The use of Pantherpix pixel detector in radiotherapy QA

Development of a Real-Time Pixel Array-Type Detector for Ultrahigh Dose-Rate Beams

Although research into ultrahigh dose-rate (UHDR) radiation therapy is ongoing, there is a significant lack of experimental measurements for two-dimensional (2D) dose-rate distributions. Additionally, conventional pixel-type detectors result in significant beam loss. In this study, we developed a pixel array-type detector with adjustable gaps and a data acquisition system to evaluate its effectiveness in measuring UHDR proton beams in real time. We measured a UHDR beam at the Korea Institute of Radiological and Medical Sciences using an MC-50 cyclotron, which produced a 45-MeV energy beam with a current range of 10-70 nA, to confirm the UHDR beam conditions. To minimize beam loss during measurement, we adjusted the gap and high voltage on the detector and determined the collection efficiency of the developed detector through Monte Carlo simulation and experimental measurements of the 2D dose-rate distribution. We also verified the accuracy of the real-time position measurement using the developed detector with a 226.29-MeV PBS beam at the National Cancer Center of the Republic of Korea. Our results indicate that, for a current of 70 nA with an energy beam of 45 MeV generated using the MC-50 cyclotron, the dose rate exceeded 300 Gy/s at the center of the beam, indicating UHDR conditions. Simulation and experimental measurements show that fixing the gap at 2 mm and the high voltage at 1000 V resulted in a less than 1% loss of collection efficiency when measuring UHDR beams. Furthermore, we achieved real-time measurements of the beam position with an accuracy of within 2% at five reference points. In conclusion, our study developed a beam monitoring system that can measure UHDR proton beams and confirmed the accuracy of the beam position and profile through real-time data transmission.

Performance of 3D diamond detectors in small field dosimetry: The impact of pixel size

PURPOSE

Small photon beams used in radiotherapy techniques have inherent characteristics of charge particle disequilibrium and high-dose gradient making accurate dosimetry for such fields very challenging. By means of a 3D manufacturing technique, it is possible to create arrays of pixels with a very small sensitive volume for radiotherapy dosimetry. We investigate the impact of 3D pixels size on absorbed dose sensitivity, linearity of response with dose rate, reproducibility and beam profile measurements.

METHODS

Diamond detectors with different pixel sizes have been produced in the 3DOSE experiment framework. To investigate the pixels size impact, they were tested using an Elekta Synergy LINAC. Dose rate dependence, absorbed dose sensitivity, reproducibility and beam profile measurement accuracy have been investigated and compared with PTW 60019 and IBA SFD reference dosimeters.

RESULTS

All of the 3D pixels had a linear and reproducible response to the dose rate. The sensitivity of a pixel decreases with its size, although even the smallest pixel has a high absorbed dose sensitivity (15 nC/Gy). The penumbra width measured with the smallest pixel size was consistent with the PTW microDiamond and differed by 0.2 mm from the IBA SFD diode.

CONCLUSIONS

The study demonstrates that variation in pixel size do not affect the linearity of response with dose rate and the reproducibility of response. Due to the 3D geometry, the absorbed dose sensitivity of the detector remains high even for the smallest pixel, furthermore the pixel size was demonstrated to be of fundamental importance in the measurement of beam profiles.

Strip detector array (SDA) for beam monitoring in radiotherapy: reconstruction of MLC parameters from multiple projections of flux

Objective:In this paper we propose and investigate a new detector with multiple strip detector arrays (SDA) for monitoring MLC shaped x-ray beams for radiotherapy treatment.Approach:Each SDA measures 1D dose profiles equivalent to dose projections. The goal of such a detector is to determine individual MLC leaf positions as well as the Monitor Units (MU) per MLC segment during radiotherapy. In the present work we investigate an optimal SDA detector configuration and reconstruction algorithm. We determine the accuracy of SDA for different treatment sites (spine, pelvis, retroperitoneum, prostate, brain SRT, SRS, lung and head and neck). We perform a simulation study accounting for different type of MLC leaf positional errors: random MLC leaf, systematic for the whole leaf bank and systematic for an individual leaf. In a similar fashion, we also account for errors in Monitor Units per segment.Main results:We demonstrate that for a broad range of IMRT treatment plans a robust reconstruction of errors is achievable with only 3 projections (3 sets of SDA oriented at at 0◦, 45◦ and 135◦). The SDA is capable of capturing both systematic errors in leaf banks and individual leaves as well as random errors sufficient for practical clinical purposes.Significance:These features of the SDA detector makes it suitable for real-time Quality Control of MLC collimated linac output.