Independent dose validation system for Gamma Knife radiosurgery, using a DICOM-RT interface and Geant4

Validation of PTV margin for Gamma Knife Icon frameless treatment using a PseudoPatient® Prime anthropomorphic phantom

The Gamma Knife Icon allows the treatment of brain tumors mask-based single-fraction or fractionated treatment schemes. In clinic, uniform axial expansion of 1 mm around the gross tumor volume (GTV) and a 1.5 mm expansion in the superior and inferior directions are used to generate the planning target volume (PTV). The purpose of the study was to validate this margin scheme with two clinical scenarios: (a) the patient's head remaining right below the high-definition motion management (HDMM) threshold, and (b) frequent treatment interruptions followed by plan adaptation induced by large pitch head motion. A remote-controlled head assembly was used to control the motion of a PseudoPatient® Prime head phantom; for dosimetric evaluations, an ionization chamber, EBT3 films, and polymer gels were used. These measurements were compared with those from the Gamma Knife plan. For the absolute dose measurements using an ionization chamber, the percentage differences for both targets were less than 3.0% for all scenarios, which was within the expected tolerance. For the film measurements, the two-dimensional (2D) gamma index with a 2%/2 mm criterion showed the passing rates of ≥87% in all scenarios except the scenario 1. The results of Gel measurements showed that GTV (D₁₀₀ ) was covered by the prescription dose and PTV (D₉₅ ) was well above the planned dose by up to 5.6% and the largest geometric PTV offset was 0.8 mm for all scenarios. In conclusion, the current margin scheme with HDMM setting is adequate for a typical patient's intrafractional motion.

Dosimetric evaluation of the Leksell GammaPlan™ Convolution dose calculation algorithm

The dosimetric accuracy of the Leksell GammaPlan Convolution calculation algorithm was evaluated through comparison with corresponding Monte Carlo (MC) dosimetric results. MC simulations were based on generated sector phase space files for the 4 mm, 8 mm and 16 mm collimator sizes, using a previous comprehensive Gamma Knife Perfexion^™ source model and validated using film dosimetry. Test cases were designed for the evaluation of the Convolution algorithm involving irradiation of homogeneous and inhomogeneous phantom geometries mimicking clinical cases, with radiation fields created using one sector (single sector), all sectors with the same (single shot) or different (composite shot) collimator sizes. Dose calculations using the Convolution algorithm were found to be in excellent agreement (gamma pass rate greater than 98%, applying 1%/1 mm local dose difference and distance agreement criteria), with corresponding MC calculations, indicating the accuracy of the Convolution algorithm in homogeneous and heterogeneous model geometries. While of minor clinical importance, large deviations were observed for the voxels laying inside air media. The calculated beam on times using the Convolution algorithm were found to increase (up to 7%) relative to the TMR 10 algorithm currently used in clinical practice, especially in a test case mimicking a brain metastasis close to the skull, in excellent agreement with corresponding MC calculations.

Development of advanced skin dose evaluation technique using a tetrahedral-mesh phantom in external beam radiotherapy: a Monte Carlo simulation study

Incorrect prediction of skin dose in external beam radiotherapy (EBR) can have normal tissue complication such as acute skin desquamation and skin necrosis. The absorbed dose of skin should be evaluated within basal layer, placed between the epidermis and dermis layers. However, current treatment planning systems (TPS) cannot correctly define the skin layer because of the limitation of voxel resolution in computed tomography (CT). Recently, a new tetrahedral-mesh (TM) phantom was developed to evaluate radiation dose realistically. This study aims to develop a technique to evaluate realistic skin dose using the TM phantom in EBR. The TM phantom was modeled with thin skin layers, including the epidermis, basal layer, and dermis from CT images. Using the Geant4 toolkit, the simulation was performed to evaluate the skin dose according to the radiation treatment conditions. The skin dose was evaluated at a surface depth of 50 µm and 2000 µm. The difference in average skin dose between depths was up to 37%, depending on the thickness and region of the skin to be measured. The results indicate that the skin dose has been overestimated when the skin is evaluated using commercial TPS. Although it is not possible with traditional TPS, our skin dose evaluation technique can realistically express the absorbed dose at thin skin layers from a patient-specific phantom.

Determining the energy spectrum of clinical linear accelerator using an optimized photon beam transmission protocol

PURPOSE

The complex beam delivery techniques for patient treatment using a clinical linear accelerator (linac) may result in variations in the photon spectra, which can lead to dosimetric differences in patients that cannot be accounted for by current treatment planning systems (TPSs). Therefore, precise knowledge of the fluence and energy spectrum (ES) of the therapeutic beam is very important. However, owing to the high energy and flux of the beam, the ES cannot be measured directly, and validation of the spectrum modeled in the TPS is difficult. The aim of this study is to develop an efficient beam transmission measurement procedure for accurately reconstructing the ES of a therapeutic x-ray beam generated by a clinical linac.

METHODS

The attenuation of a 6 MV photon beam from an Elekta Synergy Platform clinical linac through different thicknesses of graphite and lead was measured using an ion chamber. The response of the ion chamber as a function of photon energy was obtained using the Monte Carlo (MC) method in the Geant4 simulation code. Using the curves obtained in the photon beam transmission measurements and the ion chamber energy response, the ES was reconstructed using an iterative algorithm based on a mathematical model of the spectrum. To evaluate the accuracy of the spectrum reconstruction method, the reconstructed ES (ES_recon ) was compared to that determined by the MC simulation (ES_MC ).

RESULTS

The ion chamber model in the Geant4 simulation was well validated by comparing the ion chamber perturbation factors determined by the TRS-398 calibration protocol and EGSnrc; the differences were within 0.57%. The number of transmission measurements was optimized to 10 for efficient spectrum reconstruction according to the rate of increase in the spectrum reconstruction accuracy. The distribution of ES_recon obtained using the measured transmission curves was clearly similar to the reference, ES_MC , and the dose distributions in water calculated using ES_recon and ES_MC were similar within a 2% local difference. However, in a heterogeneous medium, the dose discrepancy between them was >5% when a complex beam delivery technique composed of 171 control points was used.

CONCLUSIONS

The proposed measurement procedure required a total time of approximately 1 h to obtain and analyze 20 transmission measurements. In addition, it was confirmed that the transmission curve of high-Z materials influences the accuracy of spectrum reconstruction more than that of low-Z materials. A well-designed transmission measurement protocol suitable for clinical environments could be an essential tool for better dosimetric accuracy in patient treatment and for periodic verification of the beam quality.