Development in modeling submicron particle formation in two phases flow of solvent-supercritical antisolvent emulsion

Concentration of Antioxidant Compounds from Calendula officinalis through Sustainable Supercritical Technologies, and Computational Study of Their Permeability in Skin for Cosmetic Use

The growing interest in the cosmetic industry in using compounds of natural and sustainable origin that are safe for humans is encouraging the development of processes that can satisfy these needs. Chlorogenic acid (CHA), caffeic acid (CAF) and ferulic acid (FA) are three compounds widely used within the cosmetic industry due to their functionalities as antioxidants, collagen modifiers or even as radiation protectors. In this work, two advanced separation techniques with supercritical CO2 are used to obtain these three compounds from Calendula officinalis, and these are then evaluated using a computational skin permeability model. This model is encompassed by the COSMO-RS model, the calculations of which make it possible to study the behaviour of the compounds in the epidermis. The results show that both CAF and FA are retained in the stratum corneum, while CHA manages to penetrate to the stratum spinosum. These compounds were concentrated by antisolvent fractionation with super-critical CO2 using a Response Surface Methodology to study the effect of pressure and CO2 flow rate. CHA, CAF and FA were completely retained in the precipitation vessel, with concentrations between 40% and 70% greater than in the original extract. The conditions predicted that the optimal overall yield and enrichment achieved would be 153 bar and 42 g/min.

Surfactant influence on rivulet droplet flow in minitubes and capillaries and its downstream evolution

During our investigations of two-phase flow in long hydrophobic minitubes and capillaries, we have observed transformation of the main rivulet into different new hydrodynamic modes with the use of different kinds of surfactants. The destabilization of rivulet flow at air velocities <80 m/s occurs primarily due to the strong branching off of sub-rivulets from the main rivulet during the downstream flow in the tube. The addition of some surfactants of not-so-high surface activity was found to increase the frequency of sub-rivulet formation and to suppress the Rayleigh and sinuous instabilities of the formed sub-rivulets. Such instabilities result in subsequent fragmentation of the sub-rivulets and in the formation of linear or sinuous arrays of sub-rivulet fragments (SRFs), which later transform into random arrays of SRFs. In the downstream flow, SRFs further transform into large sliding cornered droplets and linear droplet arrays (LDAs), a phenomenon which agrees with recent theories. At higher surface activity, suppression of the Rayleigh instability of sub-rivulets with surfactants becomes significant, which prevents sub-rivulet fragmentation, and only the rivulet and sub-rivulets can be visualized in the tube. At the highest surface activity, the bottom rivulet transforms rapidly into an annular liquid film. The surfactant influence on the behavior of the rivulets in minitubes is incomparably stronger than the classic example of the known surfactant stabilizing influence on a free jet. The evolution of a rivulet in the downstream flow inside a long minitube includes the following sequence of hydrodynamic modes/patterns: i) single rivulet; ii) rivulet and sub-rivulets; and iii) rivulet, sub-rivulets, sub-rivulet fragments, cornered droplets, linear droplet arrays, linear arrays of sub-rivulet fragments and annular film. The formation of these many different hydrodynamic patterns downstream is in drastic contrast with the known characteristics of two-phase flow, which demonstrates one mode for the entire tube length. Recent achievements in fluid mechanics regarding the stability of sliding thin films and in wetting dynamics have allowed us to interpret many of our findings. However, the most important phenomenon of the surfactant influence on sub-rivulet formation remains poorly understood. To achieve further progress in this new area, an interdisciplinary approach based on the use of methods of two-phase flow, wetting dynamics and interfacial rheology will be necessary.

Enhanced dissolution of megestrol acetate microcrystals prepared by antisolvent precipitation process using hydrophilic additives

Microcrystals of megestrol acetate (MA), a poorly water-soluble drug, were successfully prepared using an antisolvent precipitation technique for improving the dissolution rate. The effective hydrophilic polymers and surfactants used were screened for their abilities to produce smaller particle sizes. Raw micronized MA and processed MA microcrystals were ranked by the Student-Newman-Keuls test in order of increasing particle size and SPAN values as follows: processed MA microcrystals in the presence of polymer and surfactant (mean diameter 1048nm)<processed MA microcrystals in the presence of polymer (1654nm)<processed MA microcrystals in the absence of polymer and surfactant (3491nm)<raw micronized MA (4352nm). The order of BET surface area was reversely ranked. Processed MA microcrystals in the presence of polymer and surfactant slightly decreased crystallinity and altered crystal habit and preferred orientation without change in polymorph. In addition, the dissolution properties of the processed MA microcrystals in the presence of polymer and surfactant were significantly enhanced as compared to that of the raw micronized MA. This effect is mainly due to a reduction in particle size resulting in an increased surface area. Therefore, it was concluded that the antisolvent precipitation technique in mild conditions could be a simple and useful technique to prepare poorly water-soluble drug particles with reduction in particle size, a narrow particle size distribution and enhanced dissolution properties.