Insights of close contact between polyaniline and FTO substrate for enhanced photovoltaic performances of dye-sensitized solar cells

Microfluidic-enabled versatile hyphenation of electromembrane extraction and thin film solid phase microextraction

In the present study, a versatile combination of electromembrane extraction (EME) with thin film solid phase microextraction (TF-SPME) was introduced using a microfluidic chip device. The device consisted of two single channels on two separate layers. The upper channel was dedicated to donor phase flow pass, while the beneath channel was used as a reservoir for stagnant acceptor solution. A slide of fluorine doped tin oxide (FTO) was accommodated in the bottom of the acceptor phase channel. A thin layer of polyaniline was electrodeposited on the FTO surface to achieve the required thin film for TF-SPME. A stainless-steel wire was embedded in the donor phase channel and another wire was also attached to the FTO surface. The channels were separated by a piece of polypropylene membrane impregnated with 1-octanol and the whole chip was fixed with bolts and nuts. The driving force for the extraction was an 8 V direct current (DC) voltage applied across the supported liquid membrane (SLM). Under the influence of the electrical field, analytes immigrated from sample towards the acceptor phase and then adsorbed on the thin film of the solid phase. Finally, the analytes were desorbed by successive movement of a desorption solvent in the acceptor phase channel followed by injection of the desorption solution to HPLC-UV. The applicability of the proposed device was demonstrated by the determination of four synthetic food dyes: Amaranth, Ponceau 4R, Allura Red, and Carmoisine, as the model analytes. The effective parameters on the efficiency of the both EME and TF-SPME were investigated. Under the optimized conditions, the microchip provided low LODs (1-10 μg L^-1), and a wide linear dynamic range of 10-1000 μg L^-1 for all analytes. The system also offered RSD values lower than 5.5% and acceptable reusability of the thin film for multiple extractions.

Electropolymerization of Uniform Polyaniline Nanorod Arrays on Conducting Oxides as Counter Electrodes in Dye-Sensitized Solar Cells

Conventional techniques for the synthesis of oriented polyaniline (PANI) nanostructures are often complex or time consuming. Through an innovative reduced graphene oxide (rGO) modified FTO and a low-potential electropolymerization strategy, the rapid and template-free growth of a highly ordered PANI nanorod array on the FTO substrate is realized. The highly ordered nanostructure of the PANI array leads to a high electrocatalytic activity and chemical stability. The importance of the polymerization potential and rGO surface modification to achieve this nanostructure is revealed. Compared to platinum, the PANI nanorod array exhibits an enhanced performance and stability as counter electrodes in dye-sensitized solar cells, with a 17.6 % enhancement in power conversion efficiency.

Reduced energy offset via substitutional doping for efficient organic/inorganic hybrid solar cells

Charge carrier transport in bulk heterojunction that is central to the device performance of solar cells is sensitively dependent on the energy level alignment of acceptor and donor. However, the effect of energy level regulation induced by nickel ions on the primary photoexcited electron transfer and the performance of P3HT/TiO₂ hybrid solar cells remains being poorly understood and rarely studied. Here we demonstrate that the introduction of the versatile nickel ions into TiO₂ nanocrystals can significantly elevate the conduction and valence band energy levels of the acceptor, thus resulting in a remarkable reduction of energy level offset between the conduction band of acceptor and lowest unoccupied molecular orbital of donor. By applying transient photoluminescence and femtosecond transient absorption spectroscopies, we demonstrate that the electron transfer becomes more competitive after incorporating nickel ions. In particular, the electron transfer life time is shortened from 30.2 to 16.7 ps, i.e., more than 44% faster than pure TiO₂ acceptor, thus leading to a notable increase of power conversion efficiency in organic/inorganic hybrid solar cells. This work underscores the promising virtue of engineering the reduction of 'excess' energy offset to accelerate electron transport and demonstrates the potential of nickel ions in applications of solar energy conversion and photon detectors.