In situ sorption phenomena can mitigate potential negative environmental effects of underground coal gasification (UCG) - an experimental study of phenol removal on UCG-derived residues in the aspect of contaminant retardation

Adsorption characteristics of rocks and soils, and their potential for mitigating the environmental impact of underground coal gasification technology: A review

This work presents the state-of-the-art review of investigations related to the adsorption process, adsorption models, experimental adsorption results, and influencing factors, considering the main contaminants produced by underground coal gasification (UCG) technology as adsorbates and the various rocks and soils surrounding the UCG cavity as adsorbents. Based on the literature reviewed, it is found that claystone, coal, coal char, shale, and clay materials present a good prospect for effective phenol adsorption; coal, coal char, shale, and clay materials can also remove benzene and some heavy metals from aqueous solutions. However, their performance varies under the effect of the influencing factors, such as the initial concentration of adsorbates in solution, the pH of the solution, the temperature and contact time controlled in the adsorption process, and the adsorbent dosage. A preliminary assessment of the potential of rocks and soils to act as natural buffers in UCG application is provided. The impact of UCG process on the adsorption of contaminants on the surrounding strata together with the major challenges and future perspectives are highlighted and outlined, to identify knowledge deficiencies regarding the retardation of UCG contaminants using the natural buffers. The prospect of surrounding strata as natural buffers can benefit the site selection, design, and commercialization of UCG.

Characteristics of Water Contaminants from Underground Coal Gasification (UCG) Process—Effect of Coal Properties and Gasification Pressure

One of the most important issues during UCG process is wastewater production and treatment. Condensed gasification wastewater is contaminated by many hazardous compounds. The composition of the generated UCG-derived wastewater may vary depending on the type of gasified coal and conditions of the gasification process. The main purpose of this study was a qualitative and quantitative characterization of the UCG wastewater produced during four different UCG experiments. Experiments were conducted using semi-anthracite and bituminous coal samples at two distinct pressures, i.e., 20 and 40 bar. The conducted studies revealed significant relationships between the physicochemical composition of the wastewater and the coal properties as well as the gasification pressure. The strongest impact is noticeable in the case of organic pollutants, especially phenols, BTEX and PAH’s. The most abundant group of pollutants were phenols. Conducted studies showed significantly higher concentration levels for bituminous coal: 29.25–49.5 mg/L whereas for semi-anthracite effluents these concentrations were in much lower range 2.1–29.7 mg/L. The opposite situation occurs for BTEX, higher concentrations were in wastewater from semi-anthracite gasification: 5483.1–1496.7 µg/L, while in samples from bituminous coal gasification average BTEX concentrations were: 2514.3–1354.4 µg/L. A similar relationship occurs for the PAH’s concentrations. The higher values were in case of wastewater from semi-anthracite coal experiments and were in range 362–1658 µg/L while from bituminous coal gasification PAH’s values are in lower ranges 407–1090 µg/L. The studies conducted have shown that concentrations of phenols, BTEX and PAH’s decrease with increasing pressure. Pearson’s correlation analysis was performed to enhance the interpretation of the obtained experimental data and showed a very strong relationship between three parameters: phenols, volatile phenols and CODcr.

Effect of Lignite Properties on Its Suitability for the Implementation of Underground Coal Gasification (UCG) in Selected Deposits

Two experimental simulations of underground coal gasification (UCG) processes, using large bulk samples of lignites, were conducted in a surface laboratory setup. Two different lignite samples were used for the oxygen-blown experiments, i.e., “Velenje” meta-lignite (Slovenia) and “Oltenia” ortho-lignite (Romania). The average moisture content of the samples was 31.6wt.% and 45.6wt.% for the Velenje and Oltenia samples, respectively. The main aim of the study was to assess the suitability of the tested lignites for the underground coal gasification process. The gas composition and its production rates, as well as the temperatures in the artificial seams, were continuously monitored during the experiments. The average calorific value of gas produced during the Velenje lignite experiment (6.4 MJ/Nm3) was much higher compared to the result obtained for the experiment with Oltenia lignite (4.8 MJ/Nm3). The Velenje lignite test was also characterized by significantly higher energy efficiency, i.e., 44.6%, compared to the gasification of Oltenia lignite (33.4%). The gasification experiments carried out showed that the physicochemical properties of the lignite used considerably affect the in situ gasification process. Research also indicates that UCG can be considered as a viable option for the extraction of lignite deposits; however, lignites with a lower moisture content and higher energy density are preferred, due to their much higher process efficiency.