Influence of varying oil phase volume fractions on the characteristics of flaxseed-derived diglyceride-based Pickering emulsions stabilized by modified soy protein isolate

Influence of flaxseed-derived diglyceride-based high internal phase Pickering emulsions on the rheological and physicochemical properties of myofibrillar protein gels

The study aimed to investigate the influence of flaxseed-derived diglyceride-based high internal phase Pickering emulsions (HIPPE) at different levels (0%, 10%, 20%, 30%, 40%, and 50%) on the rheological and physicochemical properties of myofibrillar protein (MPs) gels. The study indicated that with increasing HIPPE levels, there was a significant increase in whiteness while a decrease in water-holding capacity. The gels with 10% HIPPE levels had higher ionic bonds, while those with 40% and 50% HIPPE levels showed higher hydrogen bonds. By increasing HIPPE levels in the formation of MP gels, the T2 relaxation time was found to decrease. Additionally, in all MP gels, G' values were significantly higher than G" values over time. Adding lower contents of HIPPE levels resulted in a more compact microstructure. These findings indicate that flaxseed-derived diglyceride-based HIPPEs could be utilized as fat substitutes in meat products to enhance their nutritional quality.

Ultrasonic enhancement of structural and emulsifying properties of heat-treated soy protein isolate nanoparticles to fabricate flaxseed-derived diglyceride-based pickering emulsions

Flaxseed-derived diglyceride (DAG)-based Pickering emulsions were fabricated using soy protein isolate (SPI) nanoparticles as stabilizer. The SPI nanoparticles were prepared under the combined action of heating and ultrasound treatment. The SPI nanoparticles exposed to 600 W power exhibited the smallest particle size (133.36 nm) and zeta potential (-34.77 mV). Ultrasonic treatment did not significantly impact the polypeptide chain's primary structure but induced changes in the secondary structure. The Pickering emulsions stabilized with ultrasound-treated SPI nanoparticles showed smaller particle size, lower zeta potential, and improved emulsifying properties. Notably, at 450 W power, these emulsions showed a higher solid-liquid balance, reduced mean square displacement, backscattering fluctuations, and turbiscan stability index. Besides, they displayed a more compact microstructure with smaller droplets. In conclusion, SPI subjected to heating and 450 W ultrasound power resulted in the fabrication of DAG-based Pickering emulsions with enhanced microstructure and stability.

Effect of flaxseed-derived diglyceride-based high internal phase Pickering emulsion on the quality characteristics of reformulated beef burgers

The study aimed to fabricate healthier beef burgers using high internal phase Pickering emulsion (HIPPE) as animal fat substitute. In this context, HIPPE stabilized by modified soy protein isolates was produced with flaxseed-derived diglycerides (DAGs). Beef burgers were prepared by substituting beef backfat with HIPPE at varying levels (0%, 25%, 50%, 75%, and 100%). Reformulated burgers showed a significant decrease in WHC (from 89.75 to 77.38%), pH (from 5.73 to 5.58), L* values (from 53.5 to 44.5), and b* values (22.9 to 21.8), while a significant increase in a* values (from 24.4 to 6.7), cooking loss (from 20.25 to 30.62), and cooking shrinkage (from 11.27 to 13.05). Texture attributes, including hardness, chewiness, and gumminess, decreased up to 50% fat substitution and increased with increasing levels of fat substitution. Moreover, the rheological properties (G' and G'') and T2 relaxation time were increased with increasing fat replacement. The reformulation with HIPPE resulted in a decrease in SFA (from 3896 to 1712 mg/100 g), ω-6/ω-3 ratio (from 5.29 to 0.47), atherogenic index (from 0.57 to 0.13), and thrombogenic index (from 1.46 to 0.15) and increase in PUFA/SFA ratio (from 0.20 to 2.79). Notably, burgers with 50% fat substitution were more preferred regarding tenderness, while those with 100% fat substitution obtained higher scores for color and flavor than all other treatments. In conclusion, 50% fat replacement using flaxseed-derived diglyceride-based HIPPE improved beef burgers' textural profile and fatty acid composition without compromising the sensory characteristics.