Effect of amphiphilic and non-amphiphilic polymers on micellar behaviour of nonionic surfactant Triton X-100

Pickering Emulsions of Thermotropic Liquid Crystals Stabilized by Amphiphilic Gold Nanoparticles

We report emulsions of thermotropic liquid crystals (LCs) in water that are stabilized using amphiphilic gold nanoparticles (AuNPs) and retain their ability to respond to aqueous analytes for extended periods (e.g., up to 1 year after preparation). These LC emulsions exhibit exceptional colloidal stability that results from the adsorption of AuNPs that are functionalized with thiol-terminated poly(ethylene glycol) (PEG-thiol) and hexadecanethiol (C16-thiol) to LC droplet interfaces. These stabilized LC emulsions respond to the presence of model anionic (SDS), cationic (C12TAB), and nonionic (C12E4) surfactants in the surrounding aqueous media, as evidenced by ordering transitions in the LC droplets that can be readily observed using polarized light microscopy. Our results reveal significant differences in the sensitivity of the stabilized LC droplets toward each of these analytes. In particular, these stabilized droplets can detect the cationic C12TAB at concentrations that are lower than those required for bare LC droplets under similar experimental conditions (0.5 and 2 mM, respectively). These results demonstrate an enhanced sensitivity of the LC toward C12TAB when the PEG/C16-thiol-coated AuNPs are adsorbed at LC droplet interfaces. In contrast, the concentrations of SDS required to observe optical transformations in the stabilized LC droplets are higher than those required for the bare LC droplets, suggesting that the presence of the PEG/C16-thiol AuNPs reduces the sensitivity of the LC toward this analyte. When combined, our results show that this Pickering stabilization approach using amphiphilic AuNPs as stabilizing agents for LC-in-water emulsions provides a promising platform for developing LC droplet-based optical sensors with long-term colloidal stability as well as opportunities to tune the sensitivity and selectivity of the response to target aqueous analytes.

Optimization and in Silico Analysis of a Cold-Adapted Lipase from an Antarctic Pseudomonas sp. Strain AMS8 Reaction in Triton X-100 Reverse Micelles

A moderate yield of a purified enzyme can be achieved by using the simple technique of reverse micellar extraction (RME). RME is a liquid–liquid extraction method that uses a surfactant and an organic solvent to extract biomolecules. Instead of traditional chromatographic purification methods, which are tedious and expensive, RME using the nonionic surfactant Triton X-100 and toluene is used as an alternative purification technique to purify a recombinant cold-adapted lipase, AMS8. Various process parameters were optimized to maximize the activity recovery of the AMS8 lipase. The optimal conditions were found to be 50 mM sodium phosphate buffer, pH 7, 0.125 M NaCl, and 0.07 M Triton X-100 in toluene at 10 °C. Approximately 56% of the lipase activity was successfully recovered. Structural analysis of the lipase in a reverse micelle (RM) was performed using an in silico approach. The predicted model of AMS8 lipase was simulated in the Triton X-100/toluene reverse micelles from 5 to 40 °C. The lid 2 was slightly opened at 10 °C. However, the secondary structure of AMS8 was most affected in the non-catalytic domain compared to the catalytic domain, with an increased coil conformation. These results suggest that an AMS8 lipase can be extracted using Triton X-100/water/toluene micelles at low temperature. This RME approach will be an important tool for the downstream processing of recombinant cold-adapted lipases.