Investigation of the inhibition mechanism of polymer/nano-silica composite as shale inhibitor in water-based drilling fluids

Effects of nanosilica on the properties of brine-base drilling fluid

In the process of drilling oil and gas wells, the shrinkage and falling of wellbore walls are often caused by the expansion of mud shale water. To date, conventional additives have been unable to plug the pore throats of shale rock with nanoscale pores and thus cannot effectively solve the problem of wellbore instability encountered in shale formation drilling. In view of this situation, the idea of using nanosilica to plug the nanopore throat of mud shale is proposed to reduce its permeability and to slow water intrusion. The influences of nanosilica on the properties of brine-base drilling fluid drilling fluid are evaluated by measuring the viscosity, filtration loss and swelling of the drilling fluid. The results of laboratory experiments show that the improvement in drilling fluid properties can only be achieved on the basis of salt resistance; that is, a salt-resistant soil slurry should be used. A concentration of 1-5% nanosilica can improve the viscosity of the drilling fluid by increasing the internal friction between particles. However, nanosilica materials are sensitive to salt concentration. Nanosilica particles can be deposited on the surface of a filter cake to block the pores of the filter paper, and the filtration loss reduction rate can reach 40.2%. Blocking the pores of the clay plays a role in preventing the clay from absorbing water and expanding. The optimal addition amount of silica is 3%, and its salt resistance can reach 16%. Considering the experimental results of filtration loss, swelling amount and cost performance, 3%NP + 4%NaCl + SWM-B is selected as the optimal formula. The results of this study can be applied to effectively improve the phenomenon of wellbore instability during drilling in shale formations, and it has important application value.

Sodium alginate as an eco-friendly rheology modifier and salt-tolerant fluid loss additive in water-based drilling fluids

The rheological and filtration performance of drilling fluids greatly depends on the additives used. To address the negative impact on the drilling fluid performance stemming from electrolyte contamination, a sustainable sodium alginate (SA) biopolymer was employed as an additive in water-based drilling fluids to overcome the performance deterioration caused by the polyelectrolyte effect under salt contamination. The results demonstrated that SA performs better than sodium carboxymethyl cellulose (Na-CMC) and polyanionic cellulose (PAC-LV), the widely used drilling fluid additives. Although exposed to highly concentrated salt contamination, the addition of SA can mitigate viscosity variation and maintain a lower filtration volume of a base fluid (BF), whereas an advanced variation in CMC/BF and PAC/BF was observed. The possible rheology and filtration mechanism of SA under highly concentrated salt contamination were investigated through zeta potential, particle size distribution, and scanning electron microscopy (SEM). The results revealed that the anchoring groups on the SA molecular chain enable them to strongly adsorb on the negatively charged bentonite surface via hydrogen and ionic bond interactions, leading to a significant improvement in both rheological and filtration performance. Therefore, SA with excellent salt tolerance and sustainability confers practical applicability that could extend to the preparation of saltwater-based and other inhibitive drilling fluids.