potency, and sequence is challenging due to their relatively large size, polyanionic nature, and large number of synthetic modifications. Chromatography technologies are evolving rapidly to meet these challenges, and one area of particularly rapid change at this time is the use of hydrophilic interaction liquid chromatography (HILIC) for oligonucleotide (ON) separations. Relatively little has been published on the factors that dictate the kinetics of these separations. This knowledge gap consequently makes it difficult to know what gains might be made during method development by changing flow rate or particle size, for example. In this work we have taken initial steps to address this gap by examining the dependence of plate height and resolution on flow rate for separations of 23-mer ASOs under HILIC conditions. Such work is complicated by the fact that the retention of these molecules decreases dramatically with increasing pressure. After adjusting mobile phase composition to hold retention factor nominally constant for each flow rate used, we find that plate height increases strongly with increasing flow rate such that the plate height increases about ten-fold over the range of flow rate of 0.1 to 4.0 mL/min. when using a 4.6 mm i.d. column. However, the minimum reduced plate height observed at the lowest flow rate is quite impressive at around 2. Finally, we find that this dependence of plate height on flow rate translates, as expected, to an improvement in resolution as flow rate is decreased, both in conventional one-dimensional separations, and in the second dimension of a two-dimensional separation. We expect to use this work as a foundation to build on as we deepen our understanding of the kinetics of ON separations.

Preparation of high-efficiency HILIC capillary columns utilizing slurry packing at 2100 bar

Complex mixture analysis requires high-efficiency chromatography columns. Although reversed phase liquid chromatography (RPLC) is the dominant approach for such mixtures, hydrophilic interaction liquid chromatography (HILIC) is an important complement to RPLC by enabling the separation of polar compounds. Chromatography theory predicts that small particles and long columns will yield high efficiency; however, little work has been done to prepare HILIC columns longer than 25 cm packed with sub-2 μm particles. In this work, we tested the slurry packing of 75 cm long HILIC columns with 1.7 μm bridged-ethyl-hybrid amide HILIC particles at 2,100 bar (30,000 PSI). Acetonitrile, methanol, acetone, and water were tested as slurry solvents, with acetonitrile providing the best columns. Slurry concentrations of 50-200 mg/mL were assessed, and while 50-150 mg/mL provided comparable results, the 150 mg/mL columns provided the shortest packing times (9 min). Columns prepared using 150 mg/mL slurries in acetonitrile yielded a reduced minimum plate height (hmin) of 3.3 and an efficiency of 120,000 theoretical plates for acenaphthene, an unretained solute. Para-toluenesulfonic acid produced the lowest hmin of 1.9 and the highest efficiency of 210,000 theoretical plates. These results identify conditions for producing high-efficiency HILIC columns with potential applications to complex mixture analysis.