Time-resolved photodissociation study of singly protonated peptides with a histidine residue generated by matrix-assisted laser desorption ionization: dissociation rate constant and internal temperature

Formation of gas-phase peptide ions and their dissociation in MALDI: insights from kinetic and ion yield studies

Insights on mechanisms for the generation of gas-phase peptide ions and their dissociation in matrix-assisted laser desorption ionization (MALDI) gained from the kinetic and ion yield studies are presented. Even though the time-resolved photodissociation technique was initially used to determine the dissociation kinetics of peptide ions and their effective temperature, it was replaced by a simpler method utilizing dissociation yields from in-source decay (ISD) and post-source decay (PSD). The ion yields for a matrix and a peptide were measured by repeatedly irradiating a region on a sample and collecting ion signals until the sample in the region was completely depleted. Matrix- and peptide-derived gas-phase cations were found to be generated by pre-formed ion emission or by ion-pair emission followed by anion loss, but not by laser-induced ionization. The total number of ions, that is, matrix plus peptide, was found to be equal to the number of ions emitted from a pure matrix. A matrix plume was found to cool as it expanded, from around 800-1,000 K to 400-500 K. Dissociation of peptide ions along b/y channels was found to occur statistically, that is, following RRKM behavior. Small critical energy (E0  = 0.6-0.7 eV) and highly negative critical entropy (ΔS(‡)  = -30 to -25 eu) suggested that the transition structure was stabilized by multiple intramolecular interactions.

A Thermal Mechanism of Ion Formation in MALDI

An important recent discovery concerning the fundamentals of matrix-assisted laser desorption/ionization (MALDI) is that the abundance of each ion appearing in a spectrum is fixed, regardless of the experimental condition, when an effective temperature associated with the spectrum is fixed. We describe this phenomenon and the thermal picture for the ion formation in MALDI derived from it. Accepting that matrix-to-analyte proton transfer is in quasi-equilibrium as supported by experimental data, the above thermal determination occurs because the primary (matrix) ion formation processes are thermally governed. We propose that the abundances of the primary ions are limited by the autoprotolysis-recombination process regardless of how they are initially produced. Finally, we note that primary ion formation, secondary (analyte) ion formation, and their dissociations occur sequentially while the effective temperature of the matrix plume falls steadily due to cooling associated with expansion.

Expansion cooling in the matrix plume is under-recognized in MALDI mass spectrometry

Time-of-flight (TOF) mass spectra for a peptide (Y(6)) were obtained by utilizing matrix-assisted infrared laser desorption ionization (IR-MALDI) with glycerol as the matrix and by ultraviolet MALDI with α-cyano-4-hydroxycinnamic acid (CHCA), sinapinic acid (SA), and 2,5-dihydroxybenzoic acid (DHB). Collisional activation during ion extraction and exothermicity in the gas-phase proton transfer were found to be unimportant as the driving forces for in-source (ISD) and post-source (PSD) decays, indicating that the thermal energy acquired during photo-ablation is responsible for their occurrence. The temperatures of [Y(6) + H](+) in the 'early' and 'late' matrix plumes were estimated by the kinetic analysis of the ISD and PSD yields, respectively. The order of the temperatures was glycerol < DHB ≈ SA < CHCA in the early plume and glycerol < DHB < SA < CHCA in the late plume. For each matrix, the temperature in the late plume was lower than in the early plume by 300-400 K, which was attributed to expansion cooling. The model (thermalization followed by expansion cooling) proposed to explain the occurrence of both rapid ISD and slow PSD is not only in sharp contrast with but also mutually exclusive with the prevailing explanation that the exothermicity in proton transfer and in-plume collisional activation are the driving forces for ion fragmentation in MALDI. The model also explains why MALDI is more successful for mass spectrometry of labile molecules than other desorption techniques that do not utilize a matrix. Factors affecting the plume temperature are also discussed.

Changes in dissociation efficiency and kinetics of peptide ions induced by basic residues and their mechanistic implication

With matrix-assisted laser desorption ionization (MALDI) time-of-flight (TOF) mass spectrometry, total abundance of product ions formed by dissociation inside (in-source decay, ISD) and outside (post-source decay, PSD) the source was measured for peptide ions [Y(5)X + H](+), [XY(5) + H](+), [Y 2)XY(3) + H](+), and [XY(4)X + H](+) (X = tyrosine (Y), histidine (H), lysine (K), and arginine (R) with H for the ionizing proton). α-Cyano-4-hydroxycinammic acid was used as matrix. Product abundance became smaller in the presence of basic residues (H, K, and R), in the order Y > H ≈ K > R. In particular, product abundances in ISD of peptide ions with R were smaller than those with H or K by an order of magnitude, which, in turn, were smaller than that for [Y(6) + H](+) by an order of magnitude. Product abundance was affected by the most basic residue when more than one basic residue was present. A kinetic explanation for the data was attempted under the assumption of quasi-thermal equilibrium for peptide ions in MALDI plume which undergoes expansion cooling. Dramatic disparity in product abundance was found to arise from small difference in critical energy and entropy. Results indicate similar transition structures regardless of basic residues present, where the ionizing proton keeps interacting with a basic site. Further implication of the results on the dissociation mechanism along b-y channels is discussed.

A comparative study of in- and post-source decays of peptide and preformed ions in matrix-assisted laser desorption ionization time-of-flight mass spectrometry: effective temperature and matrix effect

In-source decay (ISD) and post-source decay (PSD) of a peptide ion ([Y(6) + H](+)) and a preformed ion (benzyltriphenylphosphonium, BTPP) generated by matrix-assisted laser desorption ionization (MALDI) were investigated with time-of-flight mass spectrometry. α-Cyano-4-hydroxycinammic acid (CHCA) and 2,5-dihydroxybenzoic acid (DHB) were used as matrices. For both ions, ISD yield was unaffected by delay time, indicating rapid termination of ISD. This was taken as evidence for rapid expansion cooling of hot "early" plume formed in MALDI. CHCA was hotter than DHB for [Y(6) + H](+) while the matrix effect was insignificant for BTPP. The "early" plume temperature estimated utilizing previous kinetic results was 800-900 K, versus 400-500 K for "late" plume. The results support our previous finding that the temperature of peptide ions interrogated by tandem mass spectrometry was lower than most rough estimates of MALDI temperature.

Dissociation mechanisms and implication for the presence of multiple conformations for peptide ions with arginine at the C-terminus: time-resolved photodissociation study

Time-resolved photodissociation (PD) patterns of singly protonated peptides with arginine at the C-terminus (C-arg peptide ions) have been used to classify the dissociation channels into two categories, i.e. high-energy channels generating v, w and x and low-energy ones generating b, y and z. x + 1 formed by C(alpha)-CO cleavage seems to be the intermediate ion in high-energy channels just as a + 1 is for N-arg peptide ions. Difference in time-resolved pattern indicates that the two sets of channels, high- and low-energy ones, are not in direct competition. Noncompetitive dissociation is also indicated by the observation of anomalous effect of matrix used in matrix-assisted laser desorption ionization, a cooler matrix generating more high-energy product ions both in spontaneous dissociation and in PD. Results from detailed investigation suggest that the two sets of channels start from two (or more) different conformations.

Dissociation kinetics of singly protonated leucine enkephalin investigated by time-resolved photodissociation tandem mass spectrometry

The yields of post-source decay (PSD) and time-resolved photodissociation (PD) at 193 and 266 nm were measured for singly protonated leucine enkephalin ([YGGFL + H](+)), a benchmark in the study of peptide ion dissociation, by using tandem time-of-flight mass spectrometry. The peptide ion was generated by matrix-assisted laser desorption ionization (MALDI) using 2,5-dihydroxybenzoic acid as the matrix. The critical energy (E(0)) and entropy (DeltaS(++) at 1000 K) for the dissociation were determined by Rice-Ramsperger-Kassel-Marcus fit of the experimental data. MALDI was done for a mixture of YGGFL and Y(6) and the plume temperature determined by the kinetic analysis of [Y(6) + H](+) data were used to improve the precision of E(0) and DeltaS(++) for [YGGFL + H](+). E(0) and DeltaS(++) thus determined (E(0) = 0.67 +/- 0.08 eV, DeltaS(++) = -24.4 +/- 3.2 eu with 1 eu = 4.184 J K(-1)mol(-1)) were significantly different from those determined by blackbody infrared radiative dissociation (BIRD) (E(0) = 1.10 eV, DeltaS(++) = -14.9 eu), and by surface-induced dissociation (SID) (E(0) = 1.13 eV, DeltaS(double dagger) = -10.3 eu). Analysis of the present experimental data with the SID kinetics (and BIRD kinetics also) led to an unrealistic situation where not only PSD and PD but also MALDI-TOF signals could not be detected. As an explanation for the discrepancy, it was suggested that transition-state switching occurs from an energy bottleneck (SID/BIRD) to an entropy bottleneck (PSD/PD) as the internal energy increases.

Influence of basic residues on dissociation kinetics and dynamics of singly protonated peptides: time-resolved photodissociation study

Product ion yields in postsource decay and time-resolved photodissociation at 193 and 266 nm were measured for some peptide ions with lysine ([KF6 + H]+, [F6K + H]+, and [F3KF3 + H]+) formed by matrix-assisted laser desorption ionization. The critical energy (E0) and entropy (DeltaS(double dagger)) were determined by RRKM fitting of the data. The results were similar to those found previously for peptide ions with histidine. To summarize, the presence of a basic residue, histidine or lysine, inside a peptide ion retarded its dissociation by lowering DeltaS(double dagger). On the basis of highly negative DeltaS(double dagger), presence of intramolecular interaction involving a basic group in the transition structure was proposed.