Study of the emulsion droplet collisions with the polarizable water/1,2-dichloroethane interface by the open circuit potential measurements

Observing Discrete Blocking Events at a Polarized Micro- or Submicro-Liquid/Liquid Interface

Single-entity collisional electrochemistry (SECE), a subfield of single-entity electrochemistry, enables directly characterizing entities and particles in the electrolyte solution at the single-entity resolution. Blockade SECE at the traditional solid ultramicroelectrode (UME)/electrolyte interface suffers from a limitation: only redox-inactive particles can be studied. The wide application of the classical Coulter counter is restricted by the rapid translocation of entities through the orifice, which results in a remarkable proportion of undetected signals. In response, the blocking effect of single charged conductive or insulating nanoparticles (NPs) at low concentrations for ion transfer (IT) at a miniaturized polarized liquid/liquid interface was successfully observed. Since the particles are adsorbed at the liquid/liquid interface, our method also solves the problem of the Coulter counter having a too-fast orifice translocation rate. The decreasing quantal staircase/step current transients are from landings (controlled by electromigration) of either conductive or insulating NPs onto the interface. This interfacial NP assembly shields the IT flux. The size of each NP can be calculated by the step height. The particle size measured by dynamic light scattering (DLS) is used for comparison with that calculated from electrochemical blocking events, which is in fairly good agreement. In short, the blocking effect of IT by single entities at micro- or submicro-liquid/liquid interface has been proven experimentally and is of great reference in single-entity detection.

The Microelectrode Insulator Influences Water Nanodroplet Collisions

Studying chemical reactions in very small (attoliter to picoliter) volumes is important in understanding how chemistry proceeds at all relevant scales. Stochastic electrochemistry is a powerful tool to study the dynamics of single nanodroplets, one at a time. Perhaps the most conceptually simple experiment is that of the current blockade, where the collision of an insulating particle is observed electrochemically as a stepwise decrease in current. Here, we demonstrate that nanodroplet collisions on microelectrodes are not as simple as water droplets adsorbing to the electrode to block current and that the environment immediately around the microelectrode (glass insulator) plays a pivotal role in the electrochemical collision response. We use correlated opto-electrochemical measurements to understand a variety of electrochemical responses when water nanodroplets collide with a microelectrode during the heterogeneous oxidation of decamethylferrocene in oil. The amperometric current reports not only on current blockades but also on nanodroplet coalescence events and preferential wetting to the glass around the microelectrode. Treating the glass with dichlorodimethylsilane creates a hydrophobic environment around the working electrode, and the simple current blockade response expected from the absorption of insolating nanoparticles is observed. These results highlight the importance of the environment around the working electrode for nanodroplet collision studies.

Lipid-based liquid crystalline materials in electrochemical sensing and nanocarrier technology

Some biologically active substances are unstable and poorly soluble in aqueous media, at the same time exhibiting low bioavailability. The incorporation of these biologically active compounds into the structure of a lipid-based lyotropic liquid crystalline phase or nanoparticles can increase or improve their stability and transport properties, subsequent bioavailability, and applicability in general. The aim of this short overview is (1) to clarify the principle of self-assembly of lipidic amphiphilic molecules in an aqueous environment and (2) to present lipidic bicontinuous cubic and hexagonal phases and their current biosensing (with a focus on electrochemical protocols) and biomedical applications.

Galvani Potential-Dependent Single Collision/Fusion Impacts at Liquid/Liquid Interface: Faradic or Capacitive?

A new subtype of nano-impacts by emulsion droplets via reorganization of the electric double layer (EDL) at the liquid/liquid interface (LLI) is reported. This subtype shows anodic, bipolar, and cathodic transient currents with a potential of zero charge (PZC) dependence, revealing the non-faradic characteristic of single fusion impacts. In addition, the absolute integrated mean charge is proportional to the Galvani potential at the ITIES, indicating that the EDL at the LLI may obey the discrete Helmholtz model. The exact PZC point is interpolated from the fitting curve, and the droplet size distribution is estimated from the integrated charge distribution. Moreover, the different values of E_pzc between single fusion impacts of MgCl₂ droplets and pure water droplets is due to the specific absorption between Mg²⁺ and antagonistic anion in the organic phase. The influence of the concentration of the supporting electrolyte is also investigated. The above work gives physicochemical insights into the EDL at the micropipette-supported LLI and provides potential application to measure micro/nanoscale heterogeneous media without catalytic, reactive, or charge-transfer activity via impact experiments at LLI.

Electrochemistry under confinement

Although the term 'confinement' regularly appears in electrochemical literature, elevated by continuous progression in the research of nanomaterials and nanostructures, up until today the various aspects of confinement considered in electrochemistry are rather scattered individual contributions outside the established disciplines in this field. Thanks to a number of highly original publications and the growing appreciation of confinement as an overarching link between different exciting new research strategies, 'electrochemistry under confinement' is the process of forming a research discipline of its own. To aid the development a coherent terminology and joint basic concepts, as crucial factors for this transformation, this review provides an overview on the different effects on electrochemical processes known to date that can be caused by confinement. It also suggests where boundaries to other effects, such as nano-effects could be drawn. To conceptualize the vast amount of research activities revolving around the main concepts of confinement, we define six types of confinement and select two of them to discuss the state of the art and anticipated future developments in more detail. The first type concerns nanochannel environments and their applications for electrodeposition and for electrochemical sensing. The second type covers the rather newly emerging field of colloidal single entity confinement in electrochemistry. In these contexts, we will for instance address the influence of confinement on the mass transport and electric field distributions and will link the associated changes in local species concentration or in the local driving force to altered reaction kinetics and product selectivity. Highlighting pioneering works and exciting recent developments, this educational review does not only aim at surveying and categorizing the state-of-the-art, but seeks to specifically point out future perspectives in the field of confinement-controlled electrochemistry.

Faradaic Counter for Liposomes Loaded with Potassium, Sodium Ions, or Protonated Dopamine

Collisional electrochemistry between single particles and a biomimetic polarized micro-liquid/liquid interface has emerged as a novel and powerful analytical method for measurements of single particles. Using this platform, rapid detection of liposomes at the single particle level is reported herein. Individual potassium, sodium, or protonated dopamine-encapsulated (pristine or protein-decorated) liposomes collide and fuse with the polarized micro-liquid/liquid interface accompanying the release of ions, which are recorded as spike-like current transients of stochastic nature. The sizing and concentration of the liposomes can be readily estimated by quantifying the amount of encapsulated ions in individual liposomes via integrating each current spike versus time and the spike frequency, respectively. We call this type of nanosensing technology "Faradaic counter". The estimated liposome size distribution by this method is in line with the dynamic light scattering (DLS) measurements, implying that the quantized current spikes are indeed caused by the collisions of individual liposomes. The reported electrochemical sensing technology may become a viable alternative to DLS and other commercial nanoparticle analysis systems, for example, nanoparticle tracking analysis.

Dynamics of Collisions and Adsorption in the Stochastic Electrochemistry of Emulsion Microdroplets

Current-time recordings of emulsified toluene microdroplets containing 20 mM Ferrocene (Fc), show electrochemical oxidation peaks from individual adsorption events on disk microelectrodes (5 μm diameter). The average droplet diameter (∼0.7 μm) determined from peak area integration was close to Dynamic Light Scattering measurements (∼1 μm). Random walk simulations were performed deriving equations for droplet electrolysis using the diffusion and thermal velocity expressions from Einstein. The simulations show that multiple droplet-electrode collisions, lasting ∼0.11 μs each, occur before a droplet wanders away. Updating the Fc-concentration at every collision shows that a droplet only oxidizes ∼0.58% of its content in one collisional journey. In fact, it would take ∼5.45 × 10⁶ collisions and ∼1.26 h to electrolyze the Fc in one droplet with the collision frequency derived from the thermal velocity (∼0.52 cm/s) of a 1 μm-droplet. To simulate adsorption, the droplet was immobilized at first contact with the electrode while the electrolysis current was computed. This approach along with modeling of instrumental filtering, produced the best match of experimental peaks, which were attributed to electrolysis from single adsorption events instead of multiple consecutive collisions. These results point to a heightened sensitivity and speed when relying on adsorption instead of collisions. The electrochemical current for the former is limited by the probability of adsorption per collision, whereas for the latter, the current depends on the collision frequency and the probability of electron transfer per collision (J. Am. Chem. Soc. 2017, 139, 16923-16931).

Ionosomes: Observation of Ionic Bilayer Water Clusters

Emulsification of immiscible two-phase fluids, i.e., one condensed phase dispersed homogeneously as tiny droplets in an outer continuous medium, plays a key role in medicine, food, chemical separations, cosmetics, fabrication of micro- and nanoparticles and capsules, and dynamic optics. Herein, we demonstrate that water clusters/droplets can be formed in an organic phase via the spontaneous assembling of ionic bilayers. We term these clusters ionosomes, by analogy with liposomes where water clusters are encapsulated in a bilayer of lipid molecules. The driving force for the generation of ionosomes is a unique asymmetrical electrostatic attraction at the water/oil interface: small and more mobile hydrated ions reside in the inner aqueous side, which correlate tightly with the lipophilic bulky counterions in the adjacent outer oil side. These ionosomes can be formed through electrochemical (using an external power source) or chemical (by salt distribution) polarization at the liquid-liquid interface. The charge density of the cations, the organic solvent, and the synergistic effects between tetraethylammonium and lithium cations, all affecting the formation of ionosomes, were investigated. These results clearly prove that a new emulsification strategy is developed providing an alternative and generic platform, besides the canonical emulsification procedure with either ionic or nonionic surfactants as emulsifiers. Finally, we also demonstrate the detection of individual ionosomes via single-entity electrochemistry.

Ion Selective Detection Based on the Nuances of the Kinetic Fingerprint for Ion Transfer at Soft Interfaces

A novel approach has been developed for the selective determination of cations or anions based on the application of Fourier transformed staircase sinusoidal voltammetry (FT-SC-SV) in combination with the interface between two immiscible electrolyte solutions (ITIES) in the four-electrode configuration. The electrochemistry at the ITIES provides a very simple yet sensitive platform for the detection of a broad spectrum of redox inactive ions and even the neutral (bio)molecules that can be charged (e.g., protonated in appropriate pH). FT-SC-SV employs a complex potential excitation, i.e., a large-amplitude sine wave superimposed onto a dc bias potential that is stepped/scanned throughout the potential window. The response current is subsequently analyzed in the frequency domain by FT. Although the ions have close standard/formal transfer potential, discrimination and selective detection can be achieved by the higher harmonics. Feasibility and reliability of the proposed approach were verified with two pairs of ions that have very close transfer potentials across the ITIES and were chosen as the model systems. Besides, the additivity of the ionic current magnitude on concentration measured either in the mixture of ionic analytes or in individually prepared solutions containing the separate ionic analyte was tested. The experimental results prove that the principle of additivity holds. Compared with the traditional voltammetry, FT-SC-SV is simpler and more efficient in discrimination and quantification of apparently indistinguishable ion transfer from the viewpoint of thermodynamics. This demonstration may provide a new way for analytical detection of a broad range of redox inactive ions in terms of both fundamentals and applications.

Potentiometric Biosensing of Ascorbic Acid, Uric Acid, and Cysteine in Microliter Volumes Using Miniaturized Nanoporous Gold Electrodes

Potentiometric redox sensing is a relatively inexpensive and passive approach to evaluate the overall redox state of complex biological and environmental solutions. The ability to make such measurements in ultra-small volumes using high surface area, nanoporous electrodes is of particular importance as such electrodes can improve the rates of electron transfer and reduce the effects of biofouling on the electrochemical signal. This work focuses on the fabrication of miniaturized nanoporous gold (NPG) electrodes with a high surface area and a small footprint for the potentiometric redox sensing of three biologically relevant redox molecules (ascorbic acid, uric acid, and cysteine) in microliter volumes. The NPG electrodes were inexpensively made by attaching a nanoporous gold leaf prepared by dealloying 12K gold in nitric acid to a modified glass capillary (1.5 mm id) and establishing an electrode connection with copper tape. The surface area of the electrodes was ~1.5 cm², providing a roughness factor of ~16 relative to the geometric area of 0.09 cm². Scanning electron microscopy confirmed the nanoporous framework. A linear dependence between the open-circuit potential (OCP) and the logarithm of concentration (e.g., Nernstian-like behavior) was obtained for all three redox molecules in 100 μL buffered solutions. As a first step towards understanding a real system, the response associated with changing the concentration of one redox species in the presence of the other two was examined. These results show that at NPG, the redox potential of a solution containing biologically relevant concentrations of ascorbic acid, uric acid, and cysteine is strongly influenced by ascorbic acid. Such information is important for the measurement of redox potentials in complex biological solutions.