Synthesis of chitosan/Al-MCM-41 nanocomposite from natural microcline as a carrier for levofloxacin drug of controlled loading and release properties; Equilibrium, release kinetic, and cytotoxicity

Chitosan-coated liposome with lysozyme-responsive properties for on-demand release of levofloxacin

As an anti-infection antibiotic delivery route, a drug-controlled release system based on a specific condition stimulus response can enhance drug stability and bioavailability, reduce antibiotic resistance, achieve on-demand release and improve targeting and utilization efficiency. In this study, chitosan-coated liposomes containing levofloxacin (Lef@Lip@CS) were prepared with lysozyme in body fluids serving as an intelligent "switch" to enable accurate delivery of antibiotics through the catalytic degradation ability of chitosan. Good liposome encapsulation efficacy (64.89 ± 1.86 %) and loading capacity (5.28 ± 0.18 %) were achieved. The controlled-release behavior and morphological characterization before and after enzymatic hydrolysis confirmed that the levofloxacin release rate depended on the lysozyme concentration and the degrees of deacetylation of chitosan. In vitro bacteriostatic experiments showed significant differences in the effects of Lef@Lip@CS before and after enzyme addition, with 6-h inhibition rate of 72.46 % and 100 %, and biofilm removal rates of 51 % and 71 %, respectively. These findings show that chitosan-coated liposomes are a feasible drug delivery system responsive to lysozyme stimulation.

Novel and highly efficient transformation of carbon dioxide into 2-oxazolidinones over Al-MCM-41 mesoporous-supported ionic liquids

A type of Al-MCM-41 supported dual imidazolium ionic liquids were constructed and efficiently used as catalysts for the synthesis of 2-oxazolidinones from epoxides, amines, and CO2. The influence of the different catalysts and reaction parameters on the catalytic behaviours was investigated. Al-MCM-41@ILTiCl5 was identified as the most excellent catalyst because it could efficiently promote the three-component cycloaddition of CO2, epoxide, and amines to form the corresponding 2-oxazolidinones in high to excellent yields (84∼96%) with excellent selectivities (98∼99.7%). In addition, the recovery and reuse performances of Al-MCM-41@ILTiCl5 were examined. The catalyst could be recovered by simple filtration and reused six times without a change in the catalytic activity. Green reaction conditions, operational simplicity, feasibility, and sustainability of the functionalized catalyst are the main highlights of the present protocol.

Development and Application of Poly (Lactic Acid)/Poly (Butylene Adipate-Co-Terephthalate)/Thermoplastic Starch Film Containing Salicylic Acid for Banana Preservation

Bananas are susceptible to the effects of endogenous enzymatic, leading to their rapid decay and deterioration. In order to mitigate economic losses and prolong the shelf life of bananas, the objective of this study was to develop a new and green gas-regulating packaging film. In this study, an active gas-regulating packaging film was prepared by extrusion, with mobil composition of matter (MCM)-41 loaded with salicylic acid (SA) as the active agent and poly (lactic acid) (PLA), poly (butylene adipate-co-terephthalate) (PBAT), and thermoplastic starch (TPS) as the base materials. The obtained films included PLA/PBAT/TPS, PLA/PBAT/TPS-SA, and PLA/PBAT/TPS-MCSA. These films were subsequently applied to banana preservation. The study focused on the variations in soluble solid content (SSC), rate of weight loss (RWL), malondialdehyde (MDA) content, and polyphenol oxidase (PPO) activity of bananas during the preservation process. The results showed that, compared with the PLA/PBAT/TPS film, the oxygen transmission rate of the PLA/PBAT/TPS-MCSA film increased from 384.36 ± 22.06 cm3·m-2·24 h-1·0.1 MPa-1 to 543.10 ± 3.47 cm3·m-2·24 h-1·0.1 MPa-1. Throughout the preservation period, the PLA/PBAT/TPS-MCSA film exhibited superior performance, effectively retarding the increase in banana SSC, RWL, and MDA while inhibiting the elevation of PPO activity and prolonging the shelf life of bananas by 4-5 days. However, this study needs to further investigate the mechanism of function of MCM-41 loaded with SA in banana preservation.

Melaleuca armillaris Essential Oil as an Antibacterial Agent: The Use of Mesoporous Bioactive Glass Nanoparticles as Drug Carrier

Bioactive glasses have been proposed for bone tissue engineering due to their excellent biocompatibility and osteo-inductive behaviour. The generation of mesoporous bioactive glass (nano) particles adds a high surface area for the dissolution and release of bioactive ions, and the possibility to load them with different drugs for antibacterial purposes. Essential oils (EO) are an interesting resource for alternative medical therapy, providing antimicrobial compounds that come from organic/natural resources like aromatic plants. Also, a biological polymer, such as chitosan, could be used to control the release of active agents from mesoporous bioactive glass (MBG) loaded particles. This work presents MBG particles with nominal composition (in mol) 60% SiO2, 30% CaO and 10% P2O5, loaded with essential oil of Melaleuca armillaris, which contains 1,8-cineol as the main active component, with an inhibitory in vitro activity against several bacterial species. Also, co-loading with a broad-spectrum antibiotic, namely gentamicin, was investigated. The MBG particles were found to be of around 300nm in diameter and to exhibit highly porous open structure. The release of EO from the particles reached 72% of the initial content after the first 24 h, and 80% at 48 h of immersion in phosphate buffered solution. Also, the MBG particles with EO and EO-gentamicin loading presented in vitro apatite formation after 7 days of immersion in simulated body fluid. The antibacterial tests indicated that the main effect, after 24 h of contact with the bacteria, was reached either for the MBG EO or MBG EO-gentamicin particles against E. coli, while the effect against S. aureus was less marked. The results indicate that MBG particles are highly bioactive with the tested composition and loaded with EO of Melaleuca armillaris. The EO, also combined with gentamicin, acts as an antibacterial agent but with different efficacy depending on the bacteria type.

Fast-thermoresponsive carboxylated carbon nanotube/chitosan aerogels with switchable wettability for oil/water separation

The use of aerogels to selectively recover oil from oily wastewater is effective but challenging. In this study, a new carboxylated carbon nanotube/chitosan aerogel (CCNT/CA) with switchable wettability was developed as a smart adsorbent for fast oil absorption and oil recovery. Vinyltrimethoxysilane and thermoresponsive poly(N-isopropylacrylamide) (PNIPAAm) was grafted onto the surface of the CCNT/CA skeleton, and the resulting smart aerogel (PNI-Si@CCNT/CA) exhibited temperature responsiveness. PNI-Si@CCNT/CA exhibited an excellent reversible conversion between hydrophilicity and hydrophobicity when the temperature was changed to below or above the lower critical solution temperature (LCST) of PNIPAAm (~32 °C). Most importantly, CCNT significantly increased the oil absorption capacity, improved the mechanical properties, accelerated phonon conduction, enhanced thermal conductivity (80.57 mW m^-1 K^-1), improved the temperature response rate, shortened the oil desorption time (15 min), and improved the oil/water separation efficiency of PNI-Si@CCNT/CA because a strong interface interaction occurred between CCNT and chitosan. Moreover, PNI-Si@CCNT/CA absorbed oil at 45 °C and released the absorbed oil at 25 °C. It maintained its good adsorption performance after 15 cycles, and this was ascribed to its excellent mechanical properties and stable structure.

Insight into the Loading Properties of Na+ Green-Functionalized Clinoptilolite as a Potential Carrier for the 5-Fluorouracil Drug, its Release Kinetics, and Cytotoxicity

Herein, natural zeolite (clinoptilolite) was functionalized by Na⁺ ions (G.Na⁺/Clino) utilizing a green tea extract prepared by a green production method as a potential carrier for the 5-fluorouracil (5-Fu) drug with enhanced physicochemical behaviors. The G.Na⁺/Clino-modified product showed enhanced surface area (312 m²/g) and ion-exchange capacity (387 mequiv/100 g). The loading studies reflect high and controlled loading properties of G.Na⁺/Clino with an actual loading capacity of 291 and 462 mg/g, respectively. The loading reactions of 5-Fu into G.Na⁺/Clino were of pseudo-second-order kinetics and exhibited Langmuir isotherm properties. This suggested a monolayer and homogeneous loading process by chemical complexation and ion-exchange mechanisms with a Gaussian energy value of 10.47 kJ/mol. Additionally, these reactions were of endothermic and spontaneous nature based on the determined thermodynamic parameters. The release studies demonstrated the 5-Fu release profile for about 150 h at pH 1.2 and for 80 h at pH 7.4. The release reactions had non-Fickian transport properties and were controlled by both erosion and diffusion mechanisms, considering the release kinetic findings and the values of the diffusion exponent (0.42 at pH 1.2 and 0.37 at pH 7.4). The composite showed remarkable biocompatibility based on the measured cell viability and a cytotoxic effect on normal colorectal cells (CCD-18Co). Additionally, the application of G.Na⁺/Clino as an inorganic carrier for the 5-Fu drug prompted the cytotoxic effect of the drug on colon cancer cell treatment (HCT-116).

Starch Solutions Prepared under Different Conditions as Modifiers of Chitosan/Poly(aspartic acid)-Based Hydrogels

Recently, there has been great interest in the application of polysaccharides in the preparation of diverse biomaterials which result from their biocompatibility, biodegradability and biological activity. In this work, the investigations on chitosan/poly(aspartic acid)-based hydrogels modified with starch were described. Firstly, a series of hydrogel matrices was prepared and investigated to characterize their swelling properties, structure via FT-IR spectroscopy, elasticity and tensile strength using the Brookfield texture analyzer as well as their impact on simulated physiological liquids. Hydrogels consisting of chitosan and poly(aspartic acid) in a 2:1 volume ratio were elastic (9% elongation), did not degrade after 30-day incubation in simulated physiological liquids, exhibited a relative biocompatibility towards these liquids and similar swelling in each absorbed medium. This hydrogel matrix was modified with starch wherein two of its form were applied-a solution obtained at an elevated temperature and a suspension obtained at room temperature. Hydrogels modified with hot starch solution showed higher sorption that unmodified materials. This was probably due to the higher starch inclusion (i.e., a larger number of hydrophilic groups able to interact with the adsorbed liquid) when this polysaccharide was given in the form of a hot solution. Hydrogels modified with a cold starch suspension had visible heterogeneous inequalities on their surfaces and this modification led to the obtainment materials with unrepeatable structures which made the analysis of their properties difficult and may have led to misleading conclusions.