Co1-xS/Co3S4@N,S-co-doped agaric-derived porous carbon composites for high-performance supercapacitors

Study on the effect of sodium removal from citric acid pretreated red mud on the physical properties of red mud

Red mud is a highly alkaline solid waste discharged from the alumina industry, and its high sodium content is the key factor limiting its wide utilization. Therefore, effective control of the "frosting" phenomenon during the application of red mud has received significant attention. In this study, the changes of particle size, phase, morphology, and pore size of red mud after sodium removal with different amounts of citric acid pretreatment were investigated. The single-factor experiment shows that the Na+ leaching rate is 86.33% under a citric acid dosage of 15%, liquid-to-solid ratio of 7 mL/g, leaching temperature of 80 °C, stirring speed of 300 rpm, and leaching time of 10 min. The leachate is characterized through X-ray diffraction (XRD), scanning electron microscopy (SEM), and Brunauer-Emmett-Teller (BET) surface area analysis. The results reveal that Na+ mainly exists in a combined state in the form of cancrinite. With the increase of citric acid dosage, red mud agglomerates, calcite, and cancrinite are dissolved, and new phases such as calcium oxalate and magnesium aluminum hydroxide are formed. The specific surface area, pore volume, and pore diameter show irregular changes with the increase in the citric acid dosage. Citric acid pretreatment can effectively reduce the sodium content in red mud, the treatment cost of leaching solution is low, and the leaching residue is neutral, which is helpful to promote the practical application of red mud.

Fabrication of Co3O4/Co3S4/CNTs for photocatalytic treatment of wastewater under xenon lamp

The current study is about the synthesis of nanoparticles (NPs) of cobalt oxide (CO) and cobalt sulfide (CS) followed by their nanocomposites as CO/CS and CO/CS/CNT by ultrasonication approach. The addition of carbon-based materials in the oxides and sulfides enhances their performance by developing physico-chemical interactions. Prepared NPs were utilized for the photodegradation of organic contaminants. The characteristics, as well as the efficiency of the prepared samples, have been systematically examined by X-ray diffraction (XRD) technique, Fourier transform infrared spectroscopy (FTIR), and UV-vis spectroscopy. Photocatalytic activities of bare samples and synthesized nanocomposites were tested for the degradation of methyl orange (MO) using a xenon lamp. The percentage degradation of dye was 24.14%, 57.94%, 71.66%, and 85.04% in the presence of CO, CS, CO/CS, and CO/CS/CNT, respectively. Crystal violet (CV), Rhodamine B (rho-B), and industrial wastewater were also degraded by the ternary composite. The comparative studies showed the best performance of CO/CS/CNT, which enhanced the generation of electron-hole pairs by absorption of photons of incoming radiations, increased charge separation, and maximum surface area for adsorption.