Effectiveness of tissue engineered based platelet gel embedded chitosan scaffold on experimentally induced critical sized segmental bone defect model in rat

The Impact of Nano-Crystal Hydroxyapatites on the Regeneration of Bone Defects

Calcium hydroxyapatite is a widely used material for replacing bone defects. However, the effectiveness of nano-crystalline calcium hydroxyapatite produced from eggshells in the replacement of bone defects has not been investigated yet. The study aimed to evaluate the effectiveness of using nano-crystalline calcium hydroxyapatite made from eggshell for the healing of bone defect of the femur in rats. Forty-eight (n=48) rats underwent a surgical procedure to simulate femoral defect. The animals were sub-divided into 4 groups (each with n=12) depending on the methods of bone defect replacement: I control group (CG) (without bone defect replacement); II intervention group (the bone defect was replaced by PRP (PRP); III intervention group (the bone defect was replaced by nano-crystalline hydroxyapatite obtained from eggshell) (HA) and IV interventional group (the bone defect was replaced by a combination of hydroxyapatite and PRP) (HA+PRP). The degree of effectiveness of studied methods was assessed using radiological (on the 14th day), histological (on the 61st day), and biomechanical analysis (on the 61st day). According to radiographic data, the CG group had the lowest level of bone regeneration after 14 days (4.2 ±1.7%). In the HA + PRP group, the level of bone regeneration was 22.1±7.1 %, which was higher in comparison with the rates of consolidation of bone defects in the HA group (20.7± 9.3) (p = 0.023). According to the histo-morphometry data, the rates of bone tissue regeneration in the PRP group (19.8 ±4.2%) were higher in comparison with the CG group (12.7 ± 7.3%), (p>0.05). In the HA+PRP group, bone regeneration rates (48.9±9.4 %) were significantly higher (p=0.001) than in the HA group (35.1±9.8%). According to the results of biomechanical assessment under the maximum stress (121.0722), the maximum bending deformation of the contralateral bone without defect was 0.028746, which was higher than the indicators of the HA+PRP group, where at the maximum stress (90.67979) the bending deformation was 0.024953 (p>0.05). Compared to CG, PRP, and HA, biomechanical bone strength was significantly higher in the HA + PRP group (p≤0.01). At the maximum stress (51.81391), the maximum bending strain in the CG group was 0.03869, which was lower than in the PRP group, where the maximum stress and bending strain were 59.45824 and 0.055171, respectively (p>0.05). However, the bone strength of the HA group was statistically significantly higher compared to the CG and PRP groups (p<0.01).

The results demonstrated the effectiveness of the use of nanocrystalline calcium hydroxyapatite obtained from eggshell in the healing of a bone defect. The best results were observed in the group of the combined use of nano-crystalline calcium hydroxyapatite and PRP.

Effects of Combination of BMP7, PFG, and Autograft on Healing of the Experimental Critical Radial Bone Defect by Induced Membrane (Masquelet) Technique in Rabbit

Background

Healing of large segmental bone defects can be challenging for orthopedic surgeons. This research was conducted to provide further insight into the effects of BMP7 in combination with autograft and platelet fibrin glue (PFG) on bone regeneration by Masquelet technique (MT).

Methods

Twenty five domestic male rabbits, more than 6 months old, weighing 2.00±0.25 kg were randomly divided into five equal groups as follows: MT-blank cavity (without any biological or synthetic materials) (1), blank cavity (2), MT-autograft (3), MT-autograft-BMP7 (4), and MT-BMP7-PFG (5). A 20 mm segmental defect was made in radial bone in both forelimbs. The Masquelet technique was done in all groups except group 2. The study was evaluated by radiology, biomechanics, histopathology and scanning electron microscopy.

Results

The results showed that Masquelet technique enhanced the healing process, as, the structural and functional criteria of the injured bone showed significantly improved bone healing (P<0.05). Treatment by PFG-BMP7, Autograft-BMP7, and autograft demonstrated beneficial effects on bone healing. However, Autograft-BMP7 was more effective than autograft in healing of the radial defect in rabbits.

Conclusion

Our findings introduce the osteogenic materials in combination with Masquelet technique as an alternative for reconstruction of the big diaphyseal defects in the long bones in animal models. Our findings may be useful for clinical application in future.

Current applications of platelet gels in wound healing-A review

Human platelets play important roles in several physiologic and pathologic processes. Platelet concentrates are activated with thrombin or calcium, resulting in a viscous coagulum (platelet gel [PG]), composed of 95% platelets at least. PG is increasingly used for the treatment of a variety of soft and hard tissue defects, most notably in the management of chronic non-healing wounds. During wound healing, platelets not only play a critical role in primary hemostasis and thrombosis, but also release growth factors and cytokines to promote tissue regeneration, enhance collagen synthesis, and trigger an immune response. This review addresses a variety of aspects relevant to the functions of well-known platelet growth factors, animal and clinical studies of PG in the last decade, and different sources of platelets for PG. PG is used for non-healing chronic wounds, such as oral ulcerations related to epidermolysis bullosa and chronic graft-versus-host disease, for those, the traditional treatment effect is poor. PG maybe provide a new therapeutic direction for these diseases. Nevertheless, some uncertainty is present, the number of clinical studies is not enough. Hence, randomized controlled trials are still required to study the potential of the use of PG in the near future.

Effectiveness of a biodegradable 3D polylactic acid/poly(ɛ-caprolactone)/hydroxyapatite scaffold loaded by differentiated osteogenic cells in a critical-sized radius bone defect in rat

The effects of a scaffold made of polylactic acid, poly (ɛ-caprolactone) and hydroxyapatite by indirect 3D printing method with and without differentiated bone cells was tested on the regeneration of a critical radial bone defect in rat. The scaffold characterization and mechanical performance were determined by the rheology, scanning electron microscopy, energy-dispersive X-ray spectroscopy, X-ray diffraction, and Fourier transform infrared spectrometry. The defects were created in forty Wistar rats which were randomly divided into the untreated, autograft, scaffold cell-free, and differentiated bone cell-seeded scaffold groups (n = 10 in each group). The expression level of angiogenic and osteogenic markers, analyzed by quantitative real time-polymerase chain reaction (in vitro), significantly improved (p < 0.05) in the scaffold group compared to the untreated one. Radiology and computed tomography scan demonstrated a significant improvement in the cell-seeded scaffold group compared to the untreated one (p < 0.001). Biomechanical, histopathological, histomorphometric, and immunohistochemical investigations showed significantly better regeneration scores in the cell-seeded scaffold and autograft groups compared to the untreated group (p < 0.05). The cell-seeded scaffold and autograft groups did show comparable results on the 80^th day post-treatment (p > 0.05), however, most results in the scaffold group were significantly higher than the untreated group (p < 0.05). Differentiated bone cells can enhance bone regeneration potential of the scaffold.

Development of chitosan/gelatin hydrogels incorporation of biphasic calcium phosphate nanoparticles for bone tissue engineering

The chitosan/gelatin hydrogel incorporated with biphasic calcium phosphate nanoparticles (BCP-NPs) as scaffold (CGB) for bone tissue engineering was reported in this article. Such nanocomposite hydrogels were fabricated by using cycled freeze-thawing method, of which physicochemical and biological properties were regulated by adjusting the weight ratio of chitosan/gelatin/BCP-NPs. The needle-like BCP-NPs were dispersed into composites uniformly, and physically cross-linked with chitosan and gelatin, which were identified via Scanning Electron Microscope (SEM) images and Fourier Transform Infrared Spectroscopy (FT-IR) analysis. The porosity, equilibrium swelling ratio, and compressive strength of CGB scaffolds were mainly influenced by the BCP-NPs concentration. In vitro degradation analysis in simulated body fluids (SBF) displayed that CGB scaffolds were degraded up to at least 30 wt% in one month. Also, CCK-8 analysis confirmed that the prepared scaffolds had a good cytocompatibility through in culturing with bone marrow mesenchymal stem cells (BMSCs). Finally, In vivo animal experiments revealed that new bone tissue was observed inside the scaffolds, and gradually increased with increasing months, when implanted CGB scaffolds into large necrotic lesions of rabbit femoral head. The above results suggested that prepared CGB nanocomposites had the potential to be applied in bone tissue engineering.

Comparison Study of Bone Defect Healing Effect of Raw and Processed Pyritum in Rats

To evaluate and compare the effect of raw and processed pyritum on tibial defect healing, 32 male Sprague Dawley rats were randomly divided into four groups. After tibial defect, animals were produced and grouped: sham and control group were orally administrated with distilled water (1 mL/100 g), while treatment groups were given aqueous extracts of raw and processed pyritum (1.5 g/kg) for successive 42 days. Radiographic examination showed that bone defect healing effect of the treatment groups was obviously superior compared to that of the control group. Bone mineral density of whole tibia was increased significantly after treating with pyritum. Inductively coupled plasma-optical emission spectrometry showed that the contents of Ca, P, and Mg in callus significantly increased in the treatment groups comparing with the control. Moreover, serological analysis showed that the concentration of serum phosphorus of the treatment groups significantly increased compared with that of the control group. By in vitro study, we have evaluated the effects of drug-containing serum of raw and processed pyritum on osteoblasts. It was manifested that both the drug-containing sera of raw and processed pyritum significantly increased the mRNA levels of alkaline phosphatase and collagen type I. Protein levels of phosphorylated Smad2/3 also increased. The mRNA levels of osteocalcin and transforming growth factor β (TGF-β) type I and II receptors, as well as the protein levels of TGF-β1 in the processed groups, were higher than those in the control. In summary, both raw and processed pyritum-containing sera exhibited positive effects on osteoblasts, which maybe via the TGF-β1/Smad signaling pathway. Notably, the tibia defect healing effect of pyritum was significantly enhanced after processing.

Journey into Bone Models: A Review

Bone is a complex tissue with a variety of functions, such as providing mechanical stability for locomotion, protection of the inner organs, mineral homeostasis and haematopoiesis. To fulfil these diverse roles in the human body, bone consists of a multitude of different cells and an extracellular matrix that is mechanically stable, yet flexible at the same time. Unlike most tissues, bone is under constant renewal facilitated by a coordinated interaction of bone-forming and bone-resorbing cells. It is thus challenging to recreate bone in its complexity in vitro and most current models rather focus on certain aspects of bone biology that are of relevance for the research question addressed. In addition, animal models are still regarded as the gold-standard in the context of bone biology and pathology, especially for the development of novel treatment strategies. However, species-specific differences impede the translation of findings from animal models to humans. The current review summarizes and discusses the latest developments in bone tissue engineering and organoid culture including suitable cell sources, extracellular matrices and microfluidic bioreactor systems. With available technology in mind, a best possible bone model will be hypothesized. Furthermore, the future need and application of such a complex model will be discussed.

Reconstruction of radial bone defect in rat by calcium silicate biomaterials

AIMS

Despite many attempts, an appropriate therapeutic method has not yet been found to enhance bone formation, mechanical strength and structural and functional performances of large bone defects. In the present study, the bone regenerative potential of calcium silicate (CS) biomaterials combined with chitosan (CH) as calcium silicate/chitosan (CSC) scaffold was investigated in a critical radial bone defect in a rat model.

MAIN METHODS

The bioimplants were bilaterally implanted in the defects of 20 adult Sprague-Dawley rats. The rats were euthanized and the bone specimens were harvested at the 56th postoperative day. The healed radial bones were evaluated by three-dimensional CT, radiology, histomorphometric analysis, biomechanics, and scanning electron microscopy.

KEY FINDINGS

The XRD analysis of the CS biomaterial showed its similarity to wollastonite (β-SiCO₃). The degradation rate of the CSC scaffold was much higher and it induced milder inflammatory reaction when compared to the CH alone. More bone formation and higher biomechanical performance were observed in the CSC treated group in comparison with the CH treated ones in histological, CT scan and biomechanical examinations. Scanning electron microscopic observation demonstrated the formation of more hydroxyapatite crystals in the defects treated with CSC.

SIGNIFICANCE

This study showed that the CSC biomaterials could be used as proper biodegradable materials in the field of bone reconstruction and tissue engineering.