Solubility determination and thermodynamic data of apigenin in binary {Transcutol® + water} mixtures

Solubility of Cinnarizine in (Transcutol + Water) Mixtures: Determination, Hansen Solubility Parameters, Correlation, and Thermodynamics

Between 293.2 and 313.2 K and at 0.1 MPa, the solubility of the weak base, cinnarizine (CNZ) (3), in various {Transcutol-P (TP) (1) + water (2)} combinations is reported. The Hansen solubility parameters (HSP) of CNZ and various {(TP) (1) + water (2)} mixtures free of CNZ were also predicted using HSPiP software. Five distinct cosolvency-based mathematical models were used to link the experimentally determined solubility data of CNZ. The solubility of CNZ in mole fraction was increased with elevated temperature and TP mass fraction in {(TP) (1) + water (2)} combinations. The maximum solubility of CNZ in mole fraction was achieved in neat TP (5.83 × 10^-2 at 313.2 K) followed by the minimum in neat water (3.91 × 10^-8 at 293.2 K). The values of mean percent deviation (MPD) were estimated as 2.27%, 5.15%, 27.76%, 1.24% and 1.52% for the "Apelblat, van't Hoff, Yalkowsky-Roseman, Jouyban-Acree, and Jouyban-Acree-van't Hoff models", respectively, indicating good correlations. The HSP value of CNZ was closed with that of neat TP, suggesting the maximum solubilization of CNZ in TP compared with neat water and other aqueous mixtures of TP and water. The outcomes of the apparent thermodynamic analysis revealed that CNZ dissolution was endothermic and entropy-driven in all of the {(TP) (1) + water (2)} systems investigated. For {(TP) (1) + water (2)} mixtures, the enthalpy-driven mechanism was determined to be the driven mechanism for CNZ solvation. TP has great potential for solubilizing the weak base, CNZ, in water, as demonstrated by these results.

Solubility Determination of c-Met Inhibitor in Solvent Mixtures and Mathematical Modeling to Develop Nanosuspension Formulation

The solubility and dissolution thermodynamics of new c-Met inhibitor, ABN401, were determined in eleven solvents and Transcutol^® HP-water mixture (TWM) from 298.15 to 318.15 K. The experimental solubilities were validated using five mathematical models, namely modified Apelblat, van't Hoff, Buchowski-Ksiazaczak λh, Yalkowsky, and Jouyban-Acree van't Hoff models. The experimental results were correlated and utilized further to investigate the feasibility of nanosuspension formation using liquid anti-solvent precipitation. Thermodynamic solubility of ABN401 increased significantly with the increase in temperature and maximum solubility was obtained with Transcutol^® HP while low solubility in was obtained water. An activity coefficient study indicated that high molecular interaction was observed in ABN401-Transcutol^® HP (THP). The solubility increased proportionately as the mole fraction of Transcutol^® HP increased in TWM, which was also supported by a solvent effect study. The result suggested endothermic and entropy-driven dissolution. Based on the solubility, nanosuspension was designed with Transcutol^® HP as solvent, and water as anti-solvent. The mean particle size of nanosuspension decreased to 43.05 nm when the mole fraction of ABN401 in THP, and mole fraction of ABN401 in TWM mixture were decreased to 0.04 and 0.1. The ultrasonicated nanosuspension appeared to give comparatively higher dissolution than micronized nanosuspension and provide a candidate formulation for in vivo purposes.

Solubilization, Hansen Solubility Parameters, Solution Thermodynamics and Solvation Behavior of Flufenamic Acid in (Carbitol + Water) Mixtures

The solubilization, solution thermodynamics, solvation behavior and Hansen solubility parameters (HSPs) of an anti-inflammatory medicine flufenamic acid (FFA) in various Carbitol + water mixtures were evaluated in this study. The experimental solubility of FFA in mole fraction (xe) was measured at T = 298.2–318.2 K and p = 0.1 MPa using a static equilibrium method. The xe values of FFA in various Carbitol + water mixtures were correlated with van’t Hoff, Apelblat, Yalkowsky–Roseman, Jouyban–Acree and Jouyban–Acree–van’t Hoff models. All the studied models showed good correlation with mean error values of less than 2%. The xe value of FFA was found to increase significantly with the increase in temperature and Carbitol mass fraction in all Carbitol + water mixtures evaluated. The maximum and minimum xe values of FFA were recorded in pure Carbitol (2.81 × 10−1) at T = 318.2 K and pure water (5.80 × 10−7) at T = 298.2 K, respectively. Moreover, the HSP of FFA was found to be more closed with that of pure Carbitol, indicating the maximum solubility of FFA in pure Carbitol. The estimated values of activity coefficients showed higher molecular interactions in FFA–Carbitol combinations compared with FFA–water combinations. Thermodynamic studies indicated an endothermic and entropy-driven dissolution of FFA in all Carbitol + water mixtures. The solvation behavior of FFA was observed as enthalpy driven in all Carbitol + water combinations evaluated.

Solubility Data of the Bioactive Compound Piperine in (Transcutol + Water) Mixtures: Computational Modeling, Hansen Solubility Parameters and Mixing Thermodynamic Parameters

The solubility values and thermodynamic parameters of a natural phytomedicine/nutrient piperine (PPN) in Transcutol-HP (THP) + water combinations were determined. The mole fraction solubilities (xe) of PPN in THP + water combinations were recorded at T = 298.2-318.2 K and p = 0.1 MPa by the shake flask method. Hansen solubility parameters (HSPs) of PPN, pure THP, pure water and THP + water mixtures free of PPN were also computed. The xe values of PPN were correlated well with "Apelblat, Van't Hoff, Yalkowsky-Roseman, Jouyban-Acree and Jouyban-Acree-Van't Hoff" models with root mean square deviations of < 2.0%. The maximum and minimum xe value of PPN was found in pure THP (9.10 × 10-2 at T = 318.2 K) and pure water (1.03 × 10-5 at T = 298.2 K), respectively. In addition, HSP of PPN was observed more closed with that of pure THP. The thermodynamic parameters of PPN were obtained using the activity coefficient model. The results showed an endothermic dissolution of PPN at m = 0.6-1.0 in comparison to other THP + water combinations studied. In addition, PPN dissolution was recorded as entropy-driven at m = 0.8-1.0 compared with other THP + water mixtures evaluated.

Solubility Data and Computational Modeling of Baricitinib in Various (DMSO + Water) Mixtures

The solubility and thermodynamic analysis of baricitinib (BNB) in various dimethyl sulfoxide (DMSO) + water mixtures were performed. The “mole fraction solubilities (x_e)” of BNB in DMSO and water mixtures were determined at “T = 298.2–323.2 K” and “p = 0.1 MPa” using an isothermal saturation technique. “Hansen solubility parameters (HSPs)” of BNB, pure DMSO, pure water and “DMSO + water” mixtures free of BNB were also estimated. The x_e data of BNB was regressed well by five different thermodynamics-based co-solvency models, which included “Apelblat, Van’t Hoff, Yalkowsky-Roseman, Jouyban-Acree and Jouyban-Acree-Van’t Hoff models” with overall deviations of <5.0%. The highest and lowest x_e value of BNB was computed in pure DMSO (1.69 × 10⁻¹ at T = 323.2 K) and pure water (2.23 × 10⁻⁵ at T = 298.2 K), respectively. The HSP of BNB was found to be closer to that of pure DMSO. Based on activity coefficient data, maximum solute–solvent molecular interactions were observed in BNB-DMSO compared to BNB-water. The results of “apparent thermodynamic analysis” indicated endothermic and entropy-drive dissolution of BNB in all “DMSO + water” combinations including mono-solvents (water and DMSO). “Enthalpy-entropy compensation analysis” showed enthalpy-driven to be the main mechanism of solvation of BNB.

Solubility, Hansen Solubility Parameters and Thermodynamic Behavior of Emtricitabine in Various (Polyethylene Glycol-400 + Water) Mixtures: Computational Modeling and Thermodynamics

This study was aimed to find out the solubility, thermodynamic behavior, Hansen solubility parameters and molecular interactions of an antiviral drug emtricitabine (ECT) in various “[polyethylene glycol-400 (PEG-400) + water]” mixtures. The solubility of ECT in mole fraction was determined at “T = 298.2 to 318.2 K” and “p = 0.1 MPa” using an isothermal method. The experimental solubilities of ECT in mole fraction were validated and correlated using various computational models which includes “Van’t Hoff, Apelblat, Yalkowsky-Roseman, Jouyban-Acree and Jouyban-Acree-Van’t Hoff models”. All the models performed well in terms of model correlation. The solubility of ECT was increased with the raise in temperature in all “PEG-400 + water” mixtures studied. The highest and lowest solubility values of ECT were found in pure PEG-400 (1.45 × 10⁻¹) at “T = 318.2 K” and pure water (7.95 × 10⁻³) at “T = 298.2 K”, respectively. The quantitative values of activity coefficients indicated higher interactions at molecular level in ECT and PEG-400 combination compared with ECT and water combination. “Apparent thermodynamic analysis” showed an “endothermic and entropy-driven dissolution” of ECT in all “PEG-400 + water” combinations studied. The solvation nature of ECT was found an “enthalpy-driven” in each “PEG-400 + water” mixture studied.

Efficacy of metabolites of a Streptomyces strain (AS1) to control growth and mycotoxin production by Penicillium verrucosum, Fusarium verticillioides and Aspergillus fumigatus in culture

The objectives of this study were to determine the efficacy of metabolites of a Streptomyces strain AS1 on (a) spore germination, (b) mycelial growth, (c) control of mycotoxins produced by Penicillium verrucosum (ochratoxin A, OTA), Fusarium verticillioides (fumonisins, FUMs) and Aspergillus fumigatus (gliotoxin) and (d) identify the predominant metabolites involved in control. Initial screening showed that the Streptomyces AS1 strain was able to inhibit the mycelial growth of the three species at a distance, due to the release of secondary metabolites. A macroscopic screening system showed that the overall Index of Dominance against all three toxigenic fungi was inhibition at a distance. Subsequent studies showed that the metabolite mixture from the Streptomyces AS1 strain was very effective at inhibiting conidial germination of P. verrucosum, but less so against conidia of A. fumigatus and F. verticillioides. The efficacy was confirmed in studies on a conducive semi-solid YES medium in BioScreen C assays. Using the BioScreen C and the criteria of Time to Detection (TTD) at an OD = 0.1 showed good efficacy against P. verrucosum when treated with the Streptomyces AS1 extract at 0.95 and 0.99 water activity (a_w) when compared to the other two species tested, indicating good efficacy. The effective dose for 50% control of growth (ED₅₀) at 0.95 and 0.99 a_w were approx. 0.005 ng/ml and 0.15 μg/ml, respectively, with the minimum inhibitory concentration (MIC) at both a_w levels requiring > 40 μg/ml. In addition, OTA production was completely inhibited by 2.5 μg/ml AS1 extract at both a_w levels in the in vitro assays. Ten metabolites were identified with four of these being predominant in concentrations > 2 μg/g dry weight biomass. These were identified as valinomycin, cyclo(L-Pro-L-Tyr), cyclo(L-Pro-L-Val) and brevianamide F.

Dissolution and bioavailability improvement of bioactive apigenin using solid dispersions prepared by different techniques

Apigenin (APG) is a poorly soluble bioactive compound/nutraceutical which shows poor bioavailability upon oral administration. Hence, the objective of this research work was to develop APG solid dispersions (SDs) using different techniques with the expectation to obtain improvement in its in vitro dissolution rate and in vivo bioavailability upon oral administration. Different SDs of APG were prepared by microwave, melted and kneaded technology using pluronic-F127 (PL) as a carrier. Prepared SDs were characterized using "thermogravimetric analysis (TGA), differential scanning calorimetry (DSC), Fourier transform infra-red (FTIR) spectrometer, powder X-ray diffraction (PXRD) and scanning electron microscopy (SEM)". After characterization, prepared SDs of APG were studied for in vitro drug release/dissolution profile and in vivo pharmacokinetic studies. The results of TGA, DSC, FTIR, PXRD and SEM indicated successful formation of APG SDs. In vitro dissolution experiments suggested significant release of APG from all SDs (67.39-84.13%) in comparison with control (32.74%). Optimized SD of APG from each technology was subjected to in vivo pharmacokinetic study in rats. The results indicated significant improvement in oral absorption of APG from SD prepared using microwave and melted technology in comparison with pure drug and commercial capsule. The enhancement in oral bioavailability of APG from microwave SD (319.19%) was 3.19 fold as compared with marketed capsule (100.00%). Significant enhancement in the dissolution rate and oral absorption of APG from SD suggested that developed SD systems can be successfully used for oral drug delivery system of APG.