Facile one step synthesis method of spinel LiMn2O4 cathode material for lithium batteries

Efficient enhancement on crystallization and electrochemical performance of LiMn2O4 by recalcination treatment

Spinel LiMn₂O₄ cathode material was obtained by a recalcination treatment, which exhibits excellent crystallization and electrochemical performance. A series of test and analysis results revealed that the performance enhancement of as-prepared sample is related to the crystal structure, morphology and electrochemical properties. Owing to the recalcination treatment, the spinel LiMn₂O₄ presents a truncated-octahedral morphology with selective growth of the (110) and (100) crystal planes, which would effectively inhibit manganese dissolution. Moreover, the optimized sample exhibits a better crystallinity and electrochemical reversibility than that of pristine sample, which can provide a faster Li ion de-intercalation/intercalation kinetics. Hence, the spinel LiMn₂O₄ cathode material delivers a high initial discharge capacity of 112.3 mAh·g^-1 with a good capacity retention of 90.3% after 500 cycles and an excellent rate performance. This study constructed a facile and meaningful method to prepare spinel LiMn₂O₄ cathode material, which may facilitate the development of lithium-ion batteries.

Structural and Electrochemical Properties of the High Ni Content Spinel LiNiMnO4

This work presents a contribution to the study of a new Ni-rich spinel cathode material, LiNiMnO4, for Li-ion batteries operating in the 5-V region. The LiNiMnO4 compound was synthesized by a sol-gel method assisted by ethylene diamine tetra-acetic acid (EDTA) as a chelator. Structural analyses carried out by Rietveld refinements and Raman spectroscopy, selected area electron diffraction (SAED) and X-ray photoelectron (XPS) spectroscopy reveal that the product is a composite (LNM@NMO), including non-stoichiometric LiNiMnO4-δ spinel and a secondary Ni6MnO8 cubic phase. Cyclic voltammetry and galvanostatic charge-discharge profiles show similar features to those of LiNi0.5Mn1.5O4 bare. A comparison of the electrochemical performances of 4-V spinel LiMn2O4 and 5-V spinel LiNi0.5Mn1.5O4 with those of LNM@NMO composite demonstrates the long-term cycling stability of this new Ni-rich spinel cathode. Due to the presence of the secondary phase, the LNM@NMO electrode exhibits an initial specific capacity as low as 57 mAh g−1 but shows an excellent electrochemical stability at 1C rate for 1000 cycles with a capacity decay of 2.7 × 10−3 mAh g−1 per cycle.

Ag-Modified LiMn2O4 Cathode for Lithium-Ion Batteries: Coating Functionalization

In this work, the properties of silver-modified LiMn2O4 cathode materials are revisited. We study the influence of calcination atmosphere on the properties of the Ag-coated LiMn2O4 (Ag/LMO) and highlight the silver oxidation. The effect of the heat treatment in vacuum is compared with that in air by the characterization of the structure, specific surface area, Li transport properties and electrochemical performance of Ag/LMO composites. Surface analyses (XPS and Raman spectroscopy) show that the nature of the coating (~3 wt.%) differs with the calcination atmosphere: Ag/LMO(v) calcined in vacuum displays Ag nanospheres and minor AgO content on its surface (specific surface area of 4.1 m2 g−1), while Ag/LMO(a) treated in air is mainly covered by the AgO insulating phase (specific surface area of 0.6 m2 g−1). Electrochemical experiments emphasize that ~3 wt.% Ag coating is effective to minimize the drawbacks of the spinel LiMn2O4 (Mn dissolution, cycling instability, etc.). The Ag/LMO(v) electrode shows high capacity retention, good cyclability at C/2 rate and capacity fade of 0.06% per cycle (in 60 cycles).

Kinetic and Thermodynamic Studies on Synthesis of Mg-Doped LiMn2O4 Nanoparticles

In this work, a first study on kinetics and thermodynamics of thermal decomposition for synthesis of doped LiMn₂O₄ nanoparticles is presented. The effect of Mg doping concentration on thermal decomposition of synthesis precursors, prepared by ultrasound-assisted Pechini-type sol–gel process, and its significance on nucleation and growth of Mg-doped LiMn₂O₄ nanoparticles was studied through a method based on separation of multistage processes in single-stage reactions by deconvolution and transition state theory. Four zones of thermal decomposition were identified: Dehydration, polymeric matrix decomposition, carbonate decomposition and spinel formation, and spinel decomposition. Kinetic and thermodynamic analysis focused on the second zone. First-order Avrami-Erofeev equation was selected as reaction model representing the polymer matrix thermal decomposition. Kinetic and thermodynamic parameters revealed that Mg doping causes an increase in thermal inertia on conversion rate, and CO₂ desorption was the limiting step for formation of thermodynamically stable spinel phases. Based on thermogravimetry experiments and the effect of Mg on thermal decomposition, an optimal two-stage heat treatment was determined for preparation of LiMg_xMn_2−xO₄ (x = 0.00, 0.02, 0.05, 0.10) nanocrystalline powders as promising cathode materials for lithium-ion batteries. Crystalline structure, morphology, and stoichiometry of synthesized powders were characterized by XRD, FE-SEM, and AAS, respectively.

Formation of Ordered Honeycomb-like Structures of Manganese Oxide 2D Nanocrystals with the Birnessite-like Structure and Their Electrocatalytic Properties during Oxygen Evolution Reaction upon Water Splitting in an Alkaline Medium

In this work, a chemical reaction between gaseous ozone and aqueous solution of Mn(CH₃COO)₂ in drops has been researched. It has been shown that the formation of H _x MnO₂·nH₂O nanocrystals with a morphology of nanosheets and a birnessite-like crystal structure with a thickness of 5-8 nm is observed on the surface of drops. These nanocrystals are oriented spontaneously to the solution-gas interface and constitute peculiar ribbons with a width of 1-2 μm, some of which form ordered honeycomb structures (OHS) with a 5-20 μm cell size. To explain the observed effect, the scheme of chemical reactions that take place at the interface between the surface of a drop and ozone has been modeled, and it can be described using a diffusion pattern model taking into account the action of "force fields" on the surface of a drop, which arise due to its curvature. After the drop is dried, these structures practically retain their morphology and form a fractal structure with a geometric area equal to the area of the drop base on the surface of the substrate. The study of the electrocatalytic properties of these structures revealed that they are active electrocatalysts in the oxygen evolution reaction (OER) during water electrolysis in alkaline medium. The most efficient of the obtained electrocatalysts are characterized by an overpotential value of 284 mV at a current of 10 mA/cm² and the Tafel coefficient of 37.7 mV/dec and are currently one of the best among pure manganese oxides. Finally, it has also been assumed that this effect is explained by the morphological features of the structures obtained, which contribute to the removal of oxygen bubbles from the electrode surface during electrolysis.