Analysis of fatty acids in ecstasy tablets

The fabrication of a novel polyacrylonitrile/reduced graphene oxide-amino-halloysite/bimetallic metal–organic framework electrospun nanofiber adsorbent for the ultrasonic-assisted thin-film microextraction of fatty acid methyl esters in dairy products with gas chromatography-flame ionization detection

In this work, electrospun polyacrylonitrile/reduced graphene oxide-amino-halloysite/bimetallic metal–organic framework (PAN/rGO-amino-HNT/Co_0.5Zn_0.5(MeIm)₂) nanofiber film was synthesized and investigated as a novel adsorbent for the ultrasonic-assisted thin-film microextraction (UA-TFME) of fatty acid methyl esters (FAMEs), including palmitic methyl ester (PAME), oleic methyl ester (OAME), stearic methyl ester (SAME), and linoleic methyl ester (LAME), from dairy products. The hybrid nanocomposite was obtained via bonding halloysite nanotubes to reduced graphene oxide, followed by loading with bimetallic metal–organic frameworks. The determination of FAMEs with nanofiber film was performed in two stages of desorption and absorption where, initially, the analytes were adsorbed onto the nanofiber film and then desorbed with organic solvent. In this study, ultrasound was used for both the adsorption and desorption stages. The advantages of ultrasonication are extensive, overcoming the shortcomings of conventional techniques in terms of energy consumption and solvent use, allowing a shorter treatment time with a low cost of implementation. Based on PAN/rGO-amino-HNT/Co_0.5Zn_0.5(MeIm)₂ thin film, a microextraction-gas chromatography-flame ionization detection (TFME-GC-FID) method was developed. Experimental parameters affecting the extraction and desorption steps were optimized. The desorption parameters, including desorption time and the properties of the desorption solvent, were investigated one factor at a time. Then, effective parameters in the adsorption step were optimized using a Box–Behnken design and Design-Expert 7 software. Under the optimal conditions, the method detection limits (S/N = 3) were in the range of 0.03–0.06 μg L⁻¹ and the limits of quantification (S/N = 10) were within 0.11–0.23 μg L⁻¹. The relative standard deviations for intra-day and inter-day precision were 2.4–4.7% and 2.6–3.4%, respectively. In the present work, the UA-TFME method was successfully applied for the quantification of fatty acid methyl esters in dairy products (milk, yogurt, cheese, yogurt soda and butter samples) for the first time. The fatty acids were transesterified using standard procedures and were subjected to UA-TFME treatment prior to GC-FID determination. The developed method possesses the advantages of simplicity, rapidity, cost-effectiveness, sensitivity, and non-invasiveness.

Electrospun polyacrylonitrile/reduced graphene oxide-amino-halloysite/bimetallic metal–organic framework nanofiber film was synthesized and successfully applied to the ultrasonic-assisted thin-film microextraction (UA-TFME) of fatty acid methyl esters from dairy products.

Development of microwave-assisted extraction procedure for organic impurity profiling of seized 3,4-methylenedioxymethamphetamine (MDMA)

Organic impurity profiling of seized 3,4-methylenedioxymethamphetamine (MDMA) tablets aims to link tablets to common production sources. Conventionally, organic impurities are extracted from tablets using a liquid-liquid extraction (LLE) procedure prior to analysis by gas chromatography-mass spectrometry (GC-MS). In this research, the development of an alternative microwave-assisted extraction/headspace solid-phase microextraction (MAE/HS-SPME) procedure is described. The optimal procedure used phosphate buffer (1 M, pH 8), with an HS-SPME extraction temperature of 70 °C for 40 min, using a divinylbenzene/Carboxen™/polydimethylsiloxane (DVB/CAR/PDMS) fiber. Impurities were extracted from seized MDMA exhibits using the MAE/HS-SPME procedure, as well as HS-SPME alone, and a conventional LLE procedure. The HS-SPME procedure was deemed to be the most practical because of the affordability and need for less analyst involvement. Although the LLE was limited in the number of impurities extracted, the procedure is still useful for the extraction of less volatile impurities that are not extracted by HS-SPME.