Complex voltammetric and fractal study of adsorbed layer’s structure of pure Triton-X-100 and in mixture with o- or p-nitrophenol

Voltammetric determination of thujone in herbal matrices in the presence of Triton X-100

A simple, sensitive and rapid method of low concentration of thujone determination using Controlled Growth Mercury Drop Electrode and Differential Pulse Voltammetry was described. The reduction of thujone in phosphoric acid or potassium nitrate, involves a quasi-reversible and adsorption-controlled two-electron process. In voltammetric experiments the addition of ethanol and Triton X-100 is recommended. Experimental conditions, such as composition of supporting electrolyte, concentration of Triton X-100 and operation parameters were established. The optimal electrolyte should contain: 0.04 mol L^-1 phosphoric acid (pH = 1.9) or 0.05 mol L^-1 potassium nitrate (pH = 6.4), 0.0002% Triton X-100 and 9.6% ethanol. The calibration graph was linear from 0.7 to 140 mgL^-1 of thujone in H₃PO₄ as supporting electrolyte and from 0.7 to 115 mgL^-1 of the analyte in KNO₃. The detection limit was 0.4 mgL^-1 in H₃PO₄ and 0.6 mgL^-1 in KNO₃, with the correlation coefficient of 0.998. The influence of interfering substances, such as Al(III), Bi(III), Cd(II), Cr(III), Cu(II), Pb(II), Tl(I), V(III) and Zn(II) was studied. The proposed method was validated by the thujone recovery study from the specially prepared spiked herbal matrices and alcohol extract. The considered real sample was thuja oil, in which thujone was successfully determined. All measurements were performed without sample preparation.

Adsorption of cationic surfactants on covered hanging mercury drop electrode surface of variable area

Cetyldimethylbenzylammonium chloride (CDBACl) or cetyltrimethylammonium bromide (CTAB) is preadsorbed on mercury and used as substrate. The adsorptive stripping voltammetry with the two-step procedure is used. The mercury droplet with the preadsorbed surfactant is expanded in aqueous solutions of KCl, KBr, CTAB, CDBACl, or cetylethyldimethylammonium bromide (CEDAB). The surface area was increased from 0.0022cm(2) up to 0.0571cm(2). The surfactant molecules are maintained close to each other and in the vicinity of the electrode by the applied electric field. The expanding of the droplets resulted in a reorientation of the adsorbed molecules depending on the surfactant surface concentration. In some cases, condensed films were observed. Differences were noticed in the adsorption and desorption potential region. A linear increase in the capacitance current with the surface area was found in all cases up to a maximum increase in the surface area. Partly disorganized films were also observed. In some cases, defects were noticed during expansion. In one case, fractal structure was observed.