Efficiency enhancement of solid-state dye-sensitized solar cells by doping polythiophene films photoelectrochemically grown onto TiO2 nanoparticles covered with cis-bis(isothiocyanato) bis(2,2′-bipyridyl-4,4′-dicarboxylato)ruthenium(II)

Study of the Electronic Interaction between NiO and Short Polythiophene Chains towards Solar Photon Harvesting

The sustainable production of energy is a field of interest to which a new requirement is now imposed: the need to be respectful of the environment. New materials and techniques are being developed, but environmental concerns impose the necessity of keeping research active towards the development of green energy. For this reason, we present the study of short polythiophene (PTh) chains (three and five monomers) and their interaction with nickel oxide, looking for properties related to solar photon harvesting in order to produce electricity. The models of the molecules were developed, and the calculations were performed with an M11-L meta-GGA functional, specially developed for electronic structure calculations. The theoretical explorations demonstrated that the geometry of the PTh molecules suffer little distortion when interacting with the NiO molecule. The calculated value of E_g lies between 2.500 and 0.412 eV for a three-ring PTh chain and between 1.944 and 0.556 eV for a five-ring PTh chain. The chemical parameters indicated that, depending on the geometry of the system, the chemical potential varies from 81.27 to 102.38 kcal/mol and the highest amount of electronic charge varies from -2.94 to 21.56 a.u. for three-monomer systems. For five-monomer systems, the values lie within similar ranges as those of the three-monomer systems. The Partial Density of States (PDOS) showed that the valence and conduction electronic bands were composed of states in the NiO and PTh rings, except for a system where there was a non-bonding interaction.

A New Type of Architecture of Dye-Sensitized Solar Cells as an Alternative Pathway to Outdoor Photovoltaics

The current investigation shows a possible new pathway for more efficient and cost-effective energy-harvesting photovoltaic devices. Our approach could permit all emerging technologies that are currently used for indoors and smart buildings to go a step forward and could be used for outdoor applications. The investigated architecture is a very promising geometry especially for Dye-Sensitized Solar Cells (DSSCs). It turns their main drawback, the lowering of their efficiency and lifetime when operating at high solar irradiation density, into an asset by increasing the total active area per horizontal unit area for light harvesting, while preserving the active elements from degradation and extending durable lifetime. The investigated architecture is based on a symmetric “U” type geometry, which is constructed by a highly reflective material on the inner surface. Solar irradiation is reflected internally at the bottom of the construction and splits towards two opposite sided solar cells; the two cells form a cavity where the solar light multiplies and is successively absorbed. Consequently, the vertically incoming irradiation is reduced when reaching the vertical internal sides on which the DSSCs are mounted. Thus, the solar cells operate at low light intensities, which provide significant lifetime extension and efficiency enhancement. Interestingly, the electrical energy per effective surface unit, which is produced by the two vertical DSSCs, is at least equal to that of a standalone, vertically irradiated cell. The advantage of the new architecture is that protects DSSCs from their degradation and deterioration, although the entire system operates under high illumination. This makes the cells more efficient outdoors, with a comparable performance to indoor conditions.