Which surgical approach is optimal for joint preparation in talonavicular fusion - A cadaver study

Anatomical Structures at Risk in Percutaneous Preparation Talonavicular Fusion

BACKGROUND

The stability of the hindfoot greatly relies on the integrity of the talonavicular joint. Pathologies affecting this joint often necessitate fusion. Our study explores the risks posed to neurovascular and tendon structures during simulated percutaneous talonavicular joint preparation for fusion.

METHODS

In 9 fresh cadaver specimens, the talonavicular joint was accessed through two portals. A 2-mm Shannon burr was employed for joint surface preparation with distraction provided by a pin-based distractor. Dissections were performed to assess potential damage to critical structures, including the dorsalis pedis artery, superficial and deep peroneal nerves, extensor hallucis longus (EHL), and tibialis anterior (TA) tendons.

RESULTS

The dorsal portal site was found to be significantly closer to important structures compared to the medial portal site. The Shannon burr made contact with various structures, with a single transection identified for both deep and superficial peroneal nerve branches. During the dorsal portal site approach, potential injury to the EHL tendon was identified as concern.

CONCLUSION

This study sheds light on the potential risks associated with percutaneous dorsal and medial joint preparation approaches using a Shannon burr.Level of Evidence:Level V, mechanism-based reasoning..

Reaming for Tibiotalocalcaneal Nailing Removes Only 10% of the Ankle and Subtalar Joints

OBJECTIVES

Tibiotalocalcaneal (TTC) nailing in the setting of acute ankle trauma has become increasingly popular. No consensus exists as to whether formal joint preparation is necessary, although there is some concern that residual motion at unprepared joints may lead to implant loosening and/or breakage. The objective of this study was to quantify the proportion of tibiotalar and subtalar articular surface destruction that occurs during reaming for TTC nail fixation.

METHODS

Twelve cadaver lower extremities were procured. The specimens were pinned into neutral ankle and hindfoot alignment. A guidewire was inserted under fluoroscopy, followed by a 12-mm opening reamer. The specimens were then dissected, exposing the tibial plafond, talar dome, posterior facet of the talus, and posterior facet of the calcaneus. Images of each joint were obtained, and ImageJ software was used to calculate the total joint surface area and the area of articular destruction.

RESULTS

The mean proportion of articular cartilage destruction was 9.3%, 10.3%, 8.9%, and 10.3% for the tibial plafond, talar dome, posterior facets of the talus, and posterior facets of the calcaneus, respectively. No joint destruction was observed in the middle facets of the subtalar joint.

CONCLUSIONS

Reaming for TTC nail placement violates approximately 10% of each articular surface of the tibiotalar and subtalar joints. Retention of 90% of the articular surface may allow for residual motion at the joints and therefore potentially substantial stress on the implant. Formal joint preparation for the purposes of achieving fusion during TTC nail placement may be beneficial to prevent implant loosening or breakage.

Retrograde tibiotalocalcaneal nailing for the treatment of acute ankle fractures in the elderly: a systematic review and meta-analysis

Introduction

Methods

Results

Conclusion