Synthesis of 2-amino-4-(4-(methylamino)phenyl)-6-phenylnicotinonitrile as a new additive for the passivation of the TiO2 surface and retarding recombination in dye-sensitized solar cells

Poly(ethylene glycol)–poly(propylene glycol)–poly(ethylene glycol) and polyvinylidene fluoride blend doped with oxydianiline-based thiourea derivatives as a novel and modest gel electrolyte system for dye-sensitized solar cell applications

Unique symmetrical thiourea derivatives with an oxydianiline core were synthesized using cost-effective and simple methods. A new gel electrolyte system was prepared using these thiourea additives along with a highly conductive PEG–PPG–PEG block copolymer, PVDF, and an iodide/triiodide redox couple. The PEG units present in the electrolyte are well-known for their intense segmental motion of ions, which can degrade the recombination rate and favour the charge transfer. The thiourea additives interacted well with the redox couple to limit iodine sublimation and their adsorption induced a negative potential shift for TiO₂. The highest efficiency attained by utilizing such gel polymer electrolytes was 5.75%, especially with 1,1′-(oxybis(4,1-phenylene))bis(3-(6-methylpyridin-2-yl) thiourea) (OPPT), under an irradiation of 100 mW cm⁻². The electrochemical impedance spectroscopy, UV-vis absorption spectroscopy, differential scanning calorimetry, and FTIR spectroscopy data of such gel polymer electrolytes favoured the PCE order of the additives used in DSSCs. The improvement in the DSSC performance with symmetrical thioureas having electron-rich atoms was practically attributed to the reduction of back electron transfer, dye regeneration, and hole transport.

A unique gel polymer electrolyte was prepared using PVDF and PEG–PPG–PEG block copolymer with I⁻/I₃⁻ for DSSC application. This is a cost-effective method used for the synthesis of thiourea additives. The GPE with OPPT thiourea additive achieved a good efficiency of 5.7%.

Improving the effective photovoltaic performance in dye-sensitized solar cells using an azobenzenecarboxylic acid-based system

In this research, an azobenzenecarboxylic acid was used as a sufficient co-adsorbent in combination with N719 dye. As it is found from the results, an optimized concentration of the co-absorbent leads to the highest efficiency. The dye-sensitized solar cells (DSSCs) parameters such as short-circuit current (Jsc), open-circuit voltage (Voc) and conversion efficiency (η) were obtained -14.87 mA/cm2, 0.765 V and 5.20% respectively. Based on the results, the N719/Azobenzenecarboxylic-based system shows a significant increase in Voc and Jsc, resulting in an ∼21% improvement in the efficiency. A higher conversion efficiency for the co-adsorbent-based systems was assigned to their enhanced η, which is attributed to reduced dye aggregation, higher electron injection and increased Voc. This corresponded to the improved electron density in the TiO2 conduction band of the photoanode and reduced charge recombination revealed through electrochemical impedance spectroscopy measurements. Also, evidence was provided for a long charge life time and a high resistance of charge recombination for the co-absorbed solar cells.