Study of the formation process and the characteristics of tantalum layers electrodeposited on Nitinol plates in the 1-butyl-1-methylpyrrolidinium bis(trifluoromethylsulfonyl)imide ionic liquid

Ion Release and Surface Characterization of Nanostructured Nitinol during Long-Term Testing

The corrosion resistance of nanostructured nitinol (NiTi) was investigated using long-term tests in solutions simulating physiological fluids at static conditions, reflecting the material structure and metal concentration in the solutions. Mechanical polishing reduced the ion release by a factor of two to three, whereas annealing deteriorated the corrosion resistance. The depassivation and repassivation of nitinol surfaces were considered. We found that nanostructured nitinol might increase the corrosion leaching of titanium into solutions, although the nickel release decreased. Metal dissolution did not occur in the alkaline environment or artificial plasma. A Ni-free surface with a protective 25 nm-thick titanium oxide film resulted from soaking mechanically treated samples of the NiTi wire in a saline solution for two years under static conditions. Hence, the medical application of nanostructured NiTi, such as for the production of medical devices and implants such as stents, shows potential compared with microstructured NiTi.

Selective Electrodeposition of Tantalum(V) Oxide Electrodes

Thin films of TaO_xH_y were cathodically electrodeposited from an aqueous solution containing Ta-IPA precursor and KNO₃ as a sacrificial agent. It was shown that the deposition resulted from a precipitation reaction triggered by the local change of pH at the surface of working electrode. Combined structural and compositional analysis revealed that during the electrodeposition the oxidation state of tantalum remained constant, Ta(V). The as-deposited films are mesoporous amorphous tantalum oxide hydrate films, which can be converted to either pure Ta₂O₅ or Ta₃N₅ by high-temperature annealing in either air (or Ar) or ammonia, respectively. The Ta₃N₅ electrodes exhibited promising PEC activity for water oxidation. These results open the door for the reduced temperature synthesis of Ta₃N₅ electrodes on TCO substrates which would allow for efficient overall solar water splitting.

Electrodeposition in Ionic Liquids

Due to their attractive physico-chemical properties, ionic liquids (ILs) are increasingly used as deposition electrolytes. This review summarizes recent advances in electrodeposition in ILs and focuses on its similarities and differences with that in aqueous solutions. The electrodeposition in ILs is divided into direct and template-assisted deposition. We detail the direct deposition of metals, alloys and semiconductors in five types of ILs, including halometallate ILs, air- and water-stable ILs, deep eutectic solvents (DESs), ILs with metal-containing cations, and protic ILs. Template-assisted deposition of nanostructures and macroporous structures in ILs is also presented. The effects of modulating factors such as deposition conditions (current density, current density mode, deposition time, temperature) and electrolyte components (cation, anion, metal salts, additives, water content) on the morphology, compositions, microstructures and properties of the prepared materials are highlighted.