Use of low frequency ultrasound for water treatment: Data on azithromycin removal

Commercial dexamethasone degradation by heterogeneous sono/photo-Fenton process using iron zeolite catalyst by an electrodeposition method

Dexamethasone (DXM) was the first drug used to treat COVID-19, only a small part is metabolized and has been identified in wastewater and surface water, conventional treatments do not remove these compounds, therefore new technologies must be developed. A commercially injectable solution containing dexamethasone (DXM) was removed by heterogeneous sono/photo-Fenton (SPF) process using clinoptilolite zeolite (CZ) modified with Fe (CZ-Fe) by an electrodeposition method. The effect of initial concentration (1.2, 3, 5.5, 8, 9.7 mg/L), H2O2 dose (9.8, 15, 22.5, 30, 35.1 mg/L) and hydraulic retention time (HRT, 39.5, 60, 90, 120, 140 min) were evaluated through central composite design (CCD). The frequency of the ultrasound was 140 kHz. The optimal conditions were 5.5 mg/L DXM, 22.5 mg/L H2O2 and 140 min obtaining an 85.4% DXM by UV-Vis, 99% by high-performance liquid chromatography (HPLC) and 76% by chemical oxygen demand (COD) removal. The systems generated 12, 25, 40.5 and 45.5 mg/L of total oxidant at 20, 60, 100 and 140 kHz, respectively. In individual effects, UV radiation removed 23.6%, ultrasound 18.1% and H2O2 14% of DXM. In kinetic studies, the best fit was obtained for the Behnajady-Modirshahla-Ghanbery (BMG) model. SPF improved the mass transfer within the reaction media, the oxidation rate and the consumption of H2O2, and no sludge was generated. Finally, another oxidant formed during the process (H•, HO2•, O2-•) contributed to DXM removal.

Augmented dissemination of antibiotic resistance elicited by non-antibiotic factors

The emergence and rapid spread of antibiotic resistance seriously compromise the clinical efficacy of current antibiotic therapies, representing a serious public health threat worldwide. Generally, drug-susceptible bacteria can acquire antibiotic resistance through genetic mutation or gene transfer, among which horizontal gene transfer (HGT) plays a dominant role. It is widely acknowledged that the sub-inhibitory concentrations of antibiotics are the key drivers in promoting the transmission of antibiotic resistance. However, accumulating evidence in recent years has shown that in addition to antibiotics, non-antibiotics can also accelerate the horizontal transfer of antibiotic resistance genes (ARGs). Nevertheless, the roles and potential mechanisms of non-antibiotic factors in the transmission of ARGs remain largely underestimated. In this review, we depict the four pathways of HGT and their differences, including conjugation, transformation, transduction and vesiduction. We summarize non-antibiotic factors accounting for the enhanced horizontal transfer of ARGs and their underlying molecular mechanisms. Finally, we discuss the limitations and implications of current studies.

Fenton Reaction–Unique but Still Mysterious

This study is devoted to the Fenton reaction, which, despite hundreds of reports in a number of scientific journals, provides opportunities for further investigation of its use as a method of advanced oxidation of organic macro- and micropollutants in its diverse variations and hybrid systems. It transpires that, for example, the choice of the concentrations and ratios of basic chemical substances, i.e., hydrogen peroxide and catalysts based on the Fe2+ ion or other transition metals in homogeneous and heterogeneous arrangements for reactions with various pollutants, is for now the result of the experimental determination of rather randomly selected quantities, requiring further optimizations. The research to date also shows the indispensability of the Fenton reaction related to environmental issues, as it represents the pillar of all advanced oxidation processes, regarding the idea of oxidative hydroxide radicals. This study tries to summarize not only the current knowledge of the Fenton process and identify its advantages, but also the problems that need to be solved. Based on these findings, we identified the necessary steps affecting its further development that need to be resolved and should be the focus of further research related to the Fenton process.

Green Nanoemulsion Water/Ethanol/Transcutol/LabM-Based Treatment of Pharmaceutical Antibiotic Erythromycin-Contaminated Aqueous Bulk Solution

Contaminated wastewater released from hospital, domestic, and industrial sources is a major challenge to aquatic animals and human health. In this study, we addressed removal of erythromycin (ERN) from contaminated water employing water/ethanol/Transcutol/Labrafil M 1944 CS (LabM) green nanoemulsions as a nanocarrier system. ERN is a major antibiotic contaminant harming aquatic and human lives. Green nanoemulsions were prepared and evaluated for size, size distribution (measuring polydispersity index), stability, zeta potential, refractive index, and viscosity. Transmission electron microscopy (TEM) was used to visualize morphological behavior. The treated-water was analyzed for ERN by the spectroscopy, scanning electron microscopy-energy-dispersive X-ray analysis mode (SEM-EDX), and inductively coupled plasma-optical emission spectroscopy (ICP-OES) techniques. We studied factors (composition, size, viscosity, and time of exposure) affecting removal efficiency (%RE). The obtained green nanoemulsions (ENE1-ENE5) were stable and clear (<180 nm). ENE5 had the smallest size (58 nm), a low polydispersity index value (0.19), optimal viscosity (∼121.7 cP), and a high negative zeta potential value (-25.4 mV). A high %RE value (98.8%) was achieved with a reduced size, a high water amount, a low Capryol 90 content, and optimal viscosity as evidenced by the obtained results. Moreover, contact time had insignificant effect on %RE. UV-vis spectroscopy, SEM-EDX, and ICP-OES confirmed the absence of ERN from the treated water. Conclusively, ERN can easily be removed from polluted water employing green nanoemulsions prepared from the optimized excipients, and evaluated characteristics.

SARS-CoV-2 pharmaceutical drugs: a critical review on the environmental impacts, chemical characteristics, and behavior of advanced oxidation processes in water

This review summarizes research data on the pharmaceutical drugs used to treat the novel SARS-CoV-2 virus, their characteristics, environmental impacts, and the advanced oxidation processes (AOP) applied to remove them. A literature survey was conducted using the electronic databases Science Direct, Scopus, Taylor & Francis, Google Scholar, PubMed, and Springer. This complete research includes and discusses relevant studies that involve the introduction, pharmaceutical drugs used in the SARS-CoV-2 pandemic: chemical characteristics and environmental impact, advanced oxidation process (AOP), future trends and discussion, and conclusions. The results show a full approach in the versatility of AOPs as a promising solution to minimize the environmental impact associated with these compounds by the fact that they offer different ways for hydroxyl radical production. Moreover, this article focuses on introducing the fundamentals of each AOP, the main parameters involved, and the concomitance with other sources and modifications over the years. Photocatalysis, sonochemical technologies, electro-oxidation, photolysis, Fenton reaction, ozone, and sulfate radical AOP have been used to mineralize SARS-CoV-2 pharmaceutical compounds, and the efficiencies are greater than 65%. According to the results, photocatalysis is the main technology currently applied to remove these pharmaceuticals. This process has garnered attention because solar energy can be directly utilized; however, low photocatalytic efficiencies and high costs in large-scale practical applications limit its use. Furthermore, pharmaceuticals in the environment are diverse and complex. Finally, the review also provides ideas for further research needs and major concerns.

Pharmaceutical compounds used in the COVID-19 pandemic: A review of their presence in water and treatment techniques for their elimination

During the COVID-19 pandemic, high consumption of antivirals, antibiotics, antiparasitics, antiprotozoals, and glucocorticoids used in the treatment of this virus has been reported. Conventional treatment systems fail to efficiently remove these contaminants from water, becoming an emerging concern from the environmental field. Therefore, the objective of the present work is to address the current state of the literature on the presence and removal processes of these drugs from water bodies. It was found that the concentration of most of the drugs used in the treatment of COVID-19 increased during the pandemic in water bodies. Before the pandemic, Azithromycin concentrations in surface waters were reported to be in the order of 4.3 ng L-1, and during the pandemic, they increased up to 935 ng L-1. Laboratory scale studies conclude that adsorption and advanced oxidation processes (AOPs) can be effective in the removal of these drugs. Up to more than 80% removal of Azithromycin, Chloroquine, Ivermectin, and Dexamethasone in aqueous solutions have been reported using these processes. Pilot-scale tests achieved 100% removal of Azithromycin from hospital wastewater by adsorption with powdered activated carbon. At full scale, treatment plants supplemented with ozonation and artificial wetlands removed all Favipiravir and Azithromycin, respectively. It should be noted that hybrid technologies can improve removal rates, process kinetics, and treatment cost. Consequently, the development of new materials that can act synergistically in technically and economically sustainable treatments is required.

Application of green nanoemulsion to treat contaminated water (bulk aqueous solution) with azithromycin

The present work aimed to remove azithromycin (AZM) from the contaminated aqueous system using a water/ethanol/transcutol/Capryol-90 green nanoemulsion. The drug is identified as a potential pharmaceutical contaminant detrimental for flora and fauna of aquatic lives as well as human health. Green nanoemulsions were tailored and characterized for thermodynamic stability, size, polydispersity index (PDI), zeta potential, viscosity, refractive index (RI), and morphological assessment using a transmission electron microscopy (TEM). Moreover, nanoemulsions were investigated for percent removal efficiency (%RE) and factors affecting percent removal efficiency (%RE). The results suggested that the developed green nanoemulsions (ANE1-ANE5) were transparent (˂ 200 nm) and stable. ANE5 exhibited the lowest value of globular size (49 nm), PDI (0.17), viscosity (~ 93 cP), and optimum zeta potential (-27.8 mV). The value of %RE depended upon the content of water and Capryol-90 of the nanoemulsion. Furthermore, the value of %RE was found to be increased with increased content of water, whereas this was decreased on increasing the Capryol-90 content in the nanoemulsions. Similarly, on decreasing the values of size and viscosity, the %RE values were observed to be increased. There was insignificant impact of the duration of exposure time on %RE. Thus, the maximum %RE value (96.8%) was obtained by ANE5 from the aqueous solution after 20 min of contact time with ANE5. Thus, this method could be a promising approach to remove AZM from the contaminated water and serve as an alternative to conventional methods.