Photochemical degradation of fragrance ingredient benzyl formate in water: Mechanism and toxicity assessment

Direct and indirect photodegradation of bisphenol A in the presence of natural water components

The impacts and mechanisms of natural water constituents, such as humic acid (HA), nitrates, iron and chloride ions, to the photodegradation of bisphenol A (BPA) were investigated in aqueous media under UV light irradiation. Due to the contributions of ·OH, 1O2, O2- and BPA* to BPA photodegradation in pure water in 13.4, 7.7, 22.9 and 47.9%, respectively, BPA was attenuated through the reaction pathway of direct photodegradation more than self-sensitized photodegradation. About indirect photodegradation, BPA photolysis through inhibitory effect from HA was mainly by light screening effect and quenching effect was insignificant. NO- 3 and NO- 2 both showed inhibitory effect but due to different reactive oxidization species (ROS). The photodegradation of BPA was significantly enhanced by the addition of iron from the formation of ·OH and H2O2, due to iron-assisted indirect photolysis for the degradation process. A dual effect of chloride depending on the different concentration levels involved quenching and promotion effect on reactive photo-induced species (RPS). A simple linear model revealed that BPA photodegradation was significantly impacted by the interaction of the above factors. In natural water, the decreased photolytic rate of BPA was mainly attributed to triple-excited dissolved organic matter (3DOM*), indicating that indirect photolysis was the primary transformation pathway of BPA. The detected photolysis products, such as nitrate and chlorinated products, suggest that there might be potential ecological risk of BPA photodegradation.

Homogeneous and heterogeneous atmospheric ozonolysis of chlorobenzene:Mechanism, kinetics and ecotoxicity assessment

The reactions between chlorobenzene(CB) and ozone have been studied comprehensively in this paper. Chlorobenzene is a commonly found chlorinated aromatic volatile organic compound(VOC), and its emission into the atmosphere can cause harm to the ecosystem and human health. The frequent occurrence of mineral particles from sandstorms exerts a significant influence on the atmospheric chemistry of the troposphere. Mineral particles are abundant in SiO2 and Al2O3 content. Therefore, we investigated the homogeneous and heterogeneous reaction processes of CB and ozone in the atmosphere by using density functional theory (DFT) method at the M06-2X/6-311++g(3df,2p)//M06-2X/6-31+g(d,p) level. The atmospheric fate, reaction rate and toxicity evaluation of CB ozonation were studied in the gas-phase section. Toxicity evaluation results showed that ozonation of CB could effectively reduce its toxicity. For the heterogeneous process, we simulated three types of SiO2 clusters and nine types of (Al2O3)n clusters, and studied the configurations of CB adsorbed on the cluster surfaces. We found that adsorption of CB on the SiO2 clusters was achieved through hydrogen bonding, while adsorption of CB on the Al2O3 clusters was achieved through both hydrogen bonding and metal bonding. The energy for CB adsorption on the (Al2O3)n cluster surface was higher than that for the SixOy(OH)z cluster surface, and both types of clusters exhibited efficient adsorption of CB. As the SixOy(OH)z clusters grew larger, the rates for the reactions between O3 and CB increased. CB travelled long distances along the Al2O3 clusters, leading to an extended influence range.

Comparison of ribavirin degradation in the UV/H2O2 and UV/PDS systems: Reaction mechanism, operational parameter and toxicity evaluation

Residues in surface water of ribavirin, which used extensively during the COVID-19 pandemic, have become an emerging issue due to its adverse impact on the environment and human health. UV/H₂O₂ and UV/peroxydisulfate (PDS) have different degradation effects on ribavirin, and the same operational parameter have different effects on the two processes. In this study, the reaction mechanism and degradation efficiency for ribavirin were studied to compare the differences under UV/H₂O₂ and UV/PDS processes. We calculated the total rate constants of ribavirin with HO^• and SO₄ ^•- in the liquid phase as 2.73 × 10⁸ and 9.39 × 10⁵ M^-1s^-1. The density functional theory (DFT) calculation results showed that HO^• and SO₄ ^•- react more readily with ribavirin via H-abstraction (HAA). The nitrogen-containing heterocyclic ring is difficult to undergo ring-opening degradation. The UV/PDS process was more stable and performed better than the UV/H₂O₂ for the ribavirin degradation when the same molar oxidant dosage was applied. HO^• plays an extremely important role in the degradation of ribavirin by UV/PDS. The reason for this phenomenon is the combination of the higher yield of HO^• produced in the UV/PDS process and the faster reaction rate of ribavirin with HO^•. The UV/H₂O₂ process is more sensitive to pH than UV/PDS. Alkaline condition can significantly inhibit the ribavirin degradation. The effects of natural organic matter (NOM) and ribavirin concentration were also compared. Eventually, the toxicity prediction of the product showed that the opening-ring products were more toxic than the parent compound.

Photoinduced release of odorous volatile organic compounds from aqueous pollutants: The role of reactive oxygen species in increasing risk during cross-media transformation

Photoinduced volatile organic compounds (VOCs) release from fatty alcohols at the air-water interface, has attracted considerable attention. This paper comprehensively explores the release of odorous VOCs from aqueous micropollutants under photoirradiation, especially in terms of the important role of the reactive oxygen species (ROS) in increased risk by cross-media transformation. The formation and distribution of photoinduced VOCs produced by aqueous benzyl alcohol (BzOH), a common ingredient in personal care products, were monitored in situ by online gas chromatography equipped with mass spectrometry and flame ionization detector (GC-MS/FID). The photoreaction of BzOH followed first-order kinetics with a rate constant of 0.0158/min under air. After 180 min of ultraviolet irradiation, the accumulated output of the gas-phase products benzene and benzaldehyde (BA) reached 3.8 μmol and 2.6 μmol respectively, being approximately 10 times that under nitrogen. According to electron paramagnetic resonance measurements, singlet oxygen mainly promoted the oxidation of BzOH to BA, which was an important intermediate producing benzene via photocleavage. Odorous alicyclic hydrocarbons were also generated through photorearrangement under nitrogen. On the other hand, the Henry's law constants of the main products were much lower than those of BzOH, indicating that the photoproducts would volatilize from the aqueous phase into the gas phase. The odor threshold of gas-phase products decreased to varying degrees after photoirradiation. Especially for BA, one of the main products, its odor threshold decreased 130 times compared with BzOH. This study shows that the risk of cross-media pollution could significantly increase due to the transformation of aqueous pollutants into odorous VOCs under photoirradiation and provides new insight into its risk prevention.

Study on the Combined Toxicities and Quantitative Characterization of Toxicity Sensitivities of Three Flavor Chemicals and Their Mixtures to Caenorhabditis elegans

It was shown that flavor chemicals with high toxicity sensitivities mean that small changes in their effective concentrations can lead to significant changes in toxicity. Flavors are widely used in personal care products. However, our study demonstrated that some flavor chemicals and their mixture rays have high toxicity sensitivities to Caenorhabditis elegans (C. elegans), which may have an impact on human health. In this paper, three flavor chemicals (benzyl alcohol, phenethyl alcohol, and cinnamaldehyde) were used as components of the mixture, and three binary mixture systems were constructed, respectively. Five mixture rays were designed for each mixture system by a direct equipartition ray design method. The lethal toxicities of the three flavor chemicals and mixture rays to C. elegans at three exposure volumes were determined. A new concept (inverse of the negative logarithmic concentration span (iSPAN)) was introduced to quantitatively evaluate the toxicity sensitivity of chemicals or mixture rays, and the combination index (CI) was employed to identify the toxicological interactions in the mixtures. It was shown that the three flavor chemicals as well as the binary mixture rays have a significant concentration-response relationship on the lethality of C. elegans. The iSPAN values of the three flavor chemicals and their mixture rays were larger than 3.000, showing very strong toxicity sensitivity to C. elegans. In mixture systems, the toxicity sensitivities of mixture rays with different mixture ratios were also different at different exposure volumes. In addition, it can be seen from the CI heat map that the toxicological interaction not only shows the mixture ratio dependence but also changes with the different exposure volumes, which implies that the mixtures consisting of flavor chemicals with high toxicity sensitivity have complex toxicological interactions. Therefore, in environmental risk assessment, special attention should be paid to chemicals with high toxicity sensitivities.

Insights into the Photodegradation of the Contact Allergen Fragrance Cinnamyl Alcohol: Kinetics, Mechanism, and Toxicity

Fragrances can cause general health issues, and special concerns exist surrounding the issue of skin safety. Cinnamyl alcohol (CAL) is a frequent fragrance contact allergen that has various toxic effects on indiscriminate animals. In the present study, the photodegradation transformation mechanism of CAL and toxicity evolution during this process were examined. The results showed that CAL (50 μM) can be completely degraded after 90-min ultraviolet (UV) irradiation with a degradation rate of 0.086 min^-1 . Increased toxicity on bioluminescent bacteria was observed during this process, with lethality increasing from 10.6% (0 min) to 50.2% (90 min) under UV light irradiation. Further, the photodegradation mechanisms of CAL were explored to find the reason behind the increased toxicity observed. Laser flash photolysis and quenching experiments showed that O₂^•- , ¹ O₂ , and ^• OH were mainly responsible for CAL photodegradation, together with ³ CAL* and e_aq^- . The 5 main photodegradation products were cinnamyl aldehyde, benzaldehyde, benzenepropanal, cinnamic acid, and toluene, as identified using gas chromatography-mass spectrometry and liquid chromatography-quadrupole-time-of-flight-mass spectrometry. Once exposed to air, CAL was found to be easily oxidized to cinnamyl aldehyde and subsequently to cinnamic acid by O₂^•- - or ¹ O₂ -mediated pathways, leading to increased toxicity. Benzaldehyde exhibited bioreactive toxicity, increasing the toxicity through ^• OH-mediated pathways. Theoretical prediction of skin irritation indicated that cinnamyl aldehyde (0.83), benzenepropanal (0.69), cinnamyl aldehyde (0.69), and benzaldehyde (0.70) were higher than CAL (0.63), which may cause a profound impact on an individual's health and well-being. Overall, the present study advances the understanding of the photodegradation processes and health impacts of fragrance ingredients. Environ Toxicol Chem 2021;40:2705-2714. © 2021 SETAC.