Constructing an efficient conductive network with carbon-based additives in metal hydroxide electrode for high-performance hybrid supercapacitor

Bifunctional Fluorocarbon Electrode Additive Lowers the Salt Dependence of Aqueous Electrolytes

The solid electrolyte interphase (SEI) plays a crucial role in extending the life of aqueous batteries. The traditional anion-derived SEI formation in aqueous electrolytes highly depends on high-concentrated organic fluorinating salts, resulting in low forming efficiency and long-term consumption. In response, this study proposes a bifunctional fluorocarbon electrode additive (BFEA) that enables electrochemical pre-reduction instead of TFSI anion to form the LiF-rich SEI and in situ produce conductive graphite inside the anode before the lithiation. The BFEA lowers the salt dependence of aqueous electrolytes, enabling the inorganic LiCl electrolyte to work first, but also successfully achieves a high SEI formation efficiency in the relatively low 10 m LiTFSI without mass transfer concerns, suppressing the parasitic hydrogen evolution from 11.24 to 4.35 nmol min-1. Besides, BFEA strengthens the intrinsic superiority of Li storage reaction by lowering battery polarization resulting from the in situ production of graphite, promoting charge transfer of electrode kinetics. Compared with the control group, the demonstrated Ah-level pouch cell employing BFEA exhibits better cycle stability above 300 cycles with higher capacity retention of 78.2% and the lower decay of the round-trip efficiency (△RTE = 2%), benefiting for maintaining the high efficiency and reducing heat accumulation in large-scale electric energy storage.

Activated carbons derived from polyethylene terephthalate for coin-cell supercapacitor electrodes

We successfully prepared activated carbon derived from polyethylene terephthalate (PET) via carbonization and subsequent activation under various conditions and applied it as active material for supercapacitors. In the activation, we used CO2 for physical activation or KOH for chemical activation and varied the activation temperature from 600 °C to 1,000 °C. We found that CO2 activation is unsuitable because of insufficient pore formation or low activation yield. Interestingly, PET-derived activated carbon obtained using KOH (PETK) at 700 °C-900 °C exhibited higher specific surface areas than YP50f, which is a commercial activated carbon. Furthermore, some PETKs even displayed a dramatic increase in crystallinity. In particular, the PET-derived activated carbon prepared at 900 °C with KOH (PETK900) had the highest retention rate at a high charge-discharge rate and better durability after 2500 cycles than YP50f. Furthermore, employing the same process that we used with the PET chips, we successfully converted waste PET bottles into activated carbon materials. Waste PET-derived activated carbons exhibited good electrochemical performance as active material for supercapacitors. We thus found chemical activation with KOH to be an appropriate method for manufacturing PET-derived activated carbon and PETKs derived both from PET chips and waste PET have considerable potential for commercial use as active materials for supercapacitors.

Electronic Supplementary Material

Supplementary material is available for this article at 10.1007/s11814-023-1466-3 and is accessible for authorized users.